| CVE |
Vendors |
Products |
Updated |
CVSS v3.1 |
| A vulnerability in the mesh code of Cisco Wireless LAN Controller (WLC) software could allow an unauthenticated, remote attacker to impersonate a WLC in a meshed topology. The vulnerability is due to insufficient authentication of the parent access point in a mesh configuration. An attacker could exploit this vulnerability by forcing the target system to disconnect from the correct parent access point and reconnect to a rogue access point owned by the attacker. An exploit could allow the attacker to control the traffic flowing through the impacted access point or take full control of the target system. This vulnerability affects the following products running a vulnerable version of Wireless LAN Controller software and configured for meshed mode: Cisco 8500 Series Wireless Controller, Cisco 5500 Series Wireless Controller, Cisco 2500 Series Wireless Controller, Cisco Flex 7500 Series Wireless Controller, Cisco Virtual Wireless Controller, Wireless Services Module 2 (WiSM2). Note that additional configuration is needed in addition to upgrading to a fixed release. Cisco Bug IDs: CSCuc98992 CSCuu14804. |
| A vulnerability in the web user interface of Cisco IOS XE 3.1 through 3.17 could allow an unauthenticated, remote attacker to cause an affected device to reload. The vulnerability is due to insufficient resource handling by the affected software when the web user interface is under a high load. An attacker could exploit this vulnerability by sending a high number of requests to the web user interface of the affected software. A successful exploit could allow the attacker to cause the affected device to reload, resulting in a denial of service (DoS) condition. To exploit this vulnerability, the attacker must have access to the management interface of the affected software, which is typically connected to a restricted management network. This vulnerability affects Cisco devices that are running a vulnerable release of Cisco IOS XE Software, if the web user interface of the software is enabled. By default, the web user interface is not enabled. Cisco Bug IDs: CSCup70353. |
| A vulnerability in the Layer 2 Tunneling Protocol (L2TP) parsing function of Cisco IOS (12.0 through 12.4 and 15.0 through 15.6) and Cisco IOS XE (3.1 through 3.18) could allow an unauthenticated, remote attacker to cause an affected device to reload. The vulnerability is due to insufficient validation of L2TP packets. An attacker could exploit this vulnerability by sending a crafted L2TP packet to an affected device. A successful exploit could allow the attacker to cause the affected device to reload, resulting in a denial of service (DoS) condition. This vulnerability affects Cisco devices that are running a vulnerable release of Cisco IOS or Cisco IOS XE Software if the L2TP feature is enabled for the device and the device is configured as an L2TP Version 2 (L2TPv2) or L2TP Version 3 (L2TPv3) endpoint. By default, the L2TP feature is not enabled. Cisco Bug IDs: CSCuy82078. |
| A vulnerability in the web framework of Cisco IOS XE Software could allow an authenticated, remote attacker to inject arbitrary commands that are executed with root privileges. The vulnerability is due to insufficient input validation of HTTP parameters supplied by the user. An attacker could exploit this vulnerability by authenticating to the device and submitting crafted input to the affected web page parameter. The user must be authenticated to access the affected parameter. A successful exploit could allow the attacker to execute commands with root privileges. This vulnerability affects Cisco devices running Cisco IOS XE Software Release 16.2.1, if the HTTP Server feature is enabled for the device. The newly redesigned, web-based administration interface was introduced in the Denali 16.2 Release of Cisco IOS XE Software. The web-based administration interface in earlier releases of Cisco IOS XE Software is not affected by this vulnerability. Cisco Bug IDs: CSCuy83069. |
| Multiple vulnerabilities in the EnergyWise module of Cisco IOS (12.2 and 15.0 through 15.6) and Cisco IOS XE (3.2 through 3.18) could allow an unauthenticated, remote attacker to cause a buffer overflow condition or a reload of an affected device, leading to a denial of service (DoS) condition. These vulnerabilities are due to improper parsing of crafted EnergyWise packets destined to an affected device. An attacker could exploit these vulnerabilities by sending crafted EnergyWise packets to be processed by an affected device. An exploit could allow the attacker to cause a buffer overflow condition or a reload of the affected device, leading to a DoS condition. Cisco IOS Software and Cisco IOS XE Software support EnergyWise for IPv4 communication. Only IPv4 packets destined to a device configured as an EnergyWise domain member can trigger these vulnerabilities. IPv6 packets cannot be used to trigger these vulnerabilities. Cisco Bug ID CSCur29331. |
| Multiple vulnerabilities in the EnergyWise module of Cisco IOS (12.2 and 15.0 through 15.6) and Cisco IOS XE (3.2 through 3.18) could allow an unauthenticated, remote attacker to cause a buffer overflow condition or a reload of an affected device, leading to a denial of service (DoS) condition. These vulnerabilities are due to improper parsing of crafted EnergyWise packets destined to an affected device. An attacker could exploit these vulnerabilities by sending crafted EnergyWise packets to be processed by an affected device. An exploit could allow the attacker to cause a buffer overflow condition or a reload of the affected device, leading to a DoS condition. Cisco IOS Software and Cisco IOS XE Software support EnergyWise for IPv4 communication. Only IPv4 packets destined to a device configured as an EnergyWise domain member can trigger these vulnerabilities. IPv6 packets cannot be used to trigger these vulnerabilities. Cisco Bug ID CSCut47751. |
| Multiple vulnerabilities in the EnergyWise module of Cisco IOS (12.2 and 15.0 through 15.6) and Cisco IOS XE (3.2 through 3.18) could allow an unauthenticated, remote attacker to cause a buffer overflow condition or a reload of an affected device, leading to a denial of service (DoS) condition. These vulnerabilities are due to improper parsing of crafted EnergyWise packets destined to an affected device. An attacker could exploit these vulnerabilities by sending crafted EnergyWise packets to be processed by an affected device. An exploit could allow the attacker to cause a buffer overflow condition or a reload of the affected device, leading to a DoS condition. Cisco IOS Software and Cisco IOS XE Software support EnergyWise for IPv4 communication. Only IPv4 packets destined to a device configured as an EnergyWise domain member can trigger these vulnerabilities. IPv6 packets cannot be used to trigger these vulnerabilities. Cisco Bug ID CSCuu76493. |
| A vulnerability in the web framework code of Cisco Prime Service Catalog could allow an unauthenticated, remote attacker to conduct a cross-site scripting (XSS) attack against the user of the web interface of the affected system. More Information: CSCvc79842 CSCvc79846 CSCvc79855 CSCvc79873 CSCvc79882 CSCvc79891. Known Affected Releases: 11.1.2. |
| A vulnerability in the Border Gateway Protocol (BGP) Bidirectional Forwarding Detection (BFD) implementation of Cisco Adaptive Security Appliance (ASA) Software could allow an unauthenticated, remote attacker to bypass the access control list (ACL) for specific TCP and UDP traffic. More Information: CSCvc68229. Known Affected Releases: 9.6(2). Known Fixed Releases: 99.1(20.1) 99.1(10.2) 98.1(12.7) 98.1(1.49) 97.1(6.58) 97.1(0.134) 96.2(0.109) 9.7(1.1) 9.6(2.99) 9.6(2.8). |
| A vulnerability in the Plug-and-Play (PnP) subsystem of the Cisco Aironet 1800, 2800, and 3800 Series Access Points running a Lightweight Access Point (AP) or Mobility Express image could allow an unauthenticated, adjacent attacker to execute arbitrary code with root privileges. The vulnerability is due to insufficient validation of PnP server responses. The PnP feature is only active while the device does not contain a configuration, such as a first time boot or after a factory reset has been issued. An attacker with the ability to respond to PnP configuration requests from the affected device can exploit the vulnerability by returning malicious PnP responses. If a Cisco Application Policy Infrastructure Controller - Enterprise Module (APIC-EM) is available on the network, the attacker would need to exploit the issue in the short window before a valid PnP response was received. If successful, the attacker could gain the ability to execute arbitrary code with root privileges on the underlying operating system of the device. Cisco has confirmed that the only vulnerable software version is 8.3.102.0. Cisco Bug IDs: CSCvb42386. |
| A vulnerability in the web framework of Cisco Unified Communications Manager (CallManager) could allow an authenticated, remote attacker to perform a cross-site scripting (XSS) attack. More Information: CSCvb70033. Known Affected Releases: 11.5(1.11007.2). Known Fixed Releases: 12.0(0.98000.507) 11.0(1.23900.5) 11.0(1.23900.3) 10.5(2.15900.2). |
| The Comcast firmware on Cisco DPC3939 (firmware version dpc3939-P20-18-v303r20421733-160420a-CMCST); Cisco DPC3939 (firmware version dpc3939-P20-18-v303r20421746-170221a-CMCST); and Arris TG1682G (eMTA&DOCSIS version 10.0.132.SIP.PC20.CT, software version TG1682_2.2p7s2_PROD_sey) devices makes it easy for remote attackers to determine the hidden SSID and passphrase for a Home Security Wi-Fi network. |
| The Comcast firmware on Cisco DPC3939 (firmware version dpc3939-P20-18-v303r20421733-160420a-CMCST) and DPC3939 (firmware version dpc3939-P20-18-v303r20421746-170221a-CMCST) devices allows remote attackers to discover a CM MAC address by sniffing Wi-Fi traffic and performing simple arithmetic calculations. |
| The Comcast firmware on Cisco DPC3939B (firmware version dpc3939b-v303r204217-150321a-CMCST) devices allows configuration changes via CSRF. |
| A vulnerability in the web management interface of Cisco Wireless LAN Controller (WLC) Software could allow an unauthenticated, remote attacker to cause a denial of service (DoS) condition on an affected device. The vulnerability is due to a missing internal handler for the specific request. An attacker could exploit this vulnerability by accessing a specific hidden URL on the GUI web management interface. A successful exploit could allow the attacker to cause a reload of the device, resulting in a DoS condition. This vulnerability affects only the Cisco Wireless LAN Controller 8.3.102.0 release. Cisco Bug IDs: CSCvb48198. |
| A vulnerability in the web framework of Cisco Unified Communications Manager could allow an unauthenticated, remote attacker to conduct a cross-site scripting (XSS) attack against a user of the web interface of the affected software. More Information: CSCvb95951. Known Affected Releases: 12.0(0.99999.2). Known Fixed Releases: 11.0(1.23064.1) 11.5(1.12031.1) 11.5(1.12900.21) 11.5(1.12900.7) 11.5(1.12900.8) 11.6(1.10000.4) 12.0(0.98000.155) 12.0(0.98000.178) 12.0(0.98000.366) 12.0(0.98000.367) 12.0(0.98000.468) 12.0(0.98000.469) 12.0(0.98000.536) 12.0(0.98000.6) 12.0(0.98500.6). |
| A vulnerability in Cisco Aironet 1830 Series and Cisco Aironet 1850 Series Access Points running Cisco Mobility Express Software could allow an unauthenticated, remote attacker to take complete control of an affected device. The vulnerability is due to the existence of default credentials for an affected device that is running Cisco Mobility Express Software, regardless of whether the device is configured as a master, subordinate, or standalone access point. An attacker who has layer 3 connectivity to an affected device could use Secure Shell (SSH) to log in to the device with elevated privileges. A successful exploit could allow the attacker to take complete control of the device. This vulnerability affects Cisco Aironet 1830 Series and Cisco Aironet 1850 Series Access Points that are running an 8.2.x release of Cisco Mobility Express Software prior to Release 8.2.111.0, regardless of whether the device is configured as a master, subordinate, or standalone access point. Release 8.2 was the first release of Cisco Mobility Express Software for next generation Cisco Aironet Access Points. Cisco Bug IDs: CSCva50691. |
| An HTTP Packet Processing vulnerability in the Web Bridge interface of the Cisco Meeting Server (CMS), formerly Acano Conferencing Server, could allow an authenticated, remote attacker to retrieve memory contents, which could lead to the disclosure of confidential information. In addition, the attacker could potentially cause the application to crash unexpectedly, resulting in a denial of service (DoS) condition. The attacker would need to be authenticated and have a valid session with the Web Bridge. Affected Products: This vulnerability affects Cisco Meeting Server software releases prior to 2.1.2. This product was previously known as Acano Conferencing Server. More Information: CSCvc89551. Known Affected Releases: 2.0 2.0.7 2.1. Known Fixed Releases: 2.1.2. |
| A vulnerability in Cisco Secure Access Control System (ACS) could allow an unauthenticated, remote attacker to conduct a DOM-based cross-site scripting (XSS) attack against the user of the web interface of the affected system. More Information: CSCvc04838. Known Affected Releases: 5.8(2.5). |
| A vulnerability in the web interface of the Cisco Secure Access Control System (ACS) could allow an unauthenticated, remote attacker to disclose sensitive information. More Information: CSCvc04854. Known Affected Releases: 5.8(2.5). |
