| CVE |
Vendors |
Products |
Updated |
CVSS v3.1 |
| A vulnerability in the handling of RSA keys on devices running Cisco Adaptive Security Appliance (ASA) Software and Cisco Firepower Threat Defense (FTD) Software could allow an unauthenticated, remote attacker to retrieve an RSA private key. This vulnerability is due to a logic error when the RSA key is stored in memory on a hardware platform that performs hardware-based cryptography. An attacker could exploit this vulnerability by using a Lenstra side-channel attack against the targeted device. A successful exploit could allow the attacker to retrieve the RSA private key. The following conditions may be observed on an affected device: This vulnerability will apply to approximately 5 percent of the RSA keys on a device that is running a vulnerable release of Cisco ASA Software or Cisco FTD Software; not all RSA keys are expected to be affected due to mathematical calculations applied to the RSA key. The RSA key could be valid but have specific characteristics that make it vulnerable to the potential leak of the RSA private key. If an attacker obtains the RSA private key, they could use the key to impersonate a device that is running Cisco ASA Software or Cisco FTD Software or to decrypt the device traffic. See the Indicators of Compromise section for more information on the detection of this type of RSA key. The RSA key could be malformed and invalid. A malformed RSA key is not functional, and a TLS client connection to a device that is running Cisco ASA Software or Cisco FTD Software that uses the malformed RSA key will result in a TLS signature failure, which means a vulnerable software release created an invalid RSA signature that failed verification. If an attacker obtains the RSA private key, they could use the key to impersonate a device that is running Cisco ASA Software or Cisco FTD Software or to decrypt the device traffic. |
| A vulnerability in the data acquisition (DAQ) component of Cisco Firepower Threat Defense (FTD) Software could allow an unauthenticated, remote attacker to bypass configured access control policies or cause a denial of service (DoS) condition. The vulnerability exists because the affected software improperly manages system memory resources when inspecting traffic. An attacker could exploit this vulnerability by generating specific traffic patterns for the software to inspect. A successful exploit could allow the attacker to exhaust system memory resources used for traffic inspection. Depending on the configuration, the FTD Software could fail open and cease to inspect traffic or fail closed and result in a DoS condition. This vulnerability may require manual intervention to restore the software. |
| A vulnerability in the CLI of Cisco Firepower Threat Defense (FTD) Software could allow an authenticated, local attacker to perform a command injection attack. The vulnerability is due to insufficient input validation. An attacker could exploit this vulnerability by injecting commands into arguments for a specific command. A successful exploit could allow the attacker to execute commands with root privileges. |
| A vulnerability in the logging subsystem of the Cisco Firepower Threat Defense (FTD) Firepower Device Manager (FDM) could allow an unauthenticated, remote attacker to add arbitrary entries to the audit log. This vulnerability affects Cisco Firepower Threat Defense Software versions 6.1.x on the following vulnerable products that have enabled FDM: ASA5506-X ASA5506W-X ASA5506H-X ASA5508-X ASA5516-X ASA5512-X ASA5515-X ASA5525-X ASA5545-X ASA5555-X. More Information: CSCvb86860. Known Affected Releases: FRANGELICO. Known Fixed Releases: 6.2.0. |
| A "Cisco Firepower Threat Defense 6.0.0 through 6.2.2 and Cisco ASA with FirePOWER Module Denial of Service" vulnerability in the access control policy of Cisco Firepower System Software could allow an authenticated, remote attacker to cause an affected system to stop inspecting and processing packets, resulting in a denial of service (DoS) condition. The vulnerability is due to improper SSL policy handling by the affected software when packets are passed through the sensing interfaces of an affected system. An attacker could exploit this vulnerability by sending crafted packets through a targeted system. This vulnerability affects Cisco Firepower System Software that is configured with the SSL policy feature. Cisco Bug IDs: CSCvc84361. |
| A vulnerability in the logging configuration of Secure Sockets Layer (SSL) policies for Cisco FirePOWER System Software 5.3.0 through 6.2.2 could allow an unauthenticated, remote attacker to cause a denial of service (DoS) condition due to high consumption of system resources. The vulnerability is due to the logging of certain TCP packets by the affected software. An attacker could exploit this vulnerability by sending a flood of crafted TCP packets to an affected device. A successful exploit could allow the attacker to cause a DoS condition. The success of an exploit is dependent on how an administrator has configured logging for SSL policies for a device. This vulnerability affects Cisco FirePOWER System Software that is configured to log connections by using SSL policy default actions. Cisco Bug IDs: CSCvd07072. |
| A vulnerability in the detection engine of Cisco Firepower System Software could allow an unauthenticated, remote attacker to bypass file policies that are configured to block files transmitted to an affected device via the BitTorrent protocol. The vulnerability exists because the affected software does not detect BitTorrent handshake messages correctly. An attacker could exploit this vulnerability by sending a crafted BitTorrent connection request to an affected device. A successful exploit could allow the attacker to bypass file policies that are configured to block files transmitted to the affected device via the BitTorrent protocol. Cisco Bug IDs: CSCve26946. |
| A vulnerability in the internal packet-processing functionality of Cisco Firepower Threat Defense (FTD) Software for Cisco Firepower 2100 Series Security Appliances could allow an unauthenticated, remote attacker to cause an affected device to stop processing traffic, resulting in a denial of service (DoS) condition. The vulnerability is due to the affected software improperly validating IP Version 4 (IPv4) and IP Version 6 (IPv6) packets after the software reassembles the packets (following IP Fragmentation). An attacker could exploit this vulnerability by sending a series of malicious, fragmented IPv4 or IPv6 packets to an affected device. A successful exploit could allow the attacker to cause Snort processes on the affected device to hang at 100% CPU utilization, which could cause the device to stop processing traffic and result in a DoS condition until the device is reloaded manually. This vulnerability affects Cisco Firepower Threat Defense (FTD) Software Releases 6.2.1 and 6.2.2, if the software is running on a Cisco Firepower 2100 Series Security Appliance. Cisco Bug IDs: CSCvf91098. |
| Multiple vulnerabilities in the Application Layer Protocol Inspection feature of Cisco Adaptive Security Appliance (ASA) Software and Cisco Firepower Threat Defense (FTD) Software could allow an unauthenticated, remote attacker to trigger a reload of an affected device, resulting in a denial of service (DoS) condition. The vulnerabilities are due to logical errors during traffic inspection. An attacker could exploit these vulnerabilities by sending a high volume of malicious traffic across an affected device. An exploit could allow the attacker to cause a deadlock condition, resulting in a reload of an affected device. These vulnerabilities affect Cisco ASA Software and Cisco FTD Software configured for Application Layer Protocol Inspection running on the following Cisco products: 3000 Series Industrial Security Appliance (ISA), ASA 5500 Series Adaptive Security Appliances, ASA 5500-X Series Next-Generation Firewalls, ASA Services Module for Cisco Catalyst 6500 Series Switches and Cisco 7600 Series Routers, Adaptive Security Virtual Appliance (ASAv), Firepower 2100 Series Security Appliance, Firepower 4100 Series Security Appliance, Firepower 9300 ASA Security Module, FTD Virtual (FTDv). Cisco Bug IDs: CSCve61540, CSCvh23085, CSCvh95456. |
| A vulnerability in the Internet Key Exchange version 1 (IKEv1) feature of Cisco Adaptive Security Appliance (ASA) Software and Cisco Firepower Threat Defense (FTD) Software could allow an unauthenticated, remote attacker to trigger a reload of an affected device, resulting in a denial of service (DoS) condition. The vulnerability is due to improper management of system memory. An attacker could exploit this vulnerability by sending malicious IKEv1 traffic to an affected device. The attacker does not need valid credentials to authenticate the VPN session, nor does the attacker's source address need to match a peer statement in the crypto map applied to the ingress interface of the affected device. An exploit could allow the attacker to exhaust system memory resources, leading to a reload of an affected device. |
| A vulnerability in the TCP proxy functionality for Cisco Adaptive Security Appliance (ASA) Software and Cisco Firepower Threat Defense (FTD) Software could allow an unauthenticated, remote attacker to cause the device to restart unexpectedly, resulting in a denial of service (DoS) condition. The vulnerability is due to an error in TCP-based packet inspection, which could cause the TCP packet to have an invalid Layer 2 (L2)-formatted header. An attacker could exploit this vulnerability by sending a crafted TCP packet sequence to the targeted device. A successful exploit could allow the attacker to cause a DoS condition. |
| A vulnerability in the WebVPN service of Cisco Adaptive Security Appliance (ASA) Software and Cisco Firepower Threat Defense (FTD) Software could allow an authenticated, remote attacker to cause a denial of service (DoS) condition on an affected device. The vulnerability is due to improper management of authenticated sessions in the WebVPN portal. An attacker could exploit this vulnerability by authenticating with valid credentials and accessing a specific URL in the WebVPN portal. A successful exploit could allow the attacker to cause the device to reload, resulting in a temporary DoS condition. |
| A vulnerability in the detection engine of Cisco Adaptive Security Appliance (ASA) Software and Cisco Firepower Threat Defense (FTD) Software could allow an unauthenticated, adjacent attacker to send data directly to the kernel of an affected device. The vulnerability exists because the software improperly filters Ethernet frames sent to an affected device. An attacker could exploit this vulnerability by sending crafted packets to the management interface of an affected device. A successful exploit could allow the attacker to bypass the Layer 2 (L2) filters and send data directly to the kernel of the affected device. A malicious frame successfully delivered would make the target device generate a specific syslog entry. |
| A vulnerability in the inter-device communication mechanisms between devices that are running Cisco Firepower Threat Defense (FTD) Software and devices that are running Cisco Firepower Management (FMC) Software could allow an authenticated, local attacker to execute arbitrary commands with root permissions on the underlying operating system of an affected device.
This vulnerability is due to insufficient validation of user-supplied input. An attacker could exploit this vulnerability by accessing the expert mode of an affected device and submitting specific commands to a connected system. A successful exploit could allow the attacker to execute arbitrary code in the context of an FMC device if the attacker has administrative privileges on an associated FTD device. Alternatively, a successful exploit could allow the attacker to execute arbitrary code in the context of an FTD device if the attacker has administrative privileges on an associated FMC device. |
| A vulnerability in the Internet Key Exchange version 2 (IKEv2) protocol processing of Cisco Adaptive Security Appliance (ASA) Software, Cisco Firepower Threat Defense (FTD) Software, Cisco IOS Software, and Cisco IOS XE Software could allow an unauthenticated, remote attacker to cause a denial of service (DoS) condition on an affected device.
This vulnerability is due to insufficient input validation when processing IKEv2 messages. An attacker could exploit this vulnerability by sending crafted IKEv2 traffic to an affected device. A successful exploit could allow the attacker to cause the device to reload, resulting in a DoS condition on the affected device. |
| IBM Cognos Analytics 12.1.3 GA Version with build number through 12.1.3-2606251736 could allow an attacker to obtain incorrect report summary results or cause report-processing failures due to a race condition in the Agentic AI assistant's concurrent request-handling logic when multiple authenticated users submit report-related tasks simultaneously. |
| Acrobat Reader is affected by a Heap-based Buffer Overflow vulnerability that could result in arbitrary code execution in the context of the current user. Exploitation of this issue requires user interaction in that a victim must open a malicious file. |
| Improper neutralization of special elements used in an os command ('os command injection') in GitHub Copilot and Visual Studio Code allows an unauthorized attacker to elevate privileges locally. |
| In Eclipse OpenJ9 versions up to 0.60, using -Xtrace to trace method arguments can lead to buffer underflow. |
| In the Linux kernel, the following vulnerability has been resolved:
net: qualcomm: rmnet: fix endpoint use-after-free in rmnet_dellink()
rmnet_dellink() removes the endpoint from the hash table with
hlist_del_init_rcu() and then immediately frees it with kfree(). However,
RCU readers on the receive path (rmnet_rx_handler ->
__rmnet_map_ingress_handler) may still hold a reference to the endpoint and
dereference ep->egress_dev after the memory has been freed. The endpoint is
a kmalloc-32 object, and the stale read at offset 8 corresponds to the
egress_dev pointer.
BUG: unable to handle page fault for address: ffffffffde942eef
Oops: 0002 [#1] SMP NOPTI
CPU: 1 UID: 0 PID: 137 Comm: poc_write Not tainted 7.0.0+ #4 PREEMPTLAZY
RIP: 0010:rmnet_vnd_rx_fixup (rmnet_vnd.c:27)
Call Trace:
<TASK>
__rmnet_map_ingress_handler (rmnet_handlers.c:48 rmnet_handlers.c:101)
rmnet_rx_handler (rmnet_handlers.c:129 rmnet_handlers.c:235)
__netif_receive_skb_core.constprop.0 (net/core/dev.c:6096)
__netif_receive_skb_one_core (net/core/dev.c:6208)
netif_receive_skb (net/core/dev.c:6467)
tun_get_user (drivers/net/tun.c:1955)
tun_chr_write_iter (drivers/net/tun.c:2003)
vfs_write (fs/read_write.c:688)
ksys_write (fs/read_write.c:740)
</TASK>
Add an rcu_head field to struct rmnet_endpoint and replace kfree() with
kfree_rcu() so the endpoint memory remains valid through the RCU grace
period. Also remove the rmnet_vnd_dellink() call and inline only the
nr_rmnet_devs decrement, since rmnet_vnd_dellink() would set
ep->egress_dev to NULL during the grace period, creating a data race
with lockless readers. |
