| CVE |
Vendors |
Products |
Updated |
CVSS v3.1 |
| Two buffer overflow vulnerabilities existed in the wolfSSL CRL parser when parsing CRL numbers: a heap-based buffer overflow could occur when improperly storing the CRL number as a hexadecimal string, and a stack-based overflow for sufficiently sized CRL numbers. With appropriately crafted CRLs, either of these out of bound writes could be triggered. Note this only affects builds that specifically enable CRL support, and the user would need to load a CRL from an untrusted source. |
| A weakness has been identified in Tenda F456 1.0.0.5. The impacted element is the function fromaddressNat of the file /goform/addressNat. Executing a manipulation of the argument menufacturer/Go can lead to buffer overflow. The attack may be performed from remote. The exploit has been made available to the public and could be used for attacks. |
| A security vulnerability has been detected in Tenda F456 1.0.0.5. This affects the function fromRouteStatic of the file /goform/RouteStatic. The manipulation of the argument page leads to buffer overflow. It is possible to initiate the attack remotely. The exploit has been disclosed publicly and may be used. |
| A vulnerability was detected in Tenda F456 1.0.0.5. This impacts the function fromSafeMacFilter of the file /goform/SafeMacFilter. The manipulation of the argument page results in buffer overflow. It is possible to launch the attack remotely. The exploit is now public and may be used. |
| A flaw has been found in Tenda F456 1.0.0.5. Affected is the function SafeEmailFilter of the file /goform/SafeEmailFilter. This manipulation of the argument page causes buffer overflow. The attack can be initiated remotely. The exploit has been published and may be used. |
| In the Linux kernel, the following vulnerability has been resolved:
smb: client: fix off-by-8 bounds check in check_wsl_eas()
The bounds check uses (u8 *)ea + nlen + 1 + vlen as the end of the EA
name and value, but ea_data sits at offset sizeof(struct
smb2_file_full_ea_info) = 8 from ea, not at offset 0. The strncmp()
later reads ea->ea_data[0..nlen-1] and the value bytes follow at
ea_data[nlen+1..nlen+vlen], so the actual end is ea->ea_data + nlen + 1
+ vlen. Isn't pointer math fun?
The earlier check (u8 *)ea > end - sizeof(*ea) only guarantees the
8-byte header is in bounds, but since the last EA is placed within 8
bytes of the end of the response, the name and value bytes are read past
the end of iov.
Fix this mess all up by using ea->ea_data as the base for the bounds
check.
An "untrusted" server can use this to leak up to 8 bytes of kernel heap
into the EA name comparison and influence which WSL xattr the data is
interpreted as. |
| A security vulnerability has been detected in Tenda F456 1.0.0.5. Impacted is the function fromDhcpListClient of the file /goform/DhcpListClient of the component httpd. Such manipulation of the argument page leads to buffer overflow. The attack can be launched remotely. The exploit has been disclosed publicly and may be used. |
| A vulnerability was detected in Tenda F456 1.0.0.5. The affected element is the function formQuickIndex of the file /goform/QuickIndex of the component httpd. Performing a manipulation of the argument mit_linktype results in buffer overflow. The attack may be initiated remotely. The exploit is now public and may be used. |
| A flaw has been found in Tenda F456 1.0.0.5. The impacted element is the function fromNatlimitof of the file /goform/Natlimit of the component httpd. Executing a manipulation can lead to buffer overflow. The attack may be launched remotely. The exploit has been published and may be used. |
| A vulnerability has been found in Tenda F456 1.0.0.5. This affects the function fromWrlclientSet of the file /goform/WrlclientSet of the component httpd. The manipulation leads to buffer overflow. Remote exploitation of the attack is possible. The exploit has been disclosed to the public and may be used. |
| 1-byte OOB heap read in wc_PKCS7_DecodeEnvelopedData via zero-length encrypted content. A vulnerability existed in wolfSSL 5.8.4 and earlier, where a 1-byte out-of-bounds heap read in wc_PKCS7_DecodeEnvelopedData could be triggered by a crafted CMS EnvelopedData message with zero-length encrypted content. Note that PKCS7 support is disabled by default. |
| Heap buffer overflow in CertFromX509 via AuthorityKeyIdentifier size confusion. A heap buffer overflow occurs when converting an X.509 certificate internally due to incorrect size handling of the AuthorityKeyIdentifier extension. |
| Heap buffer overflow in DTLS 1.3 ACK message processing. A remote attacker can send a crafted DTLS 1.3 ACK message that triggers a heap buffer overflow. |
| In the Linux kernel, the following vulnerability has been resolved:
ksmbd: require 3 sub-authorities before reading sub_auth[2]
parse_dacl() compares each ACE SID against sid_unix_NFS_mode and on
match reads sid.sub_auth[2] as the file mode. If sid_unix_NFS_mode is
the prefix S-1-5-88-3 with num_subauth = 2 then compare_sids() compares
only min(num_subauth, 2) sub-authorities so a client SID with
num_subauth = 2 and sub_auth = {88, 3} will match.
If num_subauth = 2 and the ACE is placed at the very end of the security
descriptor, sub_auth[2] will be 4 bytes past end_of_acl. The
out-of-band bytes will then be masked to the low 9 bits and applied as
the file's POSIX mode, probably not something that is good to have
happen.
Fix this up by forcing the SID to actually carry a third sub-authority
before reading it at all. |
| A vulnerability was determined in Artifex MuPDF up to 1.28.0. The impacted element is the function fz_subset_cff_for_gids of the file subset-cff.c of the component CFF Index Handler. This manipulation causes out-of-bounds read. The attack can only be executed locally. The exploit has been publicly disclosed and may be utilized. The project was informed of the problem early through a bug report but has not responded yet. |
| A 1-byte stack buffer over-read was identified in the MatchDomainName function (src/internal.c) during wildcard hostname validation when the LEFT_MOST_WILDCARD_ONLY flag is active. If a wildcard * exhausts the entire hostname string, the function reads one byte past the buffer without a bounds check, which could cause a crash. |
| In the Linux kernel, the following vulnerability has been resolved:
ocfs2: handle invalid dinode in ocfs2_group_extend
[BUG]
kernel BUG at fs/ocfs2/resize.c:308!
Oops: invalid opcode: 0000 [#1] SMP KASAN NOPTI
RIP: 0010:ocfs2_group_extend+0x10aa/0x1ae0 fs/ocfs2/resize.c:308
Code: 8b8520ff ffff83f8 860f8580 030000e8 5cc3c1fe
Call Trace:
...
ocfs2_ioctl+0x175/0x6e0 fs/ocfs2/ioctl.c:869
vfs_ioctl fs/ioctl.c:51 [inline]
__do_sys_ioctl fs/ioctl.c:597 [inline]
__se_sys_ioctl fs/ioctl.c:583 [inline]
__x64_sys_ioctl+0x197/0x1e0 fs/ioctl.c:583
x64_sys_call+0x1144/0x26a0 arch/x86/include/generated/asm/syscalls_64.h:17
do_syscall_x64 arch/x86/entry/syscall_64.c:63 [inline]
do_syscall_64+0x93/0xf80 arch/x86/entry/syscall_64.c:94
entry_SYSCALL_64_after_hwframe+0x76/0x7e
...
[CAUSE]
ocfs2_group_extend() assumes that the global bitmap inode block
returned from ocfs2_inode_lock() has already been validated and
BUG_ONs when the signature is not a dinode. That assumption is too
strong for crafted filesystems because the JBD2-managed buffer path
can bypass structural validation and return an invalid dinode to the
resize ioctl.
[FIX]
Validate the dinode explicitly in ocfs2_group_extend(). If the global
bitmap buffer does not contain a valid dinode, report filesystem
corruption with ocfs2_error() and fail the resize operation instead of
crashing the kernel. |
| A vulnerability was detected in Totolink N300RT 3.4.0-B20250430. The impacted element is the function is_cmd_string_valid of the file /boafrm/formWsc of the component libapmib.so. Performing a manipulation of the argument localPin results in buffer overflow. The attack is possible to be carried out remotely. The exploit is now public and may be used. |
| A flaw has been found in Totolink N300RT 3.4.0-B20250430. This affects an unknown function of the file /boafrm/formIpQoS. Executing a manipulation of the argument entry_name can lead to buffer overflow. The attack may be performed from remote. The exploit has been published and may be used. |
| A stack buffer overflow exists in wolfSSL's PKCS7 implementation in the wc_PKCS7_DecryptOri() function in wolfcrypt/src/pkcs7.c. When processing a CMS EnvelopedData message containing an OtherRecipientInfo (ORI) recipient, the function copies an ASN.1-parsed OID into a fixed 32-byte stack buffer (oriOID[MAX_OID_SZ]) via XMEMCPY without first validating that the parsed OID length does not exceed MAX_OID_SZ. A crafted CMS EnvelopedData message with an ORI recipient containing an OID longer than 32 bytes triggers a stack buffer overflow. Exploitation requires the library to be built with --enable-pkcs7 (disabled by default) and the application to have registered an ORI decrypt callback via wc_PKCS7_SetOriDecryptCb(). |
