| CVE |
Vendors |
Products |
Updated |
CVSS v3.1 |
| When Express Path (formerly known as service offloading) is configured on Juniper Networks SRX1400, SRX3400, SRX3600, SRX5400, SRX5600, SRX5800 in high availability cluster configuration mode, certain multicast packets might cause the flowd process to crash, halting or interrupting traffic from flowing through the device and triggering RG1+ (data-plane) fail-over to the secondary node. Repeated crashes of the flowd process may constitute an extended denial of service condition. This service is not enabled by default and is only supported in high-end SRX platforms. Affected releases are Juniper Networks Junos OS 12.3X48 prior to 12.3X48-D45, 15.1X49 prior to 15.1X49-D80 on SRX1400, SRX3400, SRX3600, SRX5400, SRX5600, SRX5800. |
| MACsec feature on Juniper Networks Junos OS 15.1X49 prior to 15.1X49-D100 on SRX300 series does not report errors when a secure link can not be established. It falls back to an unencrypted link. This can happen when MACsec is configured on ports that are not capable of MACsec or when a secure link can not be established. This can mislead customers into believing that a link is secure. On SRX 300 series devices, prior to 15.1X49-D100, MACsec was only supported on control and fabric ports of SRX340 and SRX345 devices. SRX300 and and SRX320 did not have any MACsec capable ports. Configuring MACsec on ports that were not MACsec capable would have resulted in this issue. Affected releases are Juniper Networks Junos OS 15.1X49 prior to 15.1X49-D100 on SRX300 series. |
| Unspecified vulnerability in Juniper Junos before 11.4R10-S1, before 11.4R11, 12.1X44 before 12.1X44-D26, 12.1X44 before 12.1X44-D30, 12.1X45 before 12.1X45-D20, and 12.1X46 before 12.1X46-D10, when Dynamic IPsec VPN is configured, allows remote attackers to cause a denial of service (new Dynamic VPN connection failures and CPU and disk consumption) via unknown vectors. |
| Juniper Junos 11.4 before 11.4R12, 12.1X44 before 12.1X44-D32, 12.1X45 before 12.1X45-D25, 12.1X46 before 12.1X46-D20, and 12.1X47 before 12.1X47-D10 on SRX Series devices, when NAT protocol translation from IPv4 to IPv6 is enabled, allows remote attackers to cause a denial of service (flowd hang or crash) via a crafted packet. |
| The Juniper SRX Series devices with Junos 11.4 before 11.4R12-S4, 12.1X44 before 12.1X44-D40, 12.1X45 before 12.1X45-D30, 12.1X46 before 12.1X46-D25, and 12.1X47 before 12.1X47-D10, when an Application Layer Gateway (ALG) is enabled, allows remote attackers to cause a denial of service (flowd crash) via a crafted packet. |
| named in ISC BIND 9.x before 9.9.8-P4 and 9.10.x before 9.10.3-P4 does not properly handle DNAME records when parsing fetch reply messages, which allows remote attackers to cause a denial of service (assertion failure and daemon exit) via a malformed packet to the rndc (aka control channel) interface, related to alist.c and sexpr.c. |
| Juniper Junos 11.4 before 11.4R8, 12.1 before 12.1R5, 12.1X44 before 12.1X44-D20, 12.1X45 before 12.1X45-D15, 12.1X46 before 12.1X46-D10, and 12.1X47 before 12.1X47-D10 on SRX Series devices, allows remote attackers to cause a denial of service (flowd crash) via a malformed packet, related to translating IPv6 to IPv4. |
| Cross-site scripting (XSS) vulnerability in the Dynamic VPN in Juniper Junos 12.1X44 before 12.1X44-D45, 12.1X46 before 12.1X46-D30, 12.1X47 before 12.1X47-D20, and 12.3X48 before 12.3X48-D10 on SRX series devices allows remote attackers to inject arbitrary web script or HTML via unspecified vectors. |
| named in ISC BIND 9.x before 9.9.8-P4 and 9.10.x before 9.10.3-P4 allows remote attackers to cause a denial of service (assertion failure and daemon exit) via a crafted signature record for a DNAME record, related to db.c and resolver.c. |
| The SRX Network Security Daemon (nsd) in Juniper SRX Series services gateways with Junos 12.1X44 before 12.1X44-D50, 12.1X46 before 12.1X46-D35, 12.1X47 before 12.1X47-D25, and 12.3X48 before 12.3X48-D15 allows remote DNS servers to cause a denial of service (crash) via a crafted DNS response. |
| Juniper Junos 12.1X46 before 12.1X46-D20 and 12.1X47 before 12.1X47-D10 on SRX Series devices allows remote attackers to cause a denial of service (flowd crash) via a crafted SIP packet. |
| Embedthis Appweb before 4.6.6 and 5.x before 5.2.1 allows remote attackers to cause a denial of service (NULL pointer dereference) via a Range header with an empty value, as demonstrated by "Range: x=,". |
| Juniper Junos 12.1X44 before 12.1X44-D45, 12.1X46 before 12.1X46-D30, 12.1X47 before 12.1X47-D15, and 12.3X48 before 12.3X48-D10 on SRX series devices does not properly enforce the log-out-on-disconnect feature when configured in the [system port console] stanza, which allows physically proximate attackers to reconnect to the console port and gain administrative access by leveraging access to the device. |
| An Improper Check for Unusual or Exceptional Conditions vulnerability in the Packet Forwarding Engine (pfe) of Juniper Networks Junos OS on SRX Series, and MX Series with SPC3 allows an unauthenticated, network-based attacker to cause a Denial-of-Service (DoS).
When an affected device receives specific valid TCP traffic, the pfe crashes and restarts leading to a momentary but complete service outage.
This issue affects Junos OS:
21.2 releases from 21.2R3-S5 before 21.2R3-S6.
This issue does not affect earlier or later releases. |
| A Missing Authentication for Critical Function vulnerability in the Packet Forwarding Engine (pfe) of Juniper Networks Junos OS on MX Series with SPC3, and SRX Series allows an unauthenticated network-based attacker to cause limited impact to the integrity or availability of the device.
If a device is configured with IPsec authentication algorithm hmac-sha-384 or hmac-sha-512, tunnels are established normally but for traffic traversing the tunnel no authentication information is sent with the encrypted data on egress, and no authentication information is expected on ingress. So if the peer is an unaffected device transit traffic is going to fail in both directions. If the peer is an also affected device transit traffic works, but without authentication, and configuration and CLI operational commands indicate authentication is performed.
This issue affects Junos OS:
* All versions before 20.4R3-S7,
* 21.1 versions before 21.1R3,
* 21.2 versions before 21.2R2-S1, 21.2R3,
* 21.3 versions before 21.3R1-S2, 21.3R2. |
| flowd in Juniper Junos 10.4 before 10.4S14, 11.2 and 11.4 before 11.4R6-S2, and 12.1 before 12.1R6 on SRX devices, when certain Application Layer Gateways (ALGs) are enabled, allows remote attackers to cause a denial of service (daemon crash) via crafted TCP packets, aka PRs 727980, 806269, and 835593. |
| Juniper Junos before 10.4S14, 11.4 before 11.4R5-S2, 12.1R before 12.1R3, 12.1X44 before 12.1X44-D20, and 12.1X45 before 12.1X45-D15 on SRX Series services gateways, when a plugin using TCP proxy is configured, allows remote attackers to cause a denial of service (flow daemon crash) via an unspecified sequence of TCP packets. |
| Buffer overflow in the flow daemon (flowd) in Juniper Junos 10.4 before 10.4S14, 11.4 before 11.4R7-S2, 12.1.X44 before 12.1X44-D15, 12.1X45 before 12.1X45-D10 on SRX devices, when using telnet pass-through authentication on the firewall, might allow remote attackers to execute arbitrary code via a crafted telnet message. |
| Juniper Junos 10.4 before 10.4S13, 11.4 before 11.4R7-S1, 12.1 before 12.1R5-S3, 12.1X44 before 12.1X44-D20, and 12.1X45 before 12.1X45-D10 on the SRX1400, SRX3400, and SRX3600 does not properly initialize memory locations used during padding of Ethernet packets, which allows remote attackers to obtain sensitive information by reading packet data, aka PR 829536, a related issue to CVE-2003-0001. |
| Buffer overflow in flowd in Juniper Junos 10.4 before 10.4S14, 11.4 before 11.4R7, 12.1 before 12.1R6, and 12.1X44 before 12.1X44-D15 on SRX devices, when Captive Portal is enabled with the UAC enforcer role, allows remote attackers to execute arbitrary code via crafted HTTP requests, aka PR 849100. |
