Filtered by vendor Juniper Subscriptions
Total 866 CVE
CVE Vendors Products Updated CVSS v3.1
CVE-2024-21620 1 Juniper 105 Ex2200, Ex2200-c, Ex2200-vc and 102 more 2024-08-01 8.8 High
An Improper Neutralization of Input During Web Page Generation ('Cross-site Scripting') vulnerability in J-Web of Juniper Networks Junos OS on SRX Series and EX Series allows an attacker to construct a URL that when visited by another user enables the attacker to execute commands with the target's permissions, including an administrator. A specific invocation of the emit_debug_note method in webauth_operation.php will echo back the data it receives. This issue affects Juniper Networks Junos OS on SRX Series and EX Series: * All versions earlier than 20.4R3-S10; * 21.2 versions earlier than 21.2R3-S8; * 21.4 versions earlier than 21.4R3-S6; * 22.1 versions earlier than 22.1R3-S5; * 22.2 versions earlier than 22.2R3-S3; * 22.3 versions earlier than 22.3R3-S2; * 22.4 versions earlier than 22.4R3-S1; * 23.2 versions earlier than 23.2R2; * 23.4 versions earlier than 23.4R2.
CVE-2024-21600 1 Juniper 1 Junos 2024-08-01 6.5 Medium
An Improper Neutralization of Equivalent Special Elements vulnerability in the Packet Forwarding Engine (PFE) of Juniper Networks Junos OS on PTX Series allows a unauthenticated, adjacent attacker to cause a Denial of Service (DoS). When MPLS packets are meant to be sent to a flexible tunnel interface (FTI) and if the FTI tunnel is down, these will hit the reject NH, due to which the packets get sent to the CPU and cause a host path wedge condition. This will cause the FPC to hang and requires a manual restart to recover. Please note that this issue specifically affects PTX1000, PTX3000, PTX5000 with FPC3, PTX10002-60C, and PTX10008/16 with LC110x. Other PTX Series devices and Line Cards (LC) are not affected. The following log message can be seen when the issue occurs: Cmerror Op Set: Host Loopback: HOST LOOPBACK WEDGE DETECTED IN PATH ID <id> (URI: /fpc/<fpc>/pfe/<pfe>/cm/<cm>/Host_Loopback/<cm>/HOST_LOOPBACK_MAKE_CMERROR_ID[<id>]) This issue affects Juniper Networks Junos OS: * All versions earlier than 20.4R3-S8; * 21.1 versions earlier than 21.1R3-S4; * 21.2 versions earlier than 21.2R3-S6; * 21.3 versions earlier than 21.3R3-S3; * 21.4 versions earlier than 21.4R3-S5; * 22.1 versions earlier than 22.1R2-S2, 22.1R3; * 22.2 versions earlier than 22.2R2-S1, 22.2R3.
CVE-2024-21587 1 Juniper 20 Junos, Mx10, Mx10000 and 17 more 2024-08-01 6.5 Medium
An Improper Handling of Exceptional Conditions vulnerability in the broadband edge subscriber management daemon (bbe-smgd) of Juniper Networks Junos OS on MX Series allows an attacker directly connected to the vulnerable system who repeatedly flaps DHCP subscriber sessions to cause a slow memory leak, ultimately leading to a Denial of Service (DoS). Memory can only be recovered by manually restarting bbe-smgd. This issue only occurs if BFD liveness detection for DHCP subscribers is enabled. Systems without BFD liveness detection enabled are not vulnerable to this issue. Indication of the issue can be observed by periodically executing the 'show system processes extensive' command, which will indicate an increase in memory allocation for bbe-smgd. A small amount of memory is leaked every time a DHCP subscriber logs in, which will become visible over time, ultimately leading to memory starvation. user@junos> show system processes extensive | match bbe-smgd 13071 root 24 0 415M 201M select 0 0:41 7.28% bbe-smgd{bbe-smgd} 13071 root 20 0 415M 201M select 1 0:04 0.00% bbe-smgd{bbe-smgd} ... user@junos> show system processes extensive | match bbe-smgd 13071 root 20 0 420M 208M select 0 4:33 0.10% bbe-smgd{bbe-smgd} 13071 root 20 0 420M 208M select 0 0:12 0.00% bbe-smgd{bbe-smgd} ... This issue affects Juniper Networks Junos OS on MX Series: * All versions earlier than 20.4R3-S9; * 21.2 versions earlier than 21.2R3-S7; * 21.3 versions earlier than 21.3R3-S5; * 21.4 versions earlier than 21.4R3-S5; * 22.1 versions earlier than 22.1R3-S4; * 22.2 versions earlier than 22.2R3-S3; * 22.3 versions earlier than 22.3R3-S2; * 22.4 versions earlier than 22.4R2-S2, 22.4R3; * 23.2 versions earlier than 23.2R1-S1, 23.2R2.
CVE-2024-21591 1 Juniper 1 Junos 2024-08-01 9.8 Critical
An Out-of-bounds Write vulnerability in J-Web of Juniper Networks Junos OS on SRX Series and EX Series allows an unauthenticated, network-based attacker to cause a Denial of Service (DoS), or Remote Code Execution (RCE) and obtain root privileges on the device. This issue is caused by use of an insecure function allowing an attacker to overwrite arbitrary memory. This issue affects Juniper Networks Junos OS SRX Series and EX Series: * Junos OS versions earlier than 20.4R3-S9; * Junos OS 21.2 versions earlier than 21.2R3-S7; * Junos OS 21.3 versions earlier than 21.3R3-S5; * Junos OS 21.4 versions earlier than 21.4R3-S5; * Junos OS 22.1 versions earlier than 22.1R3-S4; * Junos OS 22.2 versions earlier than 22.2R3-S3; * Junos OS 22.3 versions earlier than 22.3R3-S2; * Junos OS 22.4 versions earlier than 22.4R2-S2, 22.4R3.
CVE-2024-21585 1 Juniper 2 Junos, Junos Os Evolved 2024-08-01 5.9 Medium
An Improper Handling of Exceptional Conditions vulnerability in BGP session processing of Juniper Networks Junos OS and Junos OS Evolved allows an unauthenticated network-based attacker, using specific timing outside the attacker's control, to flap BGP sessions and cause the routing protocol daemon (rpd) process to crash and restart, leading to a Denial of Service (DoS) condition. Continued BGP session flapping will create a sustained Denial of Service (DoS) condition. This issue only affects routers configured with non-stop routing (NSR) enabled. Graceful Restart (GR) helper mode, enabled by default, is also required for this issue to be exploitable. Note: NSR is not supported on the SRX Series and is therefore not affected by this vulnerability. When the BGP session flaps on the NSR-enabled router, the device enters GR-helper/LLGR-helper mode due to the peer having negotiated GR/LLGR-restarter capability and the backup BGP requests for replication of the GR/LLGR-helper session, master BGP schedules, and initiates replication of GR/LLGR stale routes to the backup BGP. In this state, if the BGP session with the BGP peer comes up again, unsolicited replication is initiated for the peer without cleaning up the ongoing GR/LLGR-helper mode replication. This parallel two instances of replication for the same peer leads to the assert if the BGP session flaps again. This issue affects: Juniper Networks Junos OS * All versions earlier than 20.4R3-S9; * 21.2 versions earlier than 21.2R3-S7; * 21.3 versions earlier than 21.3R3-S5; * 21.4 versions earlier than 21.4R3-S5; * 22.1 versions earlier than 22.1R3-S4; * 22.2 versions earlier than 22.2R3-S3; * 22.3 versions earlier than 22.3R3-S1; * 22.4 versions earlier than 22.4R2-S2, 22.4R3; * 23.2 versions earlier than 23.2R1-S1, 23.2R2. Juniper Networks Junos OS Evolved * All versions earlier than 21.3R3-S5-EVO; * 21.4 versions earlier than 21.4R3-S5-EVO; * 22.1 versions earlier than 22.1R3-S4-EVO; * 22.2 versions earlier than 22.2R3-S3-EVO; * 22.3 versions earlier than 22.3R3-S1-EVO; * 22.4 versions earlier than 22.4R2-S2-EVO, 22.4R3-EVO; * 23.2 versions earlier than 23.2R1-S1-EVO, 23.2R2-EVO.
CVE-2024-21589 1 Juniper 1 Paragon Active Assurance Control Center 2024-08-01 7.4 High
An Improper Access Control vulnerability in the Juniper Networks Paragon Active Assurance Control Center allows an unauthenticated network-based attacker to access reports without authenticating, potentially containing sensitive configuration information. A feature was introduced in version 3.1.0 of the Paragon Active Assurance Control Center which allows users to selectively share account data. By exploiting this vulnerability, it is possible to access reports without being logged in, resulting in the opportunity for malicious exfiltration of user data. Note that the Paragon Active Assurance Control Center SaaS offering is not affected by this issue. This issue affects Juniper Networks Paragon Active Assurance versions 3.1.0, 3.2.0, 3.2.2, 3.3.0, 3.3.1, 3.4.0. This issue does not affect Juniper Networks Paragon Active Assurance versions earlier than 3.1.0.