| CVE |
Vendors |
Products |
Updated |
CVSS v3.1 |
| A vulnerability in the activation of an access control list (ACL) on Cisco Adaptive Security Appliance (ASA) Software and Cisco Firepower Threat Defense (FTD) Software could allow an unauthenticated, remote attacker to bypass the protection that is offered by a configured ACL on an affected device. This vulnerability is due to a logic error that occurs when an ACL changes from inactive to active in the running configuration of an affected device. An attacker could exploit this vulnerability by sending traffic through the affected device that should be denied by the configured ACL. The reverse condition is also true—traffic that should be permitted could be denied by the configured ACL. A successful exploit could allow the attacker to bypass configured ACL protections on the affected device, allowing the attacker to access trusted networks that the device might be protecting. Note: This vulnerability applies to both IPv4 and IPv6 traffic as well as dual-stack ACL configurations in which both IPv4 and IPv6 ACLs are configured on an interface. |
| A vulnerability in the remote access VPN feature of Cisco Adaptive Security Appliance (ASA) Software and Cisco Firepower Threat Defense (FTD) Software could allow an unauthenticated, remote attacker to conduct a brute force attack in an attempt to identify valid username and password combinations or an authenticated, remote attacker to establish a clientless SSL VPN session with an unauthorized user.
This vulnerability is due to improper separation of authentication, authorization, and accounting (AAA) between the remote access VPN feature and the HTTPS management and site-to-site VPN features. An attacker could exploit this vulnerability by specifying a default connection profile/tunnel group while conducting a brute force attack or while establishing a clientless SSL VPN session using valid credentials. A successful exploit could allow the attacker to achieve one or both of the following:
Identify valid credentials that could then be used to establish an unauthorized remote access VPN session.
Establish a clientless SSL VPN session (only when running Cisco ASA Software Release 9.16 or earlier).
Notes:
Establishing a client-based remote access VPN tunnel is not possible as these default connection profiles/tunnel groups do not and cannot have an IP address pool configured.
This vulnerability does not allow an attacker to bypass authentication. To successfully establish a remote access VPN session, valid credentials are required, including a valid second factor if multi-factor authentication (MFA) is configured.
Cisco will release software updates that address this vulnerability. There are workarounds that address this vulnerability. |
| A vulnerability in the OSPF protocol of Cisco Secure Firewall ASA Software and Cisco Secure FTD Software could allow an unauthenticated, adjacent attacker to cause an affected device to reload unexpectedly, resulting in a DoS condition. If OSPF authentication is enabled, the attacker must know the secret key to exploit this vulnerability.
This vulnerability is due to insufficient input validation when processing OSPF update packets. An attacker could exploit this vulnerability by sending crafted OSPF update packets. A successful exploit could allow the attacker to create a buffer overflow, causing the affected device to reload, resulting in a DoS condition. |
| A vulnerability in the Simple Network Management Protocol (SNMP) feature of Cisco Adaptive Security Appliance (ASA) Software and Cisco Firepower Threat Defense (FTD) Software could allow an authenticated, remote attacker to cause a denial of service (DoS) condition on an affected device.
This vulnerability is due to insufficient input validation. An attacker could exploit this vulnerability by sending a crafted SNMP request to an affected device. A successful exploit could allow the attacker to cause the affected device to reload, resulting in a DoS condition. |
| Multiple vulnerabilities in the per-user-override feature of Cisco Adaptive Security Appliance (ASA) Software and Cisco Firepower Threat Defense (FTD) Software could allow an unauthenticated, remote attacker to bypass a configured access control list (ACL) and allow traffic that should be denied to flow through an affected device. These vulnerabilities are due to a logic error that could occur when the affected software constructs and applies per-user-override rules. An attacker could exploit these vulnerabilities by connecting to a network through an affected device that has a vulnerable configuration. A successful exploit could allow the attacker to bypass the interface ACL and access resources that would should be protected. |
| A vulnerability in the Secure Sockets Layer (SSL) VPN functionality of the Cisco Adaptive Security Appliance (ASA) Software could allow an unauthenticated, remote attacker to cause a reload of the affected system or to remotely execute code. The vulnerability is due to an attempt to double free a region of memory when the webvpn feature is enabled on the Cisco ASA device. An attacker could exploit this vulnerability by sending multiple, crafted XML packets to a webvpn-configured interface on the affected system. An exploit could allow the attacker to execute arbitrary code and obtain full control of the system, or cause a reload of the affected device. This vulnerability affects Cisco ASA Software that is running on the following Cisco products: 3000 Series Industrial Security Appliance (ISA), ASA 5500 Series Adaptive Security Appliances, ASA 5500-X Series Next-Generation Firewalls, ASA Services Module for Cisco Catalyst 6500 Series Switches and Cisco 7600 Series Routers, ASA 1000V Cloud Firewall, Adaptive Security Virtual Appliance (ASAv), Firepower 2100 Series Security Appliance, Firepower 4110 Security Appliance, Firepower 9300 ASA Security Module, Firepower Threat Defense Software (FTD). Cisco Bug IDs: CSCvg35618. |
| Multiple vulnerabilities in Cisco Adaptive Security Appliance (ASA) Software and Firepower Threat Defense (FTD) Software could allow an unauthenticated, remote attacker to cause a denial of service (DoS) condition on an affected device. These vulnerabilities are due to lack of proper input validation of the HTTPS request. An attacker could exploit these vulnerabilities by sending a crafted HTTPS request to an affected device. A successful exploit could allow the attacker to cause the affected device to reload, resulting in a DoS condition. Note: This vulnerability affects only specific AnyConnect and WebVPN configurations. For more information, see the Vulnerable Products section. |
| Multiple vulnerabilities in the per-user-override feature of Cisco Adaptive Security Appliance (ASA) Software and Cisco Firepower Threat Defense (FTD) Software could allow an unauthenticated, remote attacker to bypass a configured access control list (ACL) and allow traffic that should be denied to flow through an affected device. These vulnerabilities are due to a logic error that could occur when the affected software constructs and applies per-user-override rules. An attacker could exploit these vulnerabilities by connecting to a network through an affected device that has a vulnerable configuration. A successful exploit could allow the attacker to bypass the interface ACL and access resources that would should be protected. |
| A vulnerability in the AnyConnect firewall for Cisco Adaptive Security Appliance (ASA) Software and Cisco Firepower Threat Defense (FTD) Software could allow an unauthenticated, remote attacker to bypass a configured access control list (ACL) and allow traffic that should have been denied to flow through an affected device. This vulnerability is due to a logic error in populating group ACLs when an AnyConnect client establishes a new session toward an affected device. An attacker could exploit this vulnerability by establishing an AnyConnect connection to the affected device. A successful exploit could allow the attacker to bypass configured ACL rules. |
| A vulnerability in ICMPv6 processing of Cisco Adaptive Security Appliance (ASA) Software and Cisco Firepower Threat Defense (FTD) Software could allow an unauthenticated, remote attacker to cause a denial of service (DoS) condition. This vulnerability is due to improper processing of ICMPv6 messages. An attacker could exploit this vulnerability by sending crafted ICMPv6 messages to a targeted Cisco ASA or FTD system with IPv6 enabled. A successful exploit could allow the attacker to cause the device to reload, resulting in a DoS condition. |
| A vulnerability in the IPv6 DHCP (DHCPv6) client module of Cisco Adaptive Security Appliance (ASA) Software, Cisco Firepower Threat Defense (FTD) Software, Cisco IOS Software, and Cisco IOS XE Software could allow an unauthenticated, remote attacker to cause a denial of service (DoS) condition on an affected device. This vulnerability is due to insufficient validation of DHCPv6 messages. An attacker could exploit this vulnerability by sending crafted DHCPv6 messages to an affected device. A successful exploit could allow the attacker to cause the device to reload, resulting in a DoS condition. Note: To successfully exploit this vulnerability, the attacker would need to either control the DHCPv6 server or be in a man-in-the-middle position. |
| A vulnerability in the web services interface of Cisco Adaptive Security Appliance (ASA) Software and Cisco Firepower Threat Defense (FTD) Software could allow an unauthenticated, remote attacker to trigger a denial of service (DoS) condition. This vulnerability is due to improper input validation when parsing HTTPS requests. An attacker could exploit this vulnerability by sending a malicious HTTPS request to an affected device. A successful exploit could allow the attacker to cause the device to reload, resulting in a DoS condition. |
| A vulnerability in the implementation of Security Assertion Markup Language (SAML) 2.0 single sign-on (SSO) for remote access VPN in Cisco Adaptive Security Appliance (ASA) Software and Cisco Firepower Threat Defense (FTD) Software could allow an unauthenticated, remote attacker to intercept the SAML assertion of a user who is authenticating to a remote access VPN session. This vulnerability is due to insufficient validation of the login URL. An attacker could exploit this vulnerability by persuading a user to access a site that is under the control of the attacker, allowing the attacker to modify the login URL. A successful exploit could allow the attacker to intercept a successful SAML assertion and use that assertion to establish a remote access VPN session toward the affected device with the identity and permissions of the hijacked user, resulting in access to the protected network. |
| A vulnerability in the VPN web client services feature of Cisco Adaptive Security Appliance (ASA) Software and Cisco Firepower Threat Defense (FTD) Software could allow an unauthenticated, remote attacker to conduct a cross-site scripting (XSS) attack against a browser that is accessing an affected device. This vulnerability is due to improper validation of user-supplied input to application endpoints. An attacker could exploit this vulnerability by persuading a user to follow a link designed to submit malicious input to the affected application. A successful exploit could allow the attacker to execute arbitrary HTML or script code in the browser in the context of the web services page. |
| A vulnerability in the SIP inspection engine of Cisco Adaptive Security Appliance (ASA) Software and Cisco Firepower Threat Defense (FTD) Software could allow an unauthenticated, remote attacker to cause a crash and reload of an affected device, resulting in a denial of service (DoS) condition.The vulnerability is due to a crash that occurs during a hash lookup for a SIP pinhole connection. An attacker could exploit this vulnerability by sending crafted SIP traffic through an affected device. A successful exploit could allow the attacker to cause a crash and reload of the affected device. |
| A vulnerability in the Simple Network Management Protocol (SNMP) feature of Cisco Adaptive Security Appliance (ASA) Software and Cisco Firepower Threat Defense (FTD) Software could allow an authenticated, remote attacker to cause an unexpected reload of the device.
This vulnerability is due to insufficient input validation of SNMP packets. An attacker could exploit this vulnerability by sending a crafted SNMP request to an affected device using IPv4 or IPv6. A successful exploit could allow the attacker to cause the affected device to reload, resulting in a denial of service (DoS) condition. This vulnerability affects all versions of SNMP (versions 1, 2c, and 3) and requires a valid SNMP community string or valid SNMPv3 user credentials. |
| A vulnerability in the implementation of SAML 2.0 single sign-on (SSO) for remote access VPN services in Cisco Adaptive Security Appliance (ASA) Software and Cisco Firepower Threat Defense (FTD) Software could allow an authenticated, remote attacker to successfully establish a VPN session on an affected device. This vulnerability is due to improper separation of authorization domains when using SAML authentication. An attacker could exploit this vulnerability by using valid credentials to successfully authenticate using their designated connection profile (tunnel group), intercepting the SAML SSO token that is sent back from the Cisco ASA device, and then submitting the same SAML SSO token to a different tunnel group for authentication. A successful exploit could allow the attacker to establish a remote access VPN session using a connection profile that they are not authorized to use and connect to secured networks behind the affected device that they are not authorized to access. For successful exploitation, the attacker must have valid remote access VPN user credentials. |
| A vulnerability in the SSL/TLS client of Cisco Adaptive Security Appliance (ASA) Software and Cisco Firepower Threat Defense (FTD) Software could allow an authenticated, remote attacker to cause a denial of service (DoS) condition on an affected device.
This vulnerability is due to improper memory management when a device initiates SSL/TLS connections. An attacker could exploit this vulnerability by ensuring that the device will connect to an SSL/TLS server that is using specific encryption parameters. A successful exploit could allow the attacker to cause the affected device to unexpectedly reload, resulting in a DoS condition. |
| A vulnerability in the CLI of Cisco FXOS Software could allow an authenticated, local attacker to read or write arbitrary files on the underlying operating system (OS). The vulnerability is due to insufficient input validation. An attacker could exploit this vulnerability by including crafted arguments to a specific CLI command. A successful exploit could allow the attacker to read or write to arbitrary files on the underlying OS. |
| A vulnerability in the implementation of Security Assertion Markup Language (SAML) 2.0 Single Sign-On (SSO) for Clientless SSL VPN (WebVPN) and AnyConnect Remote Access VPN in Cisco Adaptive Security Appliance (ASA) Software and Cisco Firepower Threat Defense (FTD) Software could allow an unauthenticated, remote attacker to successfully establish a VPN session to an affected device. The vulnerability is due to improper credential management when using NT LAN Manager (NTLM) or basic authentication. An attacker could exploit this vulnerability by opening a VPN session to an affected device after another VPN user has successfully authenticated to the affected device via SAML SSO. A successful exploit could allow the attacker to connect to secured networks behind the affected device. |
