| CVE |
Vendors |
Products |
Updated |
CVSS v3.1 |
| A vulnerability in the generic routing encapsulation (GRE) tunnel decapsulation feature of Cisco Firepower Threat Defense (FTD) Software could allow an unauthenticated, remote attacker to cause a denial of service (DoS) condition on an affected device. The vulnerability is due to a memory handling error when GRE over IPv6 traffic is processed. An attacker could exploit this vulnerability by sending crafted GRE over IPv6 packets with either IPv4 or IPv6 payload through an affected device. A successful exploit could allow the attacker to cause the device to crash, resulting in a DoS condition. |
| A vulnerability in the Kerberos authentication feature of Cisco Adaptive Security Appliance (ASA) Software could allow an unauthenticated, remote attacker to impersonate the Kerberos key distribution center (KDC) and bypass authentication on an affected device that is configured to perform Kerberos authentication for VPN or local device access. The vulnerability is due to insufficient identity verification of the KDC when a successful authentication response is received. An attacker could exploit this vulnerability by spoofing the KDC server response to the ASA device. This malicious response would not have been authenticated by the KDC. A successful attack could allow an attacker to bypass Kerberos authentication. |
| A vulnerability in the cryptographic driver for Cisco Adaptive Security Appliance Software (ASA) and Firepower Threat Defense (FTD) Software could allow an unauthenticated, remote attacker to cause the device to reboot unexpectedly. The vulnerability is due to incomplete input validation of a Secure Sockets Layer (SSL) or Transport Layer Security (TLS) ingress packet header. An attacker could exploit this vulnerability by sending a crafted TLS/SSL packet to an interface on the targeted device. An exploit could allow the attacker to cause the device to reload, which will result in a denial of service (DoS) condition. Note: Only traffic directed to the affected system can be used to exploit this vulnerability. This vulnerability affects systems configured in routed and transparent firewall mode and in single or multiple context mode. This vulnerability can be triggered by IPv4 and IPv6 traffic. A valid SSL or TLS session is required to exploit this vulnerability. |
| A vulnerability in the Deterministic Random Bit Generator (DRBG), also known as Pseudorandom Number Generator (PRNG), used in Cisco Adaptive Security Appliance (ASA) Software and Cisco Firepower Threat Defense (FTD) Software could allow an unauthenticated, remote attacker to cause a cryptographic collision, enabling the attacker to discover the private key of an affected device. The vulnerability is due to insufficient entropy in the DRBG when generating cryptographic keys. An attacker could exploit this vulnerability by generating a large number of cryptographic keys on an affected device and looking for collisions with target devices. A successful exploit could allow the attacker to impersonate an affected target device or to decrypt traffic secured by an affected key that is sent to or from an affected target device. |
| A vulnerability in the implementation of Security Assertion Markup Language (SAML) 2.0 Single Sign-On (SSO) for Clientless SSL VPN (WebVPN) and AnyConnect Remote Access VPN in Cisco Adaptive Security Appliance (ASA) Software and Cisco Firepower Threat Defense (FTD) Software could allow an unauthenticated, remote attacker to successfully establish a VPN session to an affected device. The vulnerability is due to improper credential management when using NT LAN Manager (NTLM) or basic authentication. An attacker could exploit this vulnerability by opening a VPN session to an affected device after another VPN user has successfully authenticated to the affected device via SAML SSO. A successful exploit could allow the attacker to connect to secured networks behind the affected device. |
| A vulnerability in the Internet Key Exchange Version 2 Mobility and Multihoming Protocol (MOBIKE) feature for the Cisco Adaptive Security Appliance (ASA) Software and Cisco Firepower Threat Defense (FTD) Software could allow an unauthenticated, remote attacker to cause a memory leak or a reload of an affected device that leads to a denial of service (DoS) condition. The vulnerability is due to the incorrect processing of certain MOBIKE packets. An attacker could exploit this vulnerability by sending crafted MOBIKE packets to an affected device to be processed. A successful exploit could cause an affected device to continuously consume memory and eventually reload, resulting in a DoS condition. The MOBIKE feature is supported only for IPv4 addresses. |
| A vulnerability in the software cryptography module of the Cisco Adaptive Security Virtual Appliance (ASAv) and Firepower 2100 Series running Cisco Adaptive Security Appliance (ASA) Software could allow an unauthenticated, remote attacker to cause an unexpected reload of the device that results in a denial of service (DoS) condition. The vulnerability is due to a logic error with how the software cryptography module handles IPsec sessions. An attacker could exploit this vulnerability by creating and sending traffic in a high number of IPsec sessions through the targeted device. A successful exploit could cause the device to reload and result in a DoS condition. |
| A vulnerability in the remote access VPN session manager of Cisco Adaptive Security Appliance (ASA) Software could allow a unauthenticated, remote attacker to cause a denial of service (DoS) condition on the remote access VPN services. The vulnerability is due to an issue with the remote access VPN session manager. An attacker could exploit this vulnerability by requesting an excessive number of remote access VPN sessions. An exploit could allow the attacker to cause a DoS condition. |
| A vulnerability in the TCP processing engine of Cisco Adaptive Security Appliance (ASA) Software and Cisco Firepower Threat Defense (FTD) Software could allow an unauthenticated, remote attacker to cause an affected device to reload, resulting in a denial of service (DoS) condition. The vulnerability is due to the improper handling of TCP traffic. An attacker could exploit this vulnerability by sending a specific sequence of packets at a high rate through an affected device. A successful exploit could allow the attacker to temporarily disrupt traffic through the device while it reboots. |
| A vulnerability in the logic that handles access control to one of the hardware components in Cisco's proprietary Secure Boot implementation could allow an authenticated, local attacker to write a modified firmware image to the component. This vulnerability affects multiple Cisco products that support hardware-based Secure Boot functionality. The vulnerability is due to an improper check on the area of code that manages on-premise updates to a Field Programmable Gate Array (FPGA) part of the Secure Boot hardware implementation. An attacker with elevated privileges and access to the underlying operating system that is running on the affected device could exploit this vulnerability by writing a modified firmware image to the FPGA. A successful exploit could either cause the device to become unusable (and require a hardware replacement) or allow tampering with the Secure Boot verification process, which under some circumstances may allow the attacker to install and boot a malicious software image. An attacker will need to fulfill all the following conditions to attempt to exploit this vulnerability: Have privileged administrative access to the device. Be able to access the underlying operating system running on the device; this can be achieved either by using a supported, documented mechanism or by exploiting another vulnerability that would provide an attacker with such access. Develop or have access to a platform-specific exploit. An attacker attempting to exploit this vulnerability across multiple affected platforms would need to research each one of those platforms and then develop a platform-specific exploit. Although the research process could be reused across different platforms, an exploit developed for a given hardware platform is unlikely to work on a different hardware platform. |
| A vulnerability in the Internet Key Exchange version 1 (IKEv1) feature of Cisco Adaptive Security Appliance (ASA) Software and Cisco Firepower Threat Defense (FTD) Software could allow an unauthenticated, remote attacker to trigger a reload of an affected device, resulting in a denial of service (DoS) condition. The vulnerability is due to improper management of system memory. An attacker could exploit this vulnerability by sending malicious IKEv1 traffic to an affected device. The attacker does not need valid credentials to authenticate the VPN session, nor does the attacker's source address need to match a peer statement in the crypto map applied to the ingress interface of the affected device. An exploit could allow the attacker to exhaust system memory resources, leading to a reload of an affected device. |
| A vulnerability in the WebVPN feature of Cisco Adaptive Security Appliance (ASA) Software and Cisco Firepower Threat Defense (FTD) Software could allow an unauthenticated, remote attacker to cause increased CPU utilization on an affected device. The vulnerability is due to excessive processing load for a specific WebVPN HTTP page request. An attacker could exploit this vulnerability by sending multiple WebVPN HTTP page load requests for a specific URL. A successful exploit could allow the attacker to increase CPU load on the device, resulting in a denial of service (DoS) condition, which could cause traffic to be delayed through the device. |
| Multiple vulnerabilities in the Cisco Firepower System Software Detection Engine could allow an unauthenticated, remote attacker to bypass configured Malware and File Policies for RTF and RAR file types. For more information about these vulnerabilities, see the Details section of this advisory. |
| Multiple vulnerabilities in the Cisco Firepower System Software Detection Engine could allow an unauthenticated, remote attacker to bypass configured Malware and File Policies for RTF and RAR file types. For more information about these vulnerabilities, see the Details section of this advisory. |
| A vulnerability in the Session Initiation Protocol (SIP) inspection module of Cisco Adaptive Security Appliance (ASA) Software and Cisco Firepower Threat Defense (FTD) Software could allow an unauthenticated, remote attacker to cause a denial of service (DoS) condition on an affected device. The vulnerability is due to improper parsing of SIP messages. An attacker could exploit this vulnerability by sending a malicious SIP packet through an affected device. A successful exploit could allow the attacker to trigger an integer underflow, causing the software to try to read unmapped memory and resulting in a crash. |
| A vulnerability in the FTP inspection engine of Cisco Adaptive Security (ASA) Software and Cisco Firepower Threat Defense (FTD) Software could allow an unauthenticated, remote attacker to cause a denial of service (DoS) condition on an affected device. The vulnerability is due to insufficient validation of FTP data. An attacker could exploit this vulnerability by sending malicious FTP traffic through an affected device. A successful exploit could allow the attacker to cause a DoS condition on the affected device. |
| A vulnerability in the WebVPN login process of Cisco Adaptive Security Appliance (ASA) Software and Cisco Firepower Threat Defense (FTD) Software could allow an unauthenticated, remote attacker to cause increased CPU utilization on an affected device. The vulnerability is due to excessive processing load for existing WebVPN login operations. An attacker could exploit this vulnerability by sending multiple WebVPN login requests to the device. A successful exploit could allow the attacker to increase CPU load on the device, resulting in a denial of service (DoS) condition. |
| A vulnerability in the Cisco ASA that could allow a remote attacker to successfully authenticate using the Cisco AnyConnect VPN client if the Secondary Authentication type is LDAP and the password is left blank, providing the primary credentials are correct. The vulnerabilities is due to improper input validation of certain parameters passed to the affected software. An attacker must have the correct primary credentials in order to successfully exploit this vulnerability. |
