| CVE |
Vendors |
Products |
Updated |
CVSS v3.1 |
| A vulnerability in the detection engine of Cisco Firepower System Software could allow an unauthenticated, remote attacker to bypass configured file action policies if an Intelligent Application Bypass (IAB) with a drop percentage threshold is also configured. The vulnerability is due to incorrect counting of the percentage of dropped traffic. An attacker could exploit this vulnerability by sending network traffic to a targeted device. An exploit could allow the attacker to bypass configured file action policies, and traffic that should be dropped could be allowed into the network. Cisco Bug IDs: CSCvf86435. |
| A vulnerability in the IP fragment-handling implementation of Cisco Adaptive Security Appliance (ASA) Software and Cisco Firepower Threat Defense (FTD) Software could allow an unauthenticated, remote attacker to cause a memory leak on an affected device. This memory leak could prevent traffic from being processed through the device, resulting in a denial of service (DoS) condition. The vulnerability is due to improper error handling when specific failures occur during IP fragment reassembly. An attacker could exploit this vulnerability by sending crafted, fragmented IP traffic to a targeted device. A successful exploit could allow the attacker to continuously consume memory on the affected device and eventually impact traffic, resulting in a DoS condition. The device could require a manual reboot to recover from the DoS condition. Note: This vulnerability applies to both IP Version 4 (IPv4) and IP Version 6 (IPv6) traffic. |
| A vulnerability in the detection engine of Cisco Firepower Threat Defense software could allow an unauthenticated, remote attacker to bypass a configured Secure Sockets Layer (SSL) Access Control (AC) policy to block SSL traffic. The vulnerability is due to the incorrect handling of TCP SSL packets received out of order. An attacker could exploit this vulnerability by sending a crafted SSL connection through the affected device. A successful exploit could allow the attacker to bypass a configured SSL AC policy to block SSL traffic. Cisco Bug IDs: CSCvg09316. |
| A vulnerability in the Sourcefire tunnel control channel protocol in Cisco Firepower System Software running on Cisco Firepower Threat Defense (FTD) sensors could allow an authenticated, local attacker to execute specific CLI commands with root privileges on the Cisco Firepower Management Center (FMC), or through Cisco FMC on other Firepower sensors and devices that are controlled by the same Cisco FMC. To send the commands, the attacker must have root privileges for at least one affected sensor or the Cisco FMC. The vulnerability exists because the affected software performs insufficient checks for certain CLI commands, if the commands are executed via a Sourcefire tunnel connection. An attacker could exploit this vulnerability by authenticating with root privileges to a Firepower sensor or Cisco FMC, and then sending specific CLI commands to the Cisco FMC or through the Cisco FMC to another Firepower sensor via the Sourcefire tunnel connection. A successful exploit could allow the attacker to modify device configurations or delete files on the device that is running Cisco FMC Software or on any Firepower device that is managed by Cisco FMC. |
| A vulnerability in the per-user-override feature of Cisco Adaptive Security Appliance (ASA) Software and Cisco Firepower Threat Defense (FTD) Software could allow an unauthenticated, remote attacker to bypass an access control list (ACL) that is configured for an interface of an affected device. The vulnerability is due to errors that could occur when the affected software constructs and applies per-user-override rules. An attacker could exploit this vulnerability by connecting to a network through an affected device that has a vulnerable configuration. A successful exploit could allow the attacker to access resources that are behind the affected device and would typically be protected by the interface ACL. |
| Multiple vulnerabilities in the payload inspection for Ethernet Industrial Protocol (ENIP) traffic for Cisco Firepower Threat Defense (FTD) Software could allow an unauthenticated, remote attacker to bypass configured rules for ENIP traffic. These vulnerabilities are due to incomplete processing during deep packet inspection for ENIP packets. An attacker could exploit these vulnerabilities by sending a crafted ENIP packet to the targeted interface. A successful exploit could allow the attacker to bypass configured access control and intrusion policies that should be activated for the ENIP packet. |
| A vulnerability in the processing of SSH connections for multi-instance deployments of Cisco Firepower Threat Defense (FTD) Software could allow an unauthenticated, remote attacker to cause a denial of service (DoS) condition on the affected device. This vulnerability is due to a lack of proper error handling when an SSH session fails to be established. An attacker could exploit this vulnerability by sending a high rate of crafted SSH connections to the instance. A successful exploit could allow the attacker to cause resource exhaustion, which causes a DoS condition on the affected device. The device must be manually reloaded to recover. |
| A vulnerability in the software-based SSL/TLS message handler of Cisco Adaptive Security Appliance (ASA) Software and Firepower Threat Defense (FTD) Software could allow an unauthenticated, remote attacker to cause an affected device to reload, resulting in a denial of service (DoS) condition. This vulnerability is due to insufficient validation of SSL/TLS messages when the device performs software-based SSL/TLS decryption. An attacker could exploit this vulnerability by sending a crafted SSL/TLS message to an affected device. A successful exploit could allow the attacker to cause the affected device to reload, resulting in a DoS condition. Note: Datagram TLS (DTLS) messages cannot be used to exploit this vulnerability. |
| A vulnerability in the memory management of Cisco Adaptive Security Appliance (ASA) Software and Firepower Threat Defense (FTD) Software could allow an unauthenticated, remote attacker to cause a denial of service (DoS) condition on an affected device. This vulnerability is due to improper resource management when connection rates are high. An attacker could exploit this vulnerability by opening a significant number of connections on an affected device. A successful exploit could allow the attacker to cause the device to reload, resulting in a DoS condition. |
| A vulnerability in the Simple Network Management Protocol version 3 (SNMPv3) access control functionality of Cisco Adaptive Security Appliance (ASA) Software and Cisco Firepower Threat Defense (FTD) Software could allow an unauthenticated, remote attacker to query SNMP data. This vulnerability is due to ineffective access control. An attacker could exploit this vulnerability by sending an SNMPv3 query to an affected device from a host that is not permitted by the SNMPv3 access control list. A successful exploit could allow the attacker to send an SNMP query to an affected device and retrieve information from the device. The attacker would need valid credentials to perform the SNMP query. |
| Multiple Cisco products are affected by a vulnerability in Snort rules that could allow an unauthenticated, remote attacker to cause a denial of service (DoS) condition on an affected device.The vulnerability is due to improper handling of the Block with Reset or Interactive Block with Reset actions if a rule is configured without proper constraints. An attacker could exploit this vulnerability by sending a crafted IP packet to the affected device. A successful exploit could allow the attacker to cause through traffic to be dropped. Note: Only products with Snort3 configured and either a rule with Block with Reset or Interactive Block with Reset actions configured are vulnerable. Products configured with Snort2 are not vulnerable. |
| A vulnerability in the inter-device communication mechanisms between devices that are running Cisco Firepower Threat Defense (FTD) Software and devices that are running Cisco Firepower Management (FMC) Software could allow an authenticated, local attacker to execute arbitrary commands with root permissions on the underlying operating system of an affected device.
This vulnerability is due to insufficient validation of user-supplied input. An attacker could exploit this vulnerability by accessing the expert mode of an affected device and submitting specific commands to a connected system. A successful exploit could allow the attacker to execute arbitrary code in the context of an FMC device if the attacker has administrative privileges on an associated FTD device. Alternatively, a successful exploit could allow the attacker to execute arbitrary code in the context of an FTD device if the attacker has administrative privileges on an associated FMC device. |
| A vulnerability in the CLI of Cisco FXOS Software and Cisco UCS Manager Software could allow an authenticated, local attacker to execute arbitrary commands on the underlying operating system (OS). The vulnerability is due to insufficient input validation. An attacker could exploit this vulnerability by including crafted arguments to specific commands. A successful exploit could allow the attacker to execute arbitrary commands on the underlying OS with the privileges of the currently logged-in user for all affected platforms excluding Cisco UCS 6400 Series Fabric Interconnects. On Cisco UCS 6400 Series Fabric Interconnects, the injected commands are executed with root privileges. |
| Multiple vulnerabilities in the WebVPN service of Cisco Adaptive Security Appliance (ASA) Software and Cisco Firepower Threat Defense (FTD) Software could allow an authenticated, remote attacker to conduct a cross-site scripting (XSS) attack against a user of the WebVPN portal of an affected device. The vulnerabilities exist because the software insufficiently validates user-supplied input on an affected device. An attacker could exploit these vulnerabilities by persuading a user of the interface to click a crafted link. A successful exploit could allow the attacker to execute arbitrary script code in the context of the affected interface or access sensitive browser-based information. An attacker would need administrator privileges on the device to exploit these vulnerabilities. |
| A vulnerability in the WebVPN service of Cisco Adaptive Security Appliance (ASA) Software and Cisco Firepower Threat Defense (FTD) Software could allow an authenticated, remote attacker to cause a denial of service (DoS) condition on an affected device. The vulnerability is due to improper management of authenticated sessions in the WebVPN portal. An attacker could exploit this vulnerability by authenticating with valid credentials and accessing a specific URL in the WebVPN portal. A successful exploit could allow the attacker to cause the device to reload, resulting in a temporary DoS condition. |
| IBM Cognos Analytics 12.1.3 GA Version with build number through 12.1.3-2606251736 could allow an attacker to obtain incorrect report summary results or cause report-processing failures due to a race condition in the Agentic AI assistant's concurrent request-handling logic when multiple authenticated users submit report-related tasks simultaneously. |
| Acrobat Reader is affected by a Heap-based Buffer Overflow vulnerability that could result in arbitrary code execution in the context of the current user. Exploitation of this issue requires user interaction in that a victim must open a malicious file. |
| Improper neutralization of special elements used in an os command ('os command injection') in GitHub Copilot and Visual Studio Code allows an unauthorized attacker to elevate privileges locally. |
| In Eclipse OpenJ9 versions up to 0.60, using -Xtrace to trace method arguments can lead to buffer underflow. |
| In the Linux kernel, the following vulnerability has been resolved:
net: qualcomm: rmnet: fix endpoint use-after-free in rmnet_dellink()
rmnet_dellink() removes the endpoint from the hash table with
hlist_del_init_rcu() and then immediately frees it with kfree(). However,
RCU readers on the receive path (rmnet_rx_handler ->
__rmnet_map_ingress_handler) may still hold a reference to the endpoint and
dereference ep->egress_dev after the memory has been freed. The endpoint is
a kmalloc-32 object, and the stale read at offset 8 corresponds to the
egress_dev pointer.
BUG: unable to handle page fault for address: ffffffffde942eef
Oops: 0002 [#1] SMP NOPTI
CPU: 1 UID: 0 PID: 137 Comm: poc_write Not tainted 7.0.0+ #4 PREEMPTLAZY
RIP: 0010:rmnet_vnd_rx_fixup (rmnet_vnd.c:27)
Call Trace:
<TASK>
__rmnet_map_ingress_handler (rmnet_handlers.c:48 rmnet_handlers.c:101)
rmnet_rx_handler (rmnet_handlers.c:129 rmnet_handlers.c:235)
__netif_receive_skb_core.constprop.0 (net/core/dev.c:6096)
__netif_receive_skb_one_core (net/core/dev.c:6208)
netif_receive_skb (net/core/dev.c:6467)
tun_get_user (drivers/net/tun.c:1955)
tun_chr_write_iter (drivers/net/tun.c:2003)
vfs_write (fs/read_write.c:688)
ksys_write (fs/read_write.c:740)
</TASK>
Add an rcu_head field to struct rmnet_endpoint and replace kfree() with
kfree_rcu() so the endpoint memory remains valid through the RCU grace
period. Also remove the rmnet_vnd_dellink() call and inline only the
nr_rmnet_devs decrement, since rmnet_vnd_dellink() would set
ep->egress_dev to NULL during the grace period, creating a data race
with lockless readers. |
