| CVE |
Vendors |
Products |
Updated |
CVSS v3.1 |
| The Itel DAB Gateway (IDGat build c041640a) is vulnerable to Authentication Bypass due to improper JWT validation across devices. Attackers can reuse a valid JWT token obtained from one device to authenticate and gain administrative access to any other device running the same firmware, even if the passwords and networks are different. This allows full compromise of affected devices. |
| The Sound4 IMPACT web-based management interface is vulnerable to Remote Code Execution (RCE) via a malicious firmware update package. The update mechanism fails to validate the integrity of manual.sh, allowing an attacker to inject arbitrary commands by modifying this script and repackaging the firmware. |
| A Use-After-Free vulnerability has been discovered in GRUB's gettext module. This flaw stems from a programming error where the gettext command remains registered in memory after its module is unloaded. An attacker can exploit this condition by invoking the orphaned command, causing the application to access a memory location that is no longer valid. An attacker could exploit this vulnerability to cause grub to crash, leading to a Denial of Service. Possible data integrity or confidentiality compromise is not discarded. |
| A vulnerability has been identified in the GRUB (Grand Unified Bootloader) component. This flaw occurs because the bootloader mishandles string conversion when reading information from a USB device, allowing an attacker to exploit inconsistent length values. A local attacker can connect a maliciously configured USB device during the boot sequence to trigger this issue. A successful exploitation may lead GRUB to crash, leading to a Denial of Service. Data corruption may be also possible, although given the complexity of the exploit the impact is most likely limited. |
| A use-after-free vulnerability has been identified in the GNU GRUB (Grand Unified Bootloader). The flaw occurs because the file-closing process incorrectly retains a memory pointer, leaving an invalid reference to a file system structure. An attacker could exploit this vulnerability to cause grub to crash, leading to a Denial of Service. Possible data integrity or confidentiality compromise is not discarded. |
| A vulnerability has been identified in the GRUB2 bootloader's network module that poses an immediate Denial of Service (DoS) risk. This flaw is a Use-after-Free issue, caused because the net_set_vlan command is not properly unregistered when the network module is unloaded from memory. An attacker who can execute this command can force the system to access memory locations that are no longer valid. Successful exploitation leads directly to system instability, which can result in a complete crash and halt system availability |
| A broken access control (BAC) vulnerability in the web-based management interface could allow an authenticated remote attacker with low privileges to view sensitive information. Successful exploitation of this vulnerability could enable the attacker to disclose sensitive data. |
| Use of Web Browser Cache Containing Sensitive Information vulnerability in Drupal Drupal core allows Exploiting Incorrectly Configured Access Control Security Levels.This issue affects Drupal core: from 8.0.0 before 10.4.9, from 10.5.0 before 10.5.6, from 11.0.0 before 11.1.9, from 11.2.0 before 11.2.8. |
| User Interface (UI) Misrepresentation of Critical Information vulnerability in Drupal Drupal core allows Content Spoofing.This issue affects Drupal core: from 8.0.0 before 10.4.9, from 10.5.0 before 10.5.6, from 11.0.0 before 11.1.9, from 11.2.0 before 11.2.8. |
| Improper Check for Unusual or Exceptional Conditions vulnerability in Drupal Drupal core allows Forceful Browsing.This issue affects Drupal core: from 8.0.0 before 10.4.9, from 10.5.0 before 10.5.6, from 11.0.0 before 11.1.9, from 11.2.0 before 11.2.8. |
| Improper Neutralization of Input During Web Page Generation ("Cross-site Scripting") vulnerability in Drupal Simple multi step form allows Cross-Site Scripting (XSS).This issue affects Simple multi step form: from 0.0.0 before 2.0.0. |
| Authentication Bypass Using an Alternate Path or Channel vulnerability in Drupal Email TFA allows Functionality Bypass.This issue affects Email TFA: from 0.0.0 before 2.0.6. |
| A mongoc_bulk_operation_t may read invalid memory if large options are passed. |
| OpenSSH through 10.0, when common types of DRAM are used, might allow row hammer attacks (for authentication bypass) because the integer value of authenticated in mm_answer_authpassword does not resist flips of a single bit. NOTE: this is applicable to a certain threat model of attacker-victim co-location in which the attacker has user privileges. NOTE: this is disputed by the Supplier, who states "we do not consider it to be the application's responsibility to defend against platform architectural weaknesses." |
| In the Linux kernel, the following vulnerability has been resolved:
rxrpc: Fix irq-disabled in local_bh_enable()
The rxrpc_assess_MTU_size() function calls down into the IP layer to find
out the MTU size for a route. When accepting an incoming call, this is
called from rxrpc_new_incoming_call() which holds interrupts disabled
across the code that calls down to it. Unfortunately, the IP layer uses
local_bh_enable() which, config dependent, throws a warning if IRQs are
enabled:
WARNING: CPU: 1 PID: 5544 at kernel/softirq.c:387 __local_bh_enable_ip+0x43/0xd0
...
RIP: 0010:__local_bh_enable_ip+0x43/0xd0
...
Call Trace:
<TASK>
rt_cache_route+0x7e/0xa0
rt_set_nexthop.isra.0+0x3b3/0x3f0
__mkroute_output+0x43a/0x460
ip_route_output_key_hash+0xf7/0x140
ip_route_output_flow+0x1b/0x90
rxrpc_assess_MTU_size.isra.0+0x2a0/0x590
rxrpc_new_incoming_peer+0x46/0x120
rxrpc_alloc_incoming_call+0x1b1/0x400
rxrpc_new_incoming_call+0x1da/0x5e0
rxrpc_input_packet+0x827/0x900
rxrpc_io_thread+0x403/0xb60
kthread+0x2f7/0x310
ret_from_fork+0x2a/0x230
ret_from_fork_asm+0x1a/0x30
...
hardirqs last enabled at (23): _raw_spin_unlock_irq+0x24/0x50
hardirqs last disabled at (24): _raw_read_lock_irq+0x17/0x70
softirqs last enabled at (0): copy_process+0xc61/0x2730
softirqs last disabled at (25): rt_add_uncached_list+0x3c/0x90
Fix this by moving the call to rxrpc_assess_MTU_size() out of
rxrpc_init_peer() and further up the stack where it can be done without
interrupts disabled.
It shouldn't be a problem for rxrpc_new_incoming_call() to do it after the
locks are dropped as pmtud is going to be performed by the I/O thread - and
we're in the I/O thread at this point. |
| In the Linux kernel, the following vulnerability has been resolved:
rxrpc: Fix recv-recv race of completed call
If a call receives an event (such as incoming data), the call gets placed
on the socket's queue and a thread in recvmsg can be awakened to go and
process it. Once the thread has picked up the call off of the queue,
further events will cause it to be requeued, and once the socket lock is
dropped (recvmsg uses call->user_mutex to allow the socket to be used in
parallel), a second thread can come in and its recvmsg can pop the call off
the socket queue again.
In such a case, the first thread will be receiving stuff from the call and
the second thread will be blocked on call->user_mutex. The first thread
can, at this point, process both the event that it picked call for and the
event that the second thread picked the call for and may see the call
terminate - in which case the call will be "released", decoupling the call
from the user call ID assigned to it (RXRPC_USER_CALL_ID in the control
message).
The first thread will return okay, but then the second thread will wake up
holding the user_mutex and, if it sees that the call has been released by
the first thread, it will BUG thusly:
kernel BUG at net/rxrpc/recvmsg.c:474!
Fix this by just dequeuing the call and ignoring it if it is seen to be
already released. We can't tell userspace about it anyway as the user call
ID has become stale. |
| In the Linux kernel, the following vulnerability has been resolved:
cifs: Fix the smbd_response slab to allow usercopy
The handling of received data in the smbdirect client code involves using
copy_to_iter() to copy data from the smbd_reponse struct's packet trailer
to a folioq buffer provided by netfslib that encapsulates a chunk of
pagecache.
If, however, CONFIG_HARDENED_USERCOPY=y, this will result in the checks
then performed in copy_to_iter() oopsing with something like the following:
CIFS: Attempting to mount //172.31.9.1/test
CIFS: VFS: RDMA transport established
usercopy: Kernel memory exposure attempt detected from SLUB object 'smbd_response_0000000091e24ea1' (offset 81, size 63)!
------------[ cut here ]------------
kernel BUG at mm/usercopy.c:102!
...
RIP: 0010:usercopy_abort+0x6c/0x80
...
Call Trace:
<TASK>
__check_heap_object+0xe3/0x120
__check_object_size+0x4dc/0x6d0
smbd_recv+0x77f/0xfe0 [cifs]
cifs_readv_from_socket+0x276/0x8f0 [cifs]
cifs_read_from_socket+0xcd/0x120 [cifs]
cifs_demultiplex_thread+0x7e9/0x2d50 [cifs]
kthread+0x396/0x830
ret_from_fork+0x2b8/0x3b0
ret_from_fork_asm+0x1a/0x30
The problem is that the smbd_response slab's packet field isn't marked as
being permitted for usercopy.
Fix this by passing parameters to kmem_slab_create() to indicate that
copy_to_iter() is permitted from the packet region of the smbd_response
slab objects, less the header space. |
| In the Linux kernel, the following vulnerability has been resolved:
sched/ext: Prevent update_locked_rq() calls with NULL rq
Avoid invoking update_locked_rq() when the runqueue (rq) pointer is NULL
in the SCX_CALL_OP and SCX_CALL_OP_RET macros.
Previously, calling update_locked_rq(NULL) with preemption enabled could
trigger the following warning:
BUG: using __this_cpu_write() in preemptible [00000000]
This happens because __this_cpu_write() is unsafe to use in preemptible
context.
rq is NULL when an ops invoked from an unlocked context. In such cases, we
don't need to store any rq, since the value should already be NULL
(unlocked). Ensure that update_locked_rq() is only called when rq is
non-NULL, preventing calling __this_cpu_write() on preemptible context. |
| In the Linux kernel, the following vulnerability has been resolved:
mm/damon: fix divide by zero in damon_get_intervals_score()
The current implementation allows having zero size regions with no special
reasons, but damon_get_intervals_score() gets crashed by divide by zero
when the region size is zero.
[ 29.403950] Oops: divide error: 0000 [#1] SMP NOPTI
This patch fixes the bug, but does not disallow zero size regions to keep
the backward compatibility since disallowing zero size regions might be a
breaking change for some users.
In addition, the same crash can happen when intervals_goal.access_bp is
zero so this should be fixed in stable trees as well. |
| In the Linux kernel, the following vulnerability has been resolved:
x86/CPU/AMD: Disable INVLPGB on Zen2
AMD Cyan Skillfish (Family 17h, Model 47h, Stepping 0h) has an issue
that causes system oopses and panics when performing TLB flush using
INVLPGB.
However, the problem is that that machine has misconfigured CPUID and
should not report the INVLPGB bit in the first place. So zap the
kernel's representation of the flag so that nothing gets confused.
[ bp: Massage. ] |
