| CVE |
Vendors |
Products |
Updated |
CVSS v3.1 |
| In the Linux kernel, the following vulnerability has been resolved:
coresight: ultrasoc-smb: Fix OOB write in smb_sync_perf_buffer()
When the SMB sink is used as a perf AUX sink, smb_update_buffer() calls
smb_sync_perf_buffer() to copy hardware trace data into the perf AUX ring
buffer pages. It derives pg_idx = head >> PAGE_SHIFT from @head, which is
handle->head, and indexes dst_pages[pg_idx]. The pg_idx %= nr_pages
normalization is only applied after the first loop iteration.
This leaves the initial page index underived from the buffer size, which
can result in an out-of-bounds write past dst_pages[] when head exceeds
the AUX buffer size.
Normalize head modulo the AUX buffer size before deriving the page index
and offset, mirroring tmc_etr_sync_perf_buffer(). |
| In the Linux kernel, the following vulnerability has been resolved:
ksmbd: require source read access for duplicate extents
FSCTL_DUPLICATE_EXTENTS_TO_FILE passes the source file directly to
vfs_clone_file_range() or vfs_copy_file_range() without checking the SMB
access mask granted to the source handle. A handle opened with attribute
access can consequently be used to copy file contents into an
attacker-readable destination.
Require FILE_READ_DATA on the source handle before either VFS operation,
matching other ksmbd data-copy paths. |
| In the Linux kernel, the following vulnerability has been resolved:
smb: client: mask server-provided mode to 07777 in modefromsid
When modefromsid is active, parse_dacl() applies the server-provided
sub_auth[2] value from the NFS mode SID to cf_mode without masking to
07777. Apply the correct masking, same as in the read path. |
| In the Linux kernel, the following vulnerability has been resolved:
HID: hid-goodix-spi: validate report size to prevent stack buffer overflow
goodix_hid_set_raw_report() builds a protocol frame in a 128-byte stack
buffer (tmp_buf), writing an 11-12 byte header followed by the
caller-supplied report data. The HID core caps report size at
HID_MAX_BUFFER_SIZE (16384) by default, while the driver does not set
hid_ll_driver.max_buffer_size and performs no bounds checking before
copying the payload:
memcpy(tmp_buf + tx_len, buf, len);
A hidraw SET_REPORT ioctl with a report larger than ~116 bytes
overflows the stack buffer.
Add a size check after constructing the header, rejecting reports that
would exceed the buffer capacity.
Discovered by Atuin - Automated Vulnerability Discovery Engine. |
| In the Linux kernel, the following vulnerability has been resolved:
partitions: aix: bound the pp_count scan to the ppe array
aix_partition() reads the physical volume descriptor into a fixed-size
struct pvd and then scans its physical-partition-extent array:
int numpps = be16_to_cpu(pvd->pp_count);
...
for (i = 0; i < numpps; i += 1) {
struct ppe *p = pvd->ppe + i;
...
lp_ix = be16_to_cpu(p->lp_ix);
pvd points at a single kmalloc()'d struct pvd whose ppe[] member holds a
fixed ARRAY_SIZE(pvd->ppe) (1016) entries, but the loop runs up to the
on-disk pp_count. pp_count is an unvalidated __be16 read straight from
the descriptor, so a crafted AIX image with pp_count larger than 1016
drives the loop to read pvd->ppe[i] past the end of the allocation (up
to 65535 entries, ~2 MB out of bounds).
The partition scan runs without mounting anything, when a block device
with a crafted AIX/IBM partition table appears (an attacker-supplied
image attached with losetup -P, or a device auto-scanned by udev), via
msdos_partition() -> aix_partition().
Clamp the scan to the number of entries the ppe[] array can hold. |
| RabbitMQ is a messaging and streaming broker. Prior to 3.13.14, 4.0.19, 4.1.10, and 4.2.5, the rabbitmq_management HTTP API accepts oversized valid JSON bodies on with_decode and direct_request paths because read_complete_body checks the accumulated size before the final chunk but not the final combined size. This issue is fixed in versions 3.13.14, 4.0.19, 4.1.10, and 4.2.5. |
| RabbitMQ is a messaging and streaming broker. Prior to 4.2.6, the RabbitMQ stream listener does not enforce the configured stream frame-size limit while assembling frames during authentication and before Tune negotiation, allowing an unauthenticated remote client to declare oversized frame lengths and consume broker memory in rabbit_stream_core. This issue is fixed in version 4.2.6. |
| RabbitMQ is a messaging and streaming broker. Prior to 3.13.15, 4.0.20, 4.1.11, and 4.2.6, RabbitMQ allows foreign bindings to amq.rabbitmq.reply-to destinations because volatile direct-reply-to queues can be accepted at bind and route time but are missing from Khepri-backed deletion checks, leaving persistent route entries after unbind. This issue is fixed in versions 3.13.15, 4.0.20, 4.1.11, and 4.2.6. |
| Insufficient validation of untrusted input in Linux Toolkit Theming in Google Chrome on Linux prior to 150.0.7871.125 allowed a remote attacker who had compromised the renderer process to potentially perform a sandbox escape via a crafted HTML page. (Chromium security severity: High) |
| Use after free in GPU in Google Chrome on Android prior to 150.0.7871.125 allowed a remote attacker who had compromised the renderer process to potentially perform a sandbox escape via a crafted HTML page. (Chromium security severity: High) |
| IBM Langflow OSS 1.0.0 through 1.10.0 Langflow could allow remote code execution due to incomplete validation enforcement on MCP server configuration files. |
| IBM Langflow OSS 1.0.0 through 1.10.1 Lanflow OSS contains an unauthenticated remote code execution vulnerability in the public flow build endpoint ( /api/v1/build_public_tmp/{flow_id}/flow ). The vulnerability stems from an incomplete denylist in the validate_public_flow_no_code_execution() function that fails to block several code-execution agent components including OpenDsStarAgent, CodeActAgentSmolagents, and CSVAgent. |
| In the Linux kernel, the following vulnerability has been resolved:
bpf: Drop task_to_inode and inet_conn_established from lsm sleepable hooks
bpf_lsm_task_to_inode() is called under rcu_read_lock() and
bpf_lsm_inet_conn_established() is called from softirq context, so
neither hook can be used by sleepable LSM programs. |
| In the Linux kernel, the following vulnerability has been resolved:
mptcp: close TOCTOU race while computing rcv_wnd
The MPTCP output path access locklessly the MPTCP-level ack_seq
in multiple times, using possibly different values for the data_ack
in the DSS option and to compute the announced rcv wnd for the same
packet.
Refactor the cote to avoid inconsistencies which may confuse the
peer. Also ensure that the MPTCP level rcv wnd is updated only when
the egress packet actually contains a DSS ack. |
| In the Linux kernel, the following vulnerability has been resolved:
wifi: mac80211: limit injected antenna index in ieee80211_parse_tx_radiotap
When parsing the radiotap header of an injected frame,
ieee80211_parse_tx_radiotap() uses the IEEE80211_RADIOTAP_ANTENNA value
directly as a shift count:
info->control.antennas |= BIT(*iterator.this_arg);
*iterator.this_arg is an 8-bit value taken straight from the frame
supplied by userspace, so BIT() can be asked to shift by up to 255. That
is undefined behaviour on the unsigned long and is reported by UBSAN:
UBSAN: shift-out-of-bounds in net/mac80211/tx.c:2174:30
shift exponent 235 is too large for 64-bit type 'unsigned long'
Call Trace:
ieee80211_parse_tx_radiotap+0xadb/0x1950 net/mac80211/tx.c:2174
ieee80211_monitor_start_xmit+0xb1f/0x1250 net/mac80211/tx.c:2451
...
packet_sendmsg+0x3eb6/0x50f0 net/packet/af_packet.c:3109
info->control.antennas is a 2-bit bitmap (u8 antennas:2), so only antenna
indices 0 and 1 can ever be represented. Ignore any larger value instead
of shifting out of bounds. |
| In the Linux kernel, the following vulnerability has been resolved:
net: mctp: usb: fix race between urb completion and rx_retry cancellation
It's possible that sequencing between setting ->stopped and cancelling
the rx_retry work (in ndo_stop) could leave us with an urb queued:
T1: ndo_stop T2: rx_retry_work
------------ ----------------
LD: ->stopped => false
ST: ->stopped <= true
usb_kill_urb()
mctp_usb_rx_queue()
usb_submit_urb()
cancel_delayed_work_sync()
That urb completion can then re-schedule rx_retry_work.
Strenghen the sequencing between the stop (preventing another requeue)
and the cancel by updating both atomically under a new rx lock. After
setting ->rx_stopped, and cancelling pending work, we know that the
requeue cannot occur, so all that's left is killing any pending urb. |
| In the Linux kernel, the following vulnerability has been resolved:
arm64: tlb: Flush walk cache when unsharing PMD tables
When huge_pmd_unshare() is called to unshare a PMD table, the
tlb_unshare_pmd_ptdesc() function sets tlb->unshared_tables=true
but the aarch64 tlb_flush() only checked tlb->freed_tables to
determine whether to use TLBF_NONE (vae1is, invalidates walk
cache) or TLBF_NOWALKCACHE (vale1is, leaf-only).
This caused the stale PMD page table entry to remain in the walk cache
after unshare, potentially leading to incorrect page table walks.
Fix by including unshared_tables in the check, so that when
unsharing tables, TLBF_NONE is used and the walk cache is properly
invalidated.
Here is the detailed distinction between vae1is and vale1is:
| Instruction Combination | Actual Invalidation Scope |
| ------------------------ | --------------------------------------------------|
| `VAE1IS` + TTL=`0` | All entries at all levels (full invalidation) |
| `VAE1IS` + TTL=`2` (L2) | Non-leaf at Level 0/1 + leaf at Level 2 |
| `VALE1IS` + TTL=`0` | Leaf entries at all levels (non-leaf not cleared) |
| `VALE1IS` + TTL=`2` (L2) | Leaf entry at Level 2 only | |
| In the Linux kernel, the following vulnerability has been resolved:
drm/gem: fix race between change_handle and handle_delete
drm_gem_change_handle_ioctl leaves the old handle live in the IDR
during the window between spin_unlock(table_lock) and the final
spin_lock(table_lock). A concurrent drm_gem_handle_delete on the old
handle succeeds in this window, decrements handle_count to 0, and frees
the GEM object while the new handle's IDR entry still references it.
NULL the old handle's IDR entry before dropping table_lock so that any
concurrent GEM_CLOSE on the old handle sees NULL and returns -EINVAL.
Restore the old entry on the prime-bookkeeping error path. |
| In the Linux kernel, the following vulnerability has been resolved:
scsi: scsi_transport_fc: Widen FPIN pname walker counter to u32
An adjacent Fibre Channel fabric actor that can deliver an FPIN ELS
frame to an lpfc or qla2xxx Linux initiator can trigger a non-return in
the generic FC transport. This is not a local userspace or IP network
path; the attacker must be able to inject fabric traffic, for example as
a compromised switch or fabric controller, or as a same-zone N_Port on a
fabric that permits source spoofing.
The Link-Integrity and Peer-Congestion FPIN walkers used a u8 loop
counter against the 32-bit on-wire pname_count field, and did not bound
pname_count by the descriptor body already validated by the TLV walker.
A pname_count of 256 therefore wraps the counter and keeps the loop
condition true indefinitely.
Factor the shared pname_list[] walk into one helper, widen the counter
to u32, and clamp pname_count against the entries that fit in the
descriptor body before iterating. |
| In the Linux kernel, the following vulnerability has been resolved:
thunderbolt: property: Reject u32 wrap in tb_property_entry_valid()
entry->value is u32 and entry->length is u16; the sum is performed in
u32 and wraps. A malicious XDomain peer can pick
value = 0xffffff00, length = 0x100 so the sum 0x100000000 wraps to 0
and passes the > block_len check. tb_property_parse() then passes
entry->value to parse_dwdata() as a dword offset into the property
block, reading attacker-directed memory far past the allocation.
For TEXT-typed entries with the "deviceid" or "vendorid" keys this
lands in xd->device_name / xd->vendor_name and is readable back via
the per-XDomain device_name / vendor_name sysfs attributes; the leak
is NUL-bounded (kstrdup() stops at the first zero byte) and
untargeted (the attacker picks a delta, not an absolute address).
DATA-typed entries are parsed into property->value.data but not
generically surfaced to userspace.
Use check_add_overflow() so a wrapped sum is rejected. |
