| CVE |
Vendors |
Products |
Updated |
CVSS v3.1 |
| Release of invalid pointer or reference in Windows Device Association Service allows an authorized attacker to elevate privileges locally. |
| In the Linux kernel, the following vulnerability has been resolved:
orangefs: fix double-free of trailer_buf on readdir copy failure
On a readdir downcall, orangefs_devreq_write_iter() frees
op->downcall.trailer_buf with vfree() when copy_from_iter_full() fails,
but does not clear the pointer before goto Efault. The waiter in
do_readdir() is then woken with a negative status and frees the same
pointer again on its r < 0 path, causing a deterministic double-free.
A client holding /dev/pvfs2-req triggers it by sending a readdir
downcall whose declared trailer_size exceeds the bytes it supplies.
Clear the pointer after freeing so the readdir-side vfree() becomes a
no-op. |
| In the Linux kernel, the following vulnerability has been resolved:
wifi: mt76: mt7925: cancel mlo_pm_work on stop
mt7925 queues mlo_pm_work with a 5 second delay during multi-link
power-save setup and never cancels it on the stop path. If the device is
torn down inside that window, the work outlives the teardown and its timer
fires afterwards, trying to queue onto the workqueue that is already gone:
workqueue: cannot queue mt7925_mlo_pm_work [mt7925_common] on wq phy0
WARNING: kernel/workqueue.c:2283 at __queue_work+0x59/0xa0, CPU#1: swapper/1/0
call_timer_fn+0x2a/0x140
__run_timers+0x203/0x330
run_timer_softirq+0x86/0xf0
mt7921 already has its own stop callback, so add one for mt7925 that
cancels the work before calling mt792x_stop(). mt7925_ops backs both the
PCIe and USB drivers, so this covers both. |
| In the Linux kernel, the following vulnerability has been resolved:
ring-buffer: Free cpu_buffer::free_page with subbuf_order
When sub-buffers use an order greater than 0, cpu_buffer->free_page is
allocated with subbuf_order. Use the correct order for
cpu_buffer->free_page. |
| When initializing an RSA public key from DER or PEM bytes throws an error, the EVP_PKEY* is double-freed: first in the catch block, then in the deinit. This can lead to a crash on future memory allocations. This double-free manifests when BoringSSL cannot decode the public key from the bytes provided. This vulnerability is addressed in swift-crypto version 4.5.1. |
| Privilege escalation due to invalid pointer in the Graphics component. This vulnerability was fixed in Firefox 155, Firefox ESR 115.40, Firefox ESR 140.15, Firefox ESR 153.2, Thunderbird 155, Thunderbird 140.15, and Thunderbird 153.2. |
| There exists a use-after-free vulnerability in the Linux kernel through io_uring and the IORING_OP_SPLICE operation. If IORING_OP_SPLICE is missing the IO_WQ_WORK_FILES flag, which signals that the operation won't use current->nsproxy, so its reference counter is not increased. This assumption is not always true as calling io_splice on specific files will call the get_uts function which will use current->nsproxy leading to invalidly decreasing its reference counter later causing the use-after-free vulnerability. We recommend upgrading to version 5.10.160 or above
|
| A type confusion vulnerability in the iked process of WatchGuard Fireware OS allows a remote unauthenticated attacker to execute arbitrary code by sending specially crafted network traffic. |
| Release of an invalid pointer in the AMD kernel mode driver (KMD) could allow a privileged attacker to create a double free condition potentially leading to arbitrary code execution. |
| In the Linux kernel, the following vulnerability has been resolved:
crypto: qce - fix error path in devm_qce_register_algs
If ops->register_algs() fails, the error path repeatedly calls the same
ops->unregister_algs() from the failed registration. Use the loop index
to unregister the previously registered algorithms instead. |
| In the Linux kernel, the following vulnerability has been resolved:
fbdev: s3fb: fix potential memory leak in s3_pci_probe()
In s3_pci_probe(), the memory allocated for modelist using
fb_videomode_to_modelist() is not freed in subsequent error paths.
Fix that by calling fb_destroy_modelist() |
| In the Linux kernel, the following vulnerability has been resolved:
iommufd: Destroy the pages content after detaching from dmabuf
Sashiko points out this has gotten out of order, the mutex could still be
in use through the dmabuf invalidation callbacks. Don't destroy any of the
pages content until the dmabuf is fully detached. |
| In the Linux kernel, the following vulnerability has been resolved:
um: vector: fix use-after-free in vector_mmsg_rx()
When vector_mmsg_rx() discards a packet whose overlay header fails
verify_header(), it frees the skb and continues the loop:
if (header_check < 0) {
dev_kfree_skb_irq(skb);
vp->estats.rx_encaps_errors++;
continue;
}
The normal and short-packet paths fall through to the bottom of the
loop body, which clears the consumed slot and advances the cursors:
(*skbuff_vector) = NULL;
mmsg_vector++;
skbuff_vector++;
The verify_header() < 0 path skips that via continue, so the freed skb
is left in skbuff_vector[] and the cursors do not advance. The next
iteration reads the same slot, gets the freed skb, and frees it again,
producing a refcount underflow / use-after-free in the RX path.
Discard the slot the same way the other paths do before continuing.
Only transports whose verify_header() can return negative are affected:
GRE and L2TPv3 do so on a cookie/session-id mismatch (raw/tap do not),
so any peer on such a transport can trigger it without authentication. |
| In the Linux kernel, the following vulnerability has been resolved:
hwmon: (corsair-psu) Stop device IO before calling hid_hw_stop
hid_hw_stop() does not stop the device IO.
This results in a race condition between hid_input_report() and the point
immediately following the execution of hid_device_io_start() within
corsairpsu_probe(). If the probe operation fails after "io start" has
been initiated, this race condition will result in a uaf vulnerability
[1].
CPU0 CPU1
==== ====
corsairpsu_probe()
hid_device_io_start()
... unlock driver_input_lock
hid_hw_stop()
kfree(hidraw) __hid_input_report()
... acquire driver_input_lock
hid_report_raw_event()
hidraw_report_event()
... access hidraw's list_lock // trigger uaf
Consequently, when corsairpsu_probe() fails and hid_hw_stop() needs to
be executed, the io_started flag is first cleared while holding the
driver_input_lock to prevent potential race conditions involving input
reports.
[1]
BUG: KASAN: slab-use-after-free in rt_spin_lock+0x83/0x400 kernel/locking/spinlock_rt.c:56
Call Trace:
hidraw_report_event+0x5d/0x3a0 drivers/hid/hidraw.c:577
hid_report_raw_event+0x311/0x1730 drivers/hid/hid-core.c:2076
__hid_input_report drivers/hid/hid-core.c:2152 [inline]
hid_input_report+0x44e/0x580 drivers/hid/hid-core.c:2174
hid_irq_in+0x47e/0x6d0 drivers/hid/usbhid/hid-core.c:286
__usb_hcd_giveback_urb+0x3b3/0x5e0 drivers/usb/core/hcd.c:1657
dummy_timer+0x8a9/0x47d0 drivers/usb/gadget/udc/dummy_hcd.c:2005
Allocated by task 10:
hidraw_connect+0x57/0x430 drivers/hid/hidraw.c:606
hid_connect+0x5bf/0x19d0 drivers/hid/hid-core.c:2277
hid_hw_start+0xa8/0x120 drivers/hid/hid-core.c:2387
corsairpsu_probe+0xd9/0x3c0 drivers/hwmon/corsair-psu.c:782
Freed by task 10:
hidraw_disconnect+0x4f/0x60 drivers/hid/hidraw.c:662
hid_disconnect drivers/hid/hid-core.c:2362 [inline]
hid_hw_stop+0x101/0x1e0 drivers/hid/hid-core.c:2407
corsairpsu_probe+0x327/0x3c0 drivers/hwmon/corsair-psu.c:826
Fix the problem by calling hid_device_io_stop() before calling
hid_hw_stop().
[groeck: Updated subject and description;
call hid_device_io_stop() only if IO has been started] |
| In the Linux kernel, the following vulnerability has been resolved:
tracing: Fix resource leak on mmiotrace trace_pipe close
The mmiotrace tracer was added May 12th 2008. At that time, resources
created in pipe_open() could not be freed because there was not
pipe_close function pointer of the tracer. The pipe_close function pointer
was added in December 7th, 2009, but the mmiotrace tracer was not updated.
mmio_pipe_open() allocates a header_iter and takes a pci_dev reference
when trace_pipe is opened. mmio_close() frees them, but it was only
wired to the tracer's .close callback.
tracing_release_pipe() invokes .pipe_close, not .close, when the
trace_pipe file is released. As a result, closing trace_pipe with the
mmiotrace tracer active leaked the header_iter allocation and left a
stale pci_dev reference.
Set .pipe_close to mmio_close, matching how function_graph wires both
callbacks to the same handler.
Note, if the trace_pipe is read to completion, it will clean up the
resources, but if one were to run:
# head -n 1 /sys/kernel/tracing/trace_pipe
VERSION 20070824
Over and over again, it would trigger a massive leak. |
| Privilege escalation due to invalid pointer in the Graphics component. This vulnerability was fixed in Firefox 154, Firefox ESR 153.1, Thunderbird 154, and Thunderbird 153.1. |
| A double free vulnerability was discovered in the HDF5 library. Processing a crafted HDF5 file containing an oversized chunk size field via h5repack may cause the application to abort due to a double free. |
| In the Linux kernel, the following vulnerability has been resolved:
fuse-uring: make a fuse_req on SQE commit only findable after memcpy
Bad userspace might try to trick us and send commit SQEs request
unique / commit-id of requests that are not even send to
fuse-server (io_uring_cmd_done() not called) yet.
fuse_uring_commit_fetch() ends the fuse request when the ring entry
has a wrong state, but that could have caused a use-after-free
with the memcpy operations in fuse_uring_send_in_task().
In order to avoid such races the call of fuse_uring_add_to_pq()
is moved after the copy operations and just before completing
the io-uring request - malicious userspace cannot find the request
anymore until all prepration work in fuse-client/kernel is completed.
This also moves fuse_uring_add_to_pq() a bit up in the code to
avoid a forward declaration. Also not with a preparation commit,
to make it easier to back port to older kernels. |
| In the Linux kernel, the following vulnerability has been resolved:
netdev: fix double-free in netdev_nl_bind_rx_doit()
Sashiko flags that genlmsg_reply() always consumes the skb.
The error path calls nlmsg_free(rsp) so we can't jump directly
to it. Let's not unbind, just propagate the error to the user.
This is the typical way of handling genlmsg_reply() failures.
They shouldn't happen unless user does something silly like
calling the kernel with an already-full rcvbuf. |
| A memory corruption vulnerability in WatchGuard Fireware OS may allow an unauthenticated attacker to trigger a Denial of Service (DoS) condition in the Mobile User VPN with IKEv2 and the Branch Office VPN using IKEv2 when configured with a dynamic gateway peer. |
