| CVE |
Vendors |
Products |
Updated |
CVSS v3.1 |
| MACsec feature on Juniper Networks Junos OS 15.1X49 prior to 15.1X49-D100 on SRX300 series does not report errors when a secure link can not be established. It falls back to an unencrypted link. This can happen when MACsec is configured on ports that are not capable of MACsec or when a secure link can not be established. This can mislead customers into believing that a link is secure. On SRX 300 series devices, prior to 15.1X49-D100, MACsec was only supported on control and fabric ports of SRX340 and SRX345 devices. SRX300 and and SRX320 did not have any MACsec capable ports. Configuring MACsec on ports that were not MACsec capable would have resulted in this issue. Affected releases are Juniper Networks Junos OS 15.1X49 prior to 15.1X49-D100 on SRX300 series. |
| tcprewrite in tcpreplay before 4.1.2 allows remote attackers to cause a denial of service (segmentation fault) via a large frame, a related issue to CVE-2017-14266. |
| A vulnerability in SMART-SSL Accelerator functionality for Cisco Wide Area Application Services (WAAS) 6.2.1, 6.2.1a, and 6.2.3a could allow an unauthenticated, remote attacker to cause a denial of service (DoS) condition where the WAN optimization could stop functioning while the process restarts. The vulnerability is due to a Secure Sockets Layer/Transport Layer Security (SSL/TLS) alert being incorrectly handled when in a specific SSL/TLS connection state. An attacker could exploit this vulnerability by establishing a SMART-SSL connection through the targeted device. The attacker would then send a crafted stream of SSL/TLS traffic. An exploit could allow the attacker to cause a DoS condition where WAN optimization could stop processing traffic for a short period of time. Cisco Bug IDs: CSCvb71133. |
| A vulnerability in the HTTP remote procedure call (RPC) service of set-top box (STB) receivers manufactured by Cisco for Yes could allow an unauthenticated, remote attacker to cause a denial of service (DoS) condition on an affected device. The vulnerability exists because the firmware of an affected device fails to handle certain XML values that are passed to the HTTP RPC service listening on the local subnet of the device. An attacker could exploit this vulnerability by submitting a malformed request to an affected device. A successful attack could cause the affected device to restart, resulting in a DoS condition. Yes has updated the affected devices with firmware that addresses this vulnerability. Customers are not required to take action. Vulnerable Products: This vulnerability affects YesMaxTotal, YesMax HD, and YesQuattro STB devices. Cisco Bug IDs: CSCvd08812. |
| A vulnerability in the TCP throttling process for the GUI of the Cisco Identity Services Engine (ISE) 2.1(0.474) could allow an unauthenticated, remote attacker to cause a denial of service (DoS) condition on an affected device where the ISE GUI may fail to respond to new or established connection requests. The vulnerability is due to insufficient TCP rate limiting protection on the GUI. An attacker could exploit this vulnerability by sending the affected device a high rate of TCP connections to the GUI. An exploit could allow the attacker to cause the GUI to stop responding while the high rate of connections is in progress. Cisco Bug IDs: CSCvc81803. |
| A vulnerability in the TCP connection handling functionality of Cisco Remote Expert Manager Software 11.0.0 could allow an unauthenticated, remote attacker to disable TCP ports and cause a denial of service (DoS) condition on an affected system. The vulnerability is due to a lack of rate-limiting functionality in the TCP Listen application of the affected software. An attacker could exploit this vulnerability by sending a crafted TCP traffic stream in which specific types of TCP packets are flooded to an affected device, for example a TCP packet stream in which the TCP FIN bit is set in all the TCP packets. A successful exploit could allow the attacker to cause certain TCP listening ports on the affected system to stop accepting incoming connections for a period of time or until the affected device is restarted, resulting in a DoS condition. In addition, system resources, such as CPU and memory, could be exhausted during the attack. Cisco Bug IDs: CSCva29806. |
| A vulnerability in the DNS code of Cisco ASA Software could allow an unauthenticated, remote attacker to cause an affected device to reload or corrupt the information present in the device's local DNS cache. The vulnerability is due to a flaw in handling crafted DNS response messages. An attacker could exploit this vulnerability by triggering a DNS request from the Cisco ASA Software and replying with a crafted response. A successful exploit could cause the device to reload, resulting in a denial of service (DoS) condition or corruption of the local DNS cache information. Note: Only traffic directed to the affected device can be used to exploit this vulnerability. This vulnerability affects Cisco ASA Software configured in routed or transparent firewall mode and single or multiple context mode. This vulnerability can be triggered by IPv4 and IPv6 traffic. This vulnerability affects Cisco ASA Software running on the following products: Cisco ASA 1000V Cloud Firewall, Cisco ASA 5500 Series Adaptive Security Appliances, Cisco ASA 5500-X Series Next-Generation Firewalls, Cisco ASA Services Module for Cisco Catalyst 6500 Series Switches and Cisco 7600 Series Routers, Cisco Adaptive Security Virtual Appliance (ASAv), Cisco Firepower 9300 ASA Security Module, Cisco ISA 3000 Industrial Security Appliance. Fixed versions: 9.1(7.12) 9.2(4.18) 9.4(3.12) 9.5(3.2) 9.6(2.2). Cisco Bug IDs: CSCvb40898. |
| It was discovered that cf-release v231 and lower, Pivotal Cloud Foundry Elastic Runtime 1.5.x versions prior to 1.5.17 and Pivotal Cloud Foundry Elastic Runtime 1.6.x versions prior to 1.6.18 do not properly enforce disk quotas in certain cases. An attacker could use an improper disk quota value to bypass enforcement and consume all the disk on DEAs/CELLs causing a potential denial of service for other applications. |
| A vulnerability in the TCP throttling process for Cisco IoT Field Network Director (IoT-FND) could allow an unauthenticated, remote attacker to cause the system to consume additional memory, eventually forcing the device to restart, aka Memory Exhaustion. The vulnerability is due to insufficient rate-limiting protection. An attacker could exploit this vulnerability by sending a high rate of TCP packets to a specific group of open listening ports on a targeted device. An exploit could allow the attacker to cause the system to consume additional memory. If enough available memory is consumed, the system will restart, creating a temporary denial of service (DoS) condition. The DoS condition will end after the device has finished the restart process. This vulnerability affects the following Cisco products: Connected Grid Network Management System, if running a software release prior to IoT-FND Release 4.0; IoT Field Network Director, if running a software release prior to IoT-FND Release 4.0. Cisco Bug IDs: CSCvc77164. |
| A denial of service vulnerability in Mediaserver could enable an attacker to use a specially crafted file to cause a device hang or reboot. This issue is rated as High due to the possibility of remote denial of service. Product: Android. Versions: 4.4.4. Android ID: A-31833604. |
| The bnep_add_connection function in net/bluetooth/bnep/core.c in the Linux kernel before 3.19 does not ensure that an l2cap socket is available, which allows local users to gain privileges via a crafted application. |
| Huawei Oceanstor 5800 before V300R002C10SPC100 allows remote attackers to cause a denial of service (CPU consumption) via a large number of crafted HTTP packets. |
| A "Cisco Firepower Threat Defense 6.0.0 through 6.2.2 and Cisco ASA with FirePOWER Module Denial of Service" vulnerability in the access control policy of Cisco Firepower System Software could allow an authenticated, remote attacker to cause an affected system to stop inspecting and processing packets, resulting in a denial of service (DoS) condition. The vulnerability is due to improper SSL policy handling by the affected software when packets are passed through the sensing interfaces of an affected system. An attacker could exploit this vulnerability by sending crafted packets through a targeted system. This vulnerability affects Cisco Firepower System Software that is configured with the SSL policy feature. Cisco Bug IDs: CSCvc84361. |
| The freelist-randomization feature in mm/slab.c in the Linux kernel 4.8.x and 4.9.x before 4.9.5 allows local users to cause a denial of service (duplicate freelist entries and system crash) or possibly have unspecified other impact in opportunistic circumstances by leveraging the selection of a large value for a random number. |
| A vulnerability in the Local Packet Transport Services (LPTS) ingress frame-processing functionality of Cisco IOS XR Software could allow an unauthenticated, remote attacker to cause one of the LPTS processes on an affected system to restart unexpectedly, resulting in a brief denial of service (DoS) condition. The vulnerability is due to incomplete LPTS frame validation by the affected software. An attacker could exploit this vulnerability by sending crafted XML requests to the management interface of an affected system. A successful exploit could allow the attacker to cause one of the LPTS processes on the affected system to restart unexpectedly, which would impact LPTS traffic and cause a brief DoS condition while the process restarts. Cisco Bug IDs: CSCvf76332. |
| Node.js was affected by OpenSSL vulnerability CVE-2017-3737 in regards to the use of SSL_read() due to TLS handshake failure. The result was that an active network attacker could send application data to Node.js using the TLS or HTTP2 modules in a way that bypassed TLS authentication and encryption. |
| A vulnerability in the implementation of the direct authentication feature in Cisco Adaptive Security Appliance (ASA) Software could allow an unauthenticated, remote attacker to cause an affected device to unexpectedly reload, resulting in a denial of service (DoS) condition. The vulnerability is due to incomplete input validation of the HTTP header. An attacker could exploit this vulnerability by sending a crafted HTTP request to the local IP address of an affected device. A successful exploit could allow the attacker to cause the affected device to reload. This vulnerability affects Cisco Adaptive Security Appliance (ASA) Software that is running on the following Cisco products: ASA 5500 Series Adaptive Security Appliances, ASA 5500-X Series Next-Generation Firewalls, ASA Services Module for Cisco Catalyst 6500 Series Switches and Cisco 7600 Series Routers, ASA 1000V Cloud Firewall, Adaptive Security Virtual Appliance (ASAv), Firepower 4110 Security Appliance, Firepower 9300 ASA Security Module, ISA 3000 Industrial Security Appliance. Cisco Bug IDs: CSCvd59063. |
| Denial of Service attack when the switch rejects to receive packets from the controller. Component: This vulnerability affects OpenDaylight odl-l2switch-switch, which is the feature responsible for the OpenFlow communication. Version: OpenDaylight versions 3.3 (Lithium-SR3), 3.4 (Lithium-SR4), 4.0 (Beryllium), 4.1 (Beryllium-SR1), 4.2 (Beryllium-SR2), and 4.4 (Beryllium-SR4) are affected by this flaw. Java version is openjdk version 1.8.0_91. |
| The video_usercopy function in drivers/media/video/v4l2-ioctl.c in the Linux kernel before 2.6.39 relies on the count value of a v4l2_ext_controls data structure to determine a kmalloc size, which might allow local users to cause a denial of service (memory consumption) via a large value. |
| The Samsung Exynos fimg2d driver for Android with Exynos 5433, 54xx, or 7420 chipsets allows local users to cause a denial of service (kernel panic) via a crafted ioctl command. The Samsung ID is SVE-2016-6736. |
