| CVE |
Vendors |
Products |
Updated |
CVSS v3.1 |
| In the Linux kernel, the following vulnerability has been resolved:
power: supply: gpio-charger: Fix set charge current limits
Fix set charge current limits for devices which allow to set the lowest
charge current limit to be greater zero. If requested charge current limit
is below lowest limit, the index equals current_limit_map_size which leads
to accessing memory beyond allocated memory. |
| In the Linux kernel, the following vulnerability has been resolved:
nvme-pci: fix freeing of the HMB descriptor table
The HMB descriptor table is sized to the maximum number of descriptors
that could be used for a given device, but __nvme_alloc_host_mem could
break out of the loop earlier on memory allocation failure and end up
using less descriptors than planned for, which leads to an incorrect
size passed to dma_free_coherent.
In practice this was not showing up because the number of descriptors
tends to be low and the dma coherent allocator always allocates and
frees at least a page. |
| In the Linux kernel, the following vulnerability has been resolved:
can: j1939: j1939_session_new(): fix skb reference counting
Since j1939_session_skb_queue() does an extra skb_get() for each new
skb, do the same for the initial one in j1939_session_new() to avoid
refcount underflow.
[mkl: clean up commit message] |
| In the Linux kernel, the following vulnerability has been resolved:
net/ipv6: release expired exception dst cached in socket
Dst objects get leaked in ip6_negative_advice() when this function is
executed for an expired IPv6 route located in the exception table. There
are several conditions that must be fulfilled for the leak to occur:
* an ICMPv6 packet indicating a change of the MTU for the path is received,
resulting in an exception dst being created
* a TCP connection that uses the exception dst for routing packets must
start timing out so that TCP begins retransmissions
* after the exception dst expires, the FIB6 garbage collector must not run
before TCP executes ip6_negative_advice() for the expired exception dst
When TCP executes ip6_negative_advice() for an exception dst that has
expired and if no other socket holds a reference to the exception dst, the
refcount of the exception dst is 2, which corresponds to the increment
made by dst_init() and the increment made by the TCP socket for which the
connection is timing out. The refcount made by the socket is never
released. The refcount of the dst is decremented in sk_dst_reset() but
that decrement is counteracted by a dst_hold() intentionally placed just
before the sk_dst_reset() in ip6_negative_advice(). After
ip6_negative_advice() has finished, there is no other object tied to the
dst. The socket lost its reference stored in sk_dst_cache and the dst is
no longer in the exception table. The exception dst becomes a leaked
object.
As a result of this dst leak, an unbalanced refcount is reported for the
loopback device of a net namespace being destroyed under kernels that do
not contain e5f80fcf869a ("ipv6: give an IPv6 dev to blackhole_netdev"):
unregister_netdevice: waiting for lo to become free. Usage count = 2
Fix the dst leak by removing the dst_hold() in ip6_negative_advice(). The
patch that introduced the dst_hold() in ip6_negative_advice() was
92f1655aa2b22 ("net: fix __dst_negative_advice() race"). But 92f1655aa2b22
merely refactored the code with regards to the dst refcount so the issue
was present even before 92f1655aa2b22. The bug was introduced in
54c1a859efd9f ("ipv6: Don't drop cache route entry unless timer actually
expired.") where the expired cached route is deleted and the sk_dst_cache
member of the socket is set to NULL by calling dst_negative_advice() but
the refcount belonging to the socket is left unbalanced.
The IPv4 version - ipv4_negative_advice() - is not affected by this bug.
When the TCP connection times out ipv4_negative_advice() merely resets the
sk_dst_cache of the socket while decrementing the refcount of the
exception dst. |
| In the Linux kernel, the following vulnerability has been resolved:
soc: qcom: geni-se: fix array underflow in geni_se_clk_tbl_get()
This loop is supposed to break if the frequency returned from
clk_round_rate() is the same as on the previous iteration. However,
that check doesn't make sense on the first iteration through the loop.
It leads to reading before the start of these->clk_perf_tbl[] array. |
| In MIT Kerberos 5 (aka krb5) before 1.21.3, an attacker can cause invalid memory reads during GSS message token handling by sending message tokens with invalid length fields. |
| FreeRDP is a free implementation of the Remote Desktop Protocol (RDP). In versions prior to 2.7.0, NT LAN Manager (NTLM) authentication does not properly abort when someone provides and empty password value. This issue affects FreeRDP based RDP Server implementations. RDP clients are not affected. The vulnerability is patched in FreeRDP 2.7.0. There are currently no known workarounds. |
| A flaw was found in 389-ds-base. If an asterisk is imported as password hashes, either accidentally or maliciously, then instead of being inactive, any password will successfully match during authentication. This flaw allows an attacker to successfully authenticate as a user whose password was disabled. |
| Improper Access Control vulnerability in Apache Commons.
A special BeanIntrospector class was added in version 1.9.2. This can be used to stop attackers from using the declared class property of Java enum objects to get access to the classloader. However this protection was not enabled by default. PropertyUtilsBean (and consequently BeanUtilsBean) now disallows declared class level property access by default.
Releases 1.11.0 and 2.0.0-M2 address a potential security issue when accessing enum properties in an uncontrolled way. If an application using Commons BeanUtils passes property paths from an external source directly to the getProperty() method of PropertyUtilsBean, an attacker can access the enum’s class loader via the “declaredClass” property available on all Java “enum” objects. Accessing the enum’s “declaredClass” allows remote attackers to access the ClassLoader and execute arbitrary code. The same issue exists with PropertyUtilsBean.getNestedProperty().
Starting in versions 1.11.0 and 2.0.0-M2 a special BeanIntrospector suppresses the “declaredClass” property. Note that this new BeanIntrospector is enabled by default, but you can disable it to regain the old behavior; see section 2.5 of the user's guide and the unit tests.
This issue affects Apache Commons BeanUtils 1.x before 1.11.0, and 2.x before 2.0.0-M2.Users of the artifact commons-beanutils:commons-beanutils
1.x are recommended to upgrade to version 1.11.0, which fixes the issue.
Users of the artifact org.apache.commons:commons-beanutils2
2.x are recommended to upgrade to version 2.0.0-M2, which fixes the issue. |
| In the Linux kernel, the following vulnerability has been resolved:
blk-cgroup: Fix class @block_class's subsystem refcount leakage
blkcg_fill_root_iostats() iterates over @block_class's devices by
class_dev_iter_(init|next)(), but does not end iterating with
class_dev_iter_exit(), so causes the class's subsystem refcount leakage.
Fix by ending the iterating with class_dev_iter_exit(). |
| Improper sanitization of the value of the [srcset] attribute in <source> HTML elements in AngularJS allows attackers to bypass common image source restrictions, which can also lead to a form of Content Spoofing https://owasp.org/www-community/attacks/Content_Spoofing .
This issue affects all versions of AngularJS.
Note:
The AngularJS project is End-of-Life and will not receive any updates to address this issue. For more information see here https://docs.angularjs.org/misc/version-support-status . |
| Improper sanitization of the value of the 'srcset' attribute in AngularJS allows attackers to bypass common image source restrictions, which can also lead to a form of Content Spoofing https://owasp.org/www-community/attacks/Content_Spoofing .
This issue affects AngularJS versions 1.3.0-rc.4 and greater.
Note:
The AngularJS project is End-of-Life and will not receive any updates to address this issue. For more information see here https://docs.angularjs.org/misc/version-support-status . |
| In the Linux kernel, the following vulnerability has been resolved:
drm/v3d: Stop active perfmon if it is being destroyed
If the active performance monitor (`v3d->active_perfmon`) is being
destroyed, stop it first. Currently, the active perfmon is not
stopped during destruction, leaving the `v3d->active_perfmon` pointer
stale. This can lead to undefined behavior and instability.
This patch ensures that the active perfmon is stopped before being
destroyed, aligning with the behavior introduced in commit
7d1fd3638ee3 ("drm/v3d: Stop the active perfmon before being destroyed"). |
| In the Linux kernel, the following vulnerability has been resolved:
btrfs: don't BUG_ON() when 0 reference count at btrfs_lookup_extent_info()
Instead of doing a BUG_ON() handle the error by returning -EUCLEAN,
aborting the transaction and logging an error message. |
| The OWASP ModSecurity Core Rule Set (CRS) is affected by a partial rule set bypass by submitting a specially crafted HTTP Content-Type header field that indicates multiple character encoding schemes. A vulnerable back-end can potentially be exploited by declaring multiple Content-Type "charset" names and therefore bypassing the configurable CRS Content-Type header "charset" allow list. An encoded payload can bypass CRS detection this way and may then be decoded by the backend. The legacy CRS versions 3.0.x and 3.1.x are affected, as well as the currently supported versions 3.2.1 and 3.3.2. Integrators and users are advised to upgrade to 3.2.2 and 3.3.3 respectively. |
| In Poppler 22.07.0, PDFDoc::savePageAs in PDFDoc.c callows attackers to cause a denial-of-service (application crashes with SIGABRT) by crafting a PDF file in which the xref data structure is mishandled in getCatalog processing. Note that this vulnerability is caused by the incomplete patch of CVE-2018-20662. |
| ESAPI (The OWASP Enterprise Security API) is a free, open source, web application security control library. Prior to version 2.3.0.0, there is a potential for a cross-site scripting vulnerability in ESAPI caused by a incorrect regular expression for "onsiteURL" in the **antisamy-esapi.xml** configuration file that can cause "javascript:" URLs to fail to be correctly sanitized. This issue is patched in ESAPI 2.3.0.0. As a workaround, manually edit the **antisamy-esapi.xml** configuration files to change the "onsiteURL" regular expression. More information about remediation of the vulnerability, including the workaround, is available in the maintainers' release notes and security bulletin. |
| The 17046 Ethernet card before 94450214LFMT100SEM-L.R3-CL for the GE Digital Energy Hydran M2 does not properly generate random values for TCP Initial Sequence Numbers (ISNs), which makes it easier for remote attackers to spoof packets by predicting these values. |
| ServiceNow has addressed an input validation vulnerability that was identified in Vancouver and Washington DC Now Platform releases. This vulnerability could enable an unauthenticated user to remotely execute code within the context of the Now Platform. ServiceNow applied an update to hosted instances, and ServiceNow released the update to our partners and self-hosted customers. Listed below are the patches and hot fixes that address the vulnerability. If you have not done so already, we recommend applying security patches relevant to your instance as soon as possible. |
| In the Linux kernel, the following vulnerability has been resolved:
mm: hugetlb: independent PMD page table shared count
The folio refcount may be increased unexpectly through try_get_folio() by
caller such as split_huge_pages. In huge_pmd_unshare(), we use refcount
to check whether a pmd page table is shared. The check is incorrect if
the refcount is increased by the above caller, and this can cause the page
table leaked:
BUG: Bad page state in process sh pfn:109324
page: refcount:0 mapcount:0 mapping:0000000000000000 index:0x66 pfn:0x109324
flags: 0x17ffff800000000(node=0|zone=2|lastcpupid=0xfffff)
page_type: f2(table)
raw: 017ffff800000000 0000000000000000 0000000000000000 0000000000000000
raw: 0000000000000066 0000000000000000 00000000f2000000 0000000000000000
page dumped because: nonzero mapcount
...
CPU: 31 UID: 0 PID: 7515 Comm: sh Kdump: loaded Tainted: G B 6.13.0-rc2master+ #7
Tainted: [B]=BAD_PAGE
Hardware name: QEMU KVM Virtual Machine, BIOS 0.0.0 02/06/2015
Call trace:
show_stack+0x20/0x38 (C)
dump_stack_lvl+0x80/0xf8
dump_stack+0x18/0x28
bad_page+0x8c/0x130
free_page_is_bad_report+0xa4/0xb0
free_unref_page+0x3cc/0x620
__folio_put+0xf4/0x158
split_huge_pages_all+0x1e0/0x3e8
split_huge_pages_write+0x25c/0x2d8
full_proxy_write+0x64/0xd8
vfs_write+0xcc/0x280
ksys_write+0x70/0x110
__arm64_sys_write+0x24/0x38
invoke_syscall+0x50/0x120
el0_svc_common.constprop.0+0xc8/0xf0
do_el0_svc+0x24/0x38
el0_svc+0x34/0x128
el0t_64_sync_handler+0xc8/0xd0
el0t_64_sync+0x190/0x198
The issue may be triggered by damon, offline_page, page_idle, etc, which
will increase the refcount of page table.
1. The page table itself will be discarded after reporting the
"nonzero mapcount".
2. The HugeTLB page mapped by the page table miss freeing since we
treat the page table as shared and a shared page table will not be
unmapped.
Fix it by introducing independent PMD page table shared count. As
described by comment, pt_index/pt_mm/pt_frag_refcount are used for s390
gmap, x86 pgds and powerpc, pt_share_count is used for x86/arm64/riscv
pmds, so we can reuse the field as pt_share_count. |
