| CVE |
Vendors |
Products |
Updated |
CVSS v3.1 |
| The administrator password can be changed without knowledge of the current password. When chained with an authentication bypass vulnerability, this issue may allow unauthenticated attackers to modify the administrator password. |
| In the Linux kernel, the following vulnerability has been resolved:
mshv: Order pt_vp_array publish against irqfd assertion path
mshv_partition_ioctl_create_vp() initialises a VP struct (allocations,
mutex_init, init_waitqueue_head, page mappings) and then publishes the
pointer into partition->pt_vp_array. Several ISR paths read this array
locklessly: the intercept ISR, the two scheduler ISRs, and
mshv_try_assert_irq_fast() on the irqfd fast path.
Of these, only mshv_try_assert_irq_fast() can structurally race the
publish. It runs from an eventfd waker without holding pt_mutex, and
MSHV_IRQFD does not require the target lapic_apic_id (== vp_index) to
refer to an existing VP at registration time. A user can therefore
register an irqfd targeting a yet-to-be-created VP, then trigger
mshv_try_assert_irq_fast() concurrently with MSHV_CREATE_VP for the
same index. On weakly-ordered architectures the reader can observe a
non-NULL pointer in pt_vp_array before the initialising stores to the
VP struct become visible, leading to use of partially-initialised
fields (e.g. vp_register_page).
The other ISR readers cannot reach this race: the hypervisor will not
generate intercept or scheduler messages for a VP that has never been
told to run, and the user can only call MSHV_RUN_VP on the VP fd
returned by MSHV_CREATE_VP, which by construction is returned after
the publish. Leave those readers as plain loads.
Use smp_store_release() in mshv_partition_ioctl_create_vp() to publish
the pointer, and pair it with smp_load_acquire() in
mshv_try_assert_irq_fast(). On x86 these compile to plain accesses
under TSO; on ARM64 they emit one-instruction acquire/release barriers,
acceptable on this fast path.
The destroy-side path (destroy_partition() clearing pt_vp_array[i] to
NULL after kfree(vp)) has a separate ordering and lifetime concern
that is out of scope here. |
| In the Linux kernel, the following vulnerability has been resolved:
erofs: remove fscache backend entirely
EROFS over fscache was introduced to provide image lazy pulling
functionality. After the feature landed, the fscache subsystem made
netfs a new hard dependency, which is unexpected for a local filesystem
and has an kernel-defined caching hierarchy which could be inflexible
compared to the fanotify pre-content hooks. Therefore, this feature has
been deprecated for almost two years.
As EROFS file-backed mounts and fanotify pre-content hooks both upstream
for a while and already providing equivalent functionality (erofs-utils
has supported fanotify pre-content hooks), let's remove the fscache
backend now.
The main application of this feature is Nydus [1], and they plan to move
to use fanotify pre-content hooks in the near future too.
I hope this patch can be merged into Linux 7.2, which is also motivated
by newly found implementation issues [2][3] that are not worth
investigating given the deprecation and limited development resources.
The associated fscache/cachefiles cleanup patch will follow separately
through the vfs tree (netfs) later: it seems fine since the codebase is
isolated by CONFIG_CACHEFILES_ONDEMAND.
[1] https://github.com/dragonflyoss/nydus/blob/v2.1.0/docs/nydus-fscache.md
[2] https://github.com/dragonflyoss/nydus/pull/1824
[3] https://lore.kernel.org/r/20260619135800.1594811-1-michael.bommarito@gmail.com |
| llama.cpp b5693 and before is vulnerable to Uncontrolled Recursion in common/json-schema-to-grammar.cpp, resulting in a denial of service. |
| llama.cpp b5693 and before has a Reachable Assertion via the gguf_reader::read function. |
| Authorization Bypass Through User-Controlled Key (CWE-639) in Fleet Server can lead to information disclosure via Manipulating User-Controlled Variables (CAPEC-77). The authorization decision for artifact downloads relied on a client-supplied value that was persisted without being validated against the server-side record of the requesting agent's assignment. An authenticated party in possession of a valid enrolled agent credential could therefore retrieve a policy the agent is not assigned to. |
| llama.cpp through commit 97f06e9, when started with the --reranking flag, allows remote attackers to cause a denial of service (std::bad_alloc and HTTP 500) via a negative top_n value in a POST request to /rerank. |
| Analyzing a PDF with a deeply nested or cyclic table of contents can cause a StackOverflowError in the ingestion thread.
Spring AI 2.0.0
Spring AI 1.1.0 - 1.1.8
Spring AI 1.0.0 - 1.0.9 |
| In the Linux kernel, the following vulnerability has been resolved:
net/tls: Fail tls_sw_splice_read() after a failed async decrypt
When an async decrypt fails, tls_decrypt_done() records the error in
ctx->async_wait.err and calls tls_err_abort(), which stores it in
sk_err. tls_sw_recvmsg() and tls_sw_read_sock() each read
async_wait.err once they hold the reader lock and fail the call: a
record that did not authenticate breaks the connection.
tls_sw_splice_read() has no such check, and sk_err does not stand in
for one. tls_rx_rec_wait() tests sk_err only inside the loop it
skips whenever a record is already parsed, and the first reader to
reach sock_error() clears it, while async_wait.err persists. A
splice therefore keeps delivering records on a connection that
recvmsg() and read_sock() refuse to read.
Read async_wait.err in tls_sw_splice_read() as the other two readers
do. |
| In the Linux kernel, the following vulnerability has been resolved:
xfrm: espintcp: fix UAF during close
ZDI reported and analyzed a race condition during close for espintcp
sockets:
espintcp_close() frees emsg->skb via kfree_skb() without holding
any socket lock. Concurrently, the xfrm_trans_reinject work queue
invokes esp_output_tcp_finish() -> espintcp_push_skb() ->
espintcp_push_msgs() -> skb_send_sock_locked(), which reads the
same skb as a data source.
Fix this by adding a synchronize_rcu() call after resetting sk_prot,
since esp_output_tcp_finish() runs under RCU and won't use a socket
with sk_prot == &tcp_prot. Simply taking the socket lock in
espintcp_close() could lead to leaks, if esp_output_tcp_finish()
re-adds an skb in the slot we just freed. After this, the existing
barrier() is no longer needed. |
| In the Linux kernel, the following vulnerability has been resolved:
fuse: fix invalidate lock leak on open O_TRUNC DAX failure
fuse_open() takes filemap_invalidate_lock() for a DAX truncate
(dax_truncate = true) and releases it before the out_inode_unlock
label. But when fuse_dax_break_layouts() fails, the goto
out_inode_unlock skips the unlock and leaks the rwsem, so any later
fault or truncate on the file stalls on the stale lock.
fuse_dax_break_layouts() can fail with -ERESTARTSYS when a signal
interrupts the wait for busy DAX pages to drain:
open("file", O_RDWR | O_TRUNC)
└─ fuse_open()
├─ filemap_invalidate_lock() # dax_truncate
└─ fuse_dax_break_layouts()
└─ dax_break_layout()
└─ wait_page_idle() # TASK_INTERRUPTIBLE
└─ fuse_wait_dax_page() # unlock, schedule, re-lock
└─ signal → -ERESTARTSYS
goto out_inode_unlock # <- lock leaked
Fix this by moving filemap_invalidate_unlock() below the label so
that all error paths release the lock, and rename the label to
out_unlock as it now covers more than just the inode lock. |
| Partition interceptor may be improperly added while sending message.
Spring Cloud Stream 5.0.0 - 5.0.2
Spring Cloud Stream 4.3.0 - 4.3.3
Spring Cloud Stream 4.2.0 - 4.2.6 |
| Authorization Bypass Through User-Controlled Key vulnerability in sc Internet Vivoo WP Rentals allows Exploiting Incorrectly Configured Access Control Security Levels.
This issue affects WP Rentals: from n/a before 3.16.0. |
| In the Linux kernel, the following vulnerability has been resolved:
crypto: mxs-dcp - fix source scatterlist length access
mxs_dcp_aes_block_crypt() uses sg_dma_len() without mapping the source
scatterlist with dma_map_sg() first. Therefore, sg_dma_len() is invalid
and could return zero or a stale DMA length, causing encryption and
decryption to process the wrong number of bytes when
CONFIG_NEED_SG_DMA_LENGTH=y.
Use the original scatterlist length instead. |
| In the Linux kernel, the following vulnerability has been resolved:
io_uring/rsrc: fix folio size overflow in io_vec_fill_bvec()
io_vec_fill_bvec() computes the folio size with a plain int 1:
unsigned long folio_size = 1 << imu->folio_shift;
imu->folio_shift is unsigned int and comes from folio_shift() of the
folio backing the registered buffer, so it can be 32 or more on a 64 bit
kernel. Shifting int 1 that far is undefined, and on x86 and arm64 the
count is taken modulo 32, so a shift of 34 yields 4 rather than 16G.
Every other folio_shift shift in this file already uses 1UL.
The result is that the segment estimate and the fill loop disagree.
io_estimate_bvec_size() sizes the bvec array with the real shift:
max_segs += (iov[i].iov_len >> shift) + 2;
so a 1M iovec on a 16G folio is charged 2 segments, while
io_vec_fill_bvec() then walks the same iovec in folio_size chunks of 4
bytes and writes res_bvec[bvec_idx] a quarter of a million times, past
the end of the array it was given. src_bvec is advanced once per
iteration as well, so imu->bvec is read past its end at the same time.
validate_fixed_range() only checks that the range is inside the
registered buffer and does not bound the segment count.
Reaching it needs a folio with a shift of at least 32, which means a
gigantic hugetlb page: 16G on arm64 with 64K pages, where
CONT_PMD_SHIFT is 34 and hugetlb_add_hstate(CONT_PMD_SHIFT - PAGE_SHIFT)
registers that size, and likewise on powerpc. x86_64 tops out at 1G, so
a shift of 30, which still fits in int and is unaffected.
Use 1UL, as the rest of the file does. |
| Jaxp13XPathTemplate evaluated XPath expressions for StreamSource and SAXSource inputs using a code path that parsed attacker-controlled XML with the JDK's default DocumentBuilderFactory behavior instead of Spring's hardened parser configuration. Applications that evaluate XPath against untrusted XML payloads could therefore be exposed to XML External Entity (XXE) style attacks.
Affected versions:
Spring Web Services 5.0.0 through 5.0.1; 4.1.0 through 4.1.3; 4.0.0 through 4.0.18; 3.1.0 through 3.1.8. |
| (Holloway) Chew, Kean Ho's Actualizer v1.2.0 and earlier contains a fail-open password validation vulnerability in the Alpha user and root user password loops of Shell/debian-minbase-install.sh. The installer invokes mkpasswd to generate yescrypt password hashes but does not check the command's return value and unconditionally accepts the result. If mkpasswd fails to generate a yescrypt hash, for example because an incompatible mkpasswd implementation or an environment without yescrypt support is used, the resulting password hash variable can be empty and the build proceeds. The resulting image can therefore contain empty password fields for the root and alpha accounts, potentially permitting passwordless authentication depending on the authentication configuration. |
| Blinko 1.8.7 contains a cross-user private note disclosure vulnerability in the noteReferenceList procedure that performs no ownership verification on supplied note identifiers. Authenticated attackers can enumerate sequential note IDs and retrieve complete content of other users' private notes including attachments and tags. |
| Snipe-IT versions before 8.6.2 contain an authorization bypass vulnerability in checkout-acceptance report actions when Full Multiple Company Support is enabled. Authenticated users with reports.view permission can enumerate sequential acceptance IDs and soft-delete or trigger reminder emails for acceptances belonging to other companies by exploiting a null check on the legacy users.company_id column. |
| In the Linux kernel, the following vulnerability has been resolved:
HID: magicmouse: prevent unbounded recursion in magicmouse_raw_event()
magicmouse_raw_event() handles DOUBLE_REPORT_ID (0xf7) packets, which pack
two touch reports into one, by splitting the packet and calling itself on
each half. The only guard against runaway recursion is a "size < 1" check,
which stops zero-sized calls but does not bound the recursion depth.
A malicious HID device that matches this driver can send a report starting
with DOUBLE_REPORT_ID and filled with the sequence [0xf7, 0x00]. Each level
consumes two bytes and recurses on the remainder, so an incoming report of
up to HID_MAX_BUFFER_SIZE (16 KiB) drives roughly 8000 nested calls. That
easily exhausts the 16 KiB kernel stack, leading to a stack overflow: a
panic with CONFIG_VMAP_STACK, or memory corruption without it.
A double report only ever wraps two normal reports; it is never
legitimately nested. Refuse to re-enter the DOUBLE_REPORT_ID case from a
recursive call so the recursion depth is bounded to two, while all valid
packets keep being parsed exactly as before. |
