CVE-2026-99346

KVM: SVM: Trigger new ASID allocation in both VMCBs on pCPU switch

Published Nov 19, 2026 CVSS n/a EPSS n/a KEV · Not listed
Description
In the Linux kernel, the following vulnerability has been resolved:

KVM: SVM: Trigger new ASID allocation in both VMCBs on pCPU switch

When the pCPU where the VMCB was most recently used is switched, reset
the ASID generation in both VMCBs, triggering new ASID allocation for
the immediate VMRUN as well as the next VMRUN on the other VMCB.

The ASID is shared between vmcb01 and vmcb02, and gets flushed on every
nested transition. However, since pCPU tracking is done per VMCB, it is
possible for one VMCB to allocate a new ASID when migrated to a new
pCPU, and then the other VMCB reuses that ASID on the old pCPU. This can
result in the same ASID being used by multiple vCPUs on the old pCPU.

Example scenario:
- vCPU runs on pCPU A, vmcb01 is active, asid=1.
- vCPU migrates to pCPU B, vmcb01 pCPU changes, new asid=2.
- Another vCPU runs on pCPU A and allocates asid=2 as well.
- vCPU migrates back to pCPU A, and then switches to vmcb02 before it
runs again with vmcb01.
- No pCPU switch is detected for vmcb02, so VMRUN is done with asid=2.
- Two vCPUs end up using asid=2 on the same pCPU.

Keep the VMCB dirtying to the active VMCB only. Clean bits are tracked
by a pCPU for each VMCB, so do not unnecessarily dirty a VMCB if its
pCPU does not change.

Additionally, initialize the tracked pCPU for vmcb02 to -1 on nested
enablement as hardening, so that a new ASID allocation is always
triggered when nested is disabled and re-enabled.

No performance regression was noticed when overcommitting L1 vCPUs in L0
(to force rescheduling), pinning L1 <-> L2 vCPUs, and running CPUID in a
tight loop bouncing between 2 vCPUs in L2.

An alternative (and perhaps more proper) fix would be tracking the ASID
per-VMCB instead (e.g. [1]). However, that's a more involved change, and
it would result in having different ASIDs for L1 and L2 without actually
properly maintaining them. It would probably work because all TLB
flushes target the current VMCB, and the other VMCB is always flushed on
nested transitions, but the code ends up in an arguably more fragile
state. Punt a proper clean fix to an incoming (and overdue) overhaul of
SVM's ASID usage [2].

[1] https://lore.kernel.org/lkml/20250205182402.2147495-2-yosry.ahmed@linux.dev
[2] https://lore.kernel.org/kvm/20260728003557.1136583-1-yosry@kernel.org

Analysis

No analysis available yet

Remediation

No remediation available yet

Tracking

Sign in to view the affected projects.

Advisories

No advisories available
History
Type Values Removed Values Added
Description In the Linux kernel, the following vulnerability has been resolved: KVM: SVM: Trigger new ASID allocation in both VMCBs on pCPU switch When the pCPU where the VMCB was most recently used is switched, reset the ASID generation in both VMCBs, triggering new ASID allocation for the immediate VMRUN as well as the next VMRUN on the other VMCB. The ASID is shared between vmcb01 and vmcb02, and gets flushed on every nested transition. However, since pCPU tracking is done per VMCB, it is possible for one VMCB to allocate a new ASID when migrated to a new pCPU, and then the other VMCB reuses that ASID on the old pCPU. This can result in the same ASID being used by multiple vCPUs on the old pCPU. Example scenario: - vCPU runs on pCPU A, vmcb01 is active, asid=1. - vCPU migrates to pCPU B, vmcb01 pCPU changes, new asid=2. - Another vCPU runs on pCPU A and allocates asid=2 as well. - vCPU migrates back to pCPU A, and then switches to vmcb02 before it runs again with vmcb01. - No pCPU switch is detected for vmcb02, so VMRUN is done with asid=2. - Two vCPUs end up using asid=2 on the same pCPU. Keep the VMCB dirtying to the active VMCB only. Clean bits are tracked by a pCPU for each VMCB, so do not unnecessarily dirty a VMCB if its pCPU does not change. Additionally, initialize the tracked pCPU for vmcb02 to -1 on nested enablement as hardening, so that a new ASID allocation is always triggered when nested is disabled and re-enabled. No performance regression was noticed when overcommitting L1 vCPUs in L0 (to force rescheduling), pinning L1 <-> L2 vCPUs, and running CPUID in a tight loop bouncing between 2 vCPUs in L2. An alternative (and perhaps more proper) fix would be tracking the ASID per-VMCB instead (e.g. [1]). However, that's a more involved change, and it would result in having different ASIDs for L1 and L2 without actually properly maintaining them. It would probably work because all TLB flushes target the current VMCB, and the other VMCB is always flushed on nested transitions, but the code ends up in an arguably more fragile state. Punt a proper clean fix to an incoming (and overdue) overhaul of SVM's ASID usage [2]. [1] https://lore.kernel.org/lkml/20250205182402.2147495-2-yosry.ahmed@linux.dev [2] https://lore.kernel.org/kvm/20260728003557.1136583-1-yosry@kernel.org
Title KVM: SVM: Trigger new ASID allocation in both VMCBs on pCPU switch
First Time appeared Linux
Linux linux Kernel
CPEs cpe:2.3:o:linux:linux_kernel:*:*:*:*:*:*:*:*
Vendors & Products Linux
Linux linux Kernel
References
Weaknesses

No weakness.

Sources

Status
PUBLISHED
Assigner
Linux
Published
Updated
Nov 19, 2026, 2:36 PM
Reserved
Sep 25, 2026, 10:25 AM
Status
Received
Published
Nov 19, 2026, 3:17 PM
Modified
Nov 19, 2026, 3:17 PM