media: gspca: use vb2_video_unregister_device() on disconnect
Default status is the baseline for the product, each version can override it (e.g. patched versions marked unaffected).
| Vendor | Product | Default status | Versions | |||||||||||||||||||||
|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|
| Linux | Linux | unaffected |
|
|||||||||||||||||||||
| Linux | Linux | affected |
|
No data.
No data.
No data available yet.
No CVSS v4.0
No CVSS v3.1
No CVSS v3.0
No CVSS v2
This CVE is not in the KEV list.
No EPSS score available.
Key SSVC decision points have not yet been added.
| Type | Values Removed | Values Added |
|---|---|---|
| Description | In the Linux kernel, the following vulnerability has been resolved: media: gspca: use vb2_video_unregister_device() on disconnect gspca uses vb2_fop_release(), but gspca_disconnect() only unregisters the video device. If the queue owner closes the device after USB disconnect, vb2_fop_release() releases the queue and invokes gspca_stop_streaming() at that point. gspca_stream_off() calls subdriver stop callbacks and usb_set_interface() through gspca_dev->dev. By the time the late close runs, the USB core can have freed the usb_device, resulting in a use-after-free. This was observed as a KASAN use-after-free in sd_stopN(). Use vb2_video_unregister_device() so the queue is released and streaming is stopped synchronously during disconnect, while the usb_device is still valid. Since the helper takes the queue lock, which is usb_lock, call it after dropping that lock. | |
| Title | media: gspca: use vb2_video_unregister_device() on disconnect | |
| First Time appeared |
Linux
Linux linux Kernel |
|
| CPEs | cpe:2.3:o:linux:linux_kernel:*:*:*:*:*:*:*:* | |
| Vendors & Products |
Linux
Linux linux Kernel |
|
| References |
|
No weakness.