| CVE |
Vendors |
Products |
Updated |
CVSS v3.1 |
| A vulnerability was identified in SourceCodester Class and Exam Timetabling System 1.0. Affected by this issue is some unknown functionality of the file /forCYS.php. Such manipulation of the argument course leads to cross site scripting. The attack may be performed from remote. The exploit is publicly available and might be used. |
| Authentication bypass using an alternate path or channel in Microsoft Edge (Chromium-based) allows an unauthorized attacker to perform tampering over a network. |
| In the Linux kernel, the following vulnerability has been resolved:
hwmon: (pmbus/adm1266) include PEC byte in pmbus_block_xfer read buffer
adm1266_pmbus_block_xfer() sets up the read transaction with
.buf = data->read_buf,
.len = ADM1266_PMBUS_BLOCK_MAX + 2,
but read_buf in struct adm1266_data is declared as
u8 read_buf[ADM1266_PMBUS_BLOCK_MAX + 1];
For a max-length block response (length byte = 255 + up to 1 PEC
byte), the i2c controller is told to write 257 bytes into a 256-byte
buffer, putting one byte past the end of read_buf. The same response
also makes the subsequent PEC compare
if (crc != msgs[1].buf[msgs[1].buf[0] + 1])
read a byte beyond the array.
Bump the read_buf declaration to ADM1266_PMBUS_BLOCK_MAX + 2 so the
buffer can hold the length byte, up to 255 payload bytes, and the PEC
byte the i2c_msg length already accounts for. |
| In the Linux kernel, the following vulnerability has been resolved:
hwmon: (pmbus/adm1266) cap PDIO scan in get_multiple at ADM1266_PDIO_NR
adm1266_gpio_get_multiple() iterates the PDIO portion of the
caller-supplied mask using
for_each_set_bit_from(gpio_nr, mask,
ADM1266_GPIO_NR + ADM1266_PDIO_STATUS) {
...
}
where ADM1266_PDIO_STATUS is the PMBus command code (0xE9, i.e. 233),
not the number of PDIO pins. The intended upper bound is
ADM1266_GPIO_NR + ADM1266_PDIO_NR = 25.
gpiolib hands in a mask sized for gc.ngpio (= 25 bits on this chip),
so the iteration walks find_next_bit() up to 242, reading up to 217
extra bits (a handful of unsigned-long words: four on 64-bit, seven
on 32-bit) of whatever lives past the end of the mask in the
caller's stack. Any incidental set bit in that range then drives a
set_bit(gpio_nr, bits) call that writes past the end of the
caller-supplied bits array too -- both out-of-bounds.
Substitute ADM1266_PDIO_NR for the constant so the scan stops at the
last real PDIO bit. |
| In the Linux kernel, the following vulnerability has been resolved:
firmware: arm_ffa: Snapshot notifier callbacks under lock
Both notification handlers currently look up a notifier callback under
notify_lock, drop the lock, and then dereference the returned
notifier entry. A concurrent unregister can delete and free that
entry in the gap, leaving the handler to dereference stale memory.
Copy the callback pointer and callback data while notify_lock is
still held and invoke the callback only after the lock is dropped.
This keeps the existing callback execution model while removing the
use-after-free window in both the framework and non-framework
notification paths. |
| In the Linux kernel, the following vulnerability has been resolved:
netfilter: x_tables: add and use xtables_unregister_table_exit
Previous change added xtables_unregister_table_pre_exit to detach the
table from the packetpath and to unlink it from the active table list.
In case of rmmod, userspace that is doing set/getsockopt for this table
will not be able to re-instantiate the table:
1. The larval table has been removed already
2. existing instantiated table is no longer on the xt pernet table list.
This adds the second stage helper:
unlink the table from the dying list, free the hook ops (if any) and do
the audit notification. It replaces xt_unregister_table(). |
| In the Linux kernel, the following vulnerability has been resolved:
netfilter: ebtables: move to two-stage removal scheme
Like previous patches for x_tables, follow same pattern in ebtables.
We can't reuse xt helpers: ebt_table struct layout is incompatible.
table->ops assignment is now done while still holding the ebt mutex
to make sure we never expose partially-filled table struct. |
| In the Linux kernel, the following vulnerability has been resolved:
irq_work: Fix use-after-free in irq_work_single() on PREEMPT_RT
On PREEMPT_RT, non-HARD irq_work runs in per-CPU kthreads via
run_irq_workd(), so irq_work_sync() uses rcuwait() to wait for BUSY==0.
After irq_work_single() clears BUSY via atomic_cmpxchg(), it still
dereferences @work for irq_work_is_hard() and rcuwait_wake_up().
An irq_work_sync() caller on another CPU that enters after BUSY is cleared
can observe BUSY==0 immediately, return, and free the work before those
accesses complete — causing a use-after-free.
Fix this by wrapping run_irq_workd() in guard(rcu)() so that the entire
irq_work_single() execution is within an RCU read-side critical
section. Then add synchronize_rcu() in irq_work_sync() after
rcuwait_wait_event() to ensure the caller waits for the RCU grace period
before returning, preventing premature frees. |
| In the Linux kernel, the following vulnerability has been resolved:
netfs: Fix cancellation of a DIO and single read subrequests
When the preparation of a new subrequest for a read fails, if the
subrequest has already been added to the stream->subrequests list, it can't
simply be put and abandoned as the collector may see it. Also, if it
hasn't been queued yet, it has two outstanding refs that both need to be
put. Both DIO read and single-read dispatch fail at this; further, both
differ in the order they do things to the way buffered read works.
Fix cancellation of both DIO-read and single-read subrequests that failed
preparation by the following steps:
(1) Harmonise all three reads (buffered, dio, single) to queue the subreq
before prepping it.
(2) Make all three call netfs_queue_read() to do the queuing.
(3) Set NETFS_RREQ_ALL_QUEUED independently of the queuing as we don't
know the length of the subreq at this point.
(4) In all cases, set the error and NETFS_SREQ_FAILED flag on the subreq
and then call netfs_read_subreq_terminated() to deal with it. This
will pass responsibility off to the collector for dealing with it. |
| A vulnerability was determined in Sipeed PicoClaw up to 0.2.9. The affected element is an unknown function of the file web/backend/api/auth.go. Executing a manipulation can lead to cross-site request forgery. The attack can be launched remotely. The exploit has been publicly disclosed and may be utilized. This patch is called 4b0229351678f479429b8d8b19207757266f246b. Applying a patch is advised to resolve this issue. |
| In the Linux kernel, the following vulnerability has been resolved:
netfs: Fix missing locking around retry adding new subreqs
Fix netfs_retry_read_subrequests() and netfs_retry_write_stream() to take
the appropriate lock when adding extra subrequests into
stream->subrequests. |
| In the Linux kernel, the following vulnerability has been resolved:
netfs: Fix missing barriers when accessing stream->subrequests locklessly
The list of subrequests attached to stream->subrequests is accessed without
locks by netfs_collect_read_results() and netfs_collect_write_results(),
and then they access subreq->flags without taking a barrier after getting
the subreq pointer from the list. Relatedly, the functions that build the
list don't use any sort of write barrier when constructing the list to make
sure that the NETFS_SREQ_IN_PROGRESS flag is perceived to be set first if
no lock is taken.
Fix this by:
(1) Add a new list_add_tail_release() function that uses a release barrier
to set the pointer to the new member of the list.
(2) Add a new list_first_entry_or_null_acquire() function that uses an
acquire barrier to read the pointer to the first member in a list (or
return NULL).
(3) Use list_add_tail_release() when adding a subreq to ->subrequests.
(4) Use list_first_entry_or_null_acquire() when initially accessing the
front of the list (when an item is removed, the pointer to the new
front iterm is obtained under the same lock). |
| In the Linux kernel, the following vulnerability has been resolved:
vfio/pci: Check BAR resources before exporting a DMABUF
A DMABUF exports access to BAR resources and, although they are
requested at startup time, we need to ensure they really were reserved
before exporting. Otherwise, it's possible to access unreserved
resources through the export.
Add a check to the DMABUF-creation path. |
| In the Linux kernel, the following vulnerability has been resolved:
ASoC: codecs: fs210x: fix possible buffer overflow
In fs210x_effect_scene_info(), a string was copied like this:
strscpy(DST, SRC, strlen(SRC) + 1);
A buffer overflow would happen if strlen(SRC) >= sizeof(DST).
Actually, strscpy() must be used this way:
strscpy(DST, SRC, sizeof(DST));
strscpy(DST, SRC); // defaults to sizeof(DST) |
| In the Linux kernel, the following vulnerability has been resolved:
wifi: iwlwifi: mld: fix TSO segmentation explosion when AMSDU is disabled
When the TLC notification disables AMSDU for a TID, the MLD driver sets
max_tid_amsdu_len to the sentinel value 1. The TSO segmentation path in
iwl_mld_tx_tso_segment() checks for zero but not for this sentinel,
allowing it to reach the num_subframes calculation:
num_subframes = (max_tid_amsdu_len + pad) / (subf_len + pad)
= (1 + 2) / (1534 + 2) = 0
This zero propagates to iwl_tx_tso_segment() which sets:
gso_size = num_subframes * mss = 0
Calling skb_gso_segment() with gso_size=0 creates over 32000 tiny
segments from a single GSO skb. This floods the TX ring with ~1024
micro-frames (the rest are purged), creating a massive burst of TX
completion events that can lead to memory corruption and a subsequent
use-after-free in TCP's retransmit queue (refcount underflow in
tcp_shifted_skb, NULL deref in tcp_rack_detect_loss).
The MVM driver is immune because it checks mvmsta->amsdu_enabled before
reaching the num_subframes calculation. The MLD driver has no equivalent
bitmap check and relies solely on max_tid_amsdu_len, which does not
catch the sentinel value.
Fix this by detecting the sentinel value (max_tid_amsdu_len == 1) at the
existing check and falling back to non-AMSDU TSO segmentation. Also add
a WARN_ON_ONCE guard after the num_subframes division as defense-in-depth
to catch any future code paths that produce zero through a different
mechanism. |
| A flaw has been found in Shibby Tomato 1.28 RT-N5x MIPSR2 Build 124. Affected by this issue is the function setup_conntrack of the file /sbin/rc. Executing a manipulation of the argument ct_tcp_timeout can lead to out-of-bounds write. The attack may be performed from remote. This project is superseded by FreshTomato. |
| In the Linux kernel, the following vulnerability has been resolved:
wifi: mt76: mt7996: Clear wcid pointer in mt7996_mac_sta_deinit_link()
Clear WCID pointer removing the sta link in mt7996_mac_sta_deinit_link
routine. |
| In the Linux kernel, the following vulnerability has been resolved:
drm/amdgpu/vcn: set no_user_fence for VCN v2.5 enc/dec rings
VCN encoder and decoder rings do not support 64-bit user fence writes,
reject CS submissions with user fences.
(cherry picked from commit efc9dd5590894109bce9a0bfe1fa5592dd6b20b1) |
| In the Linux kernel, the following vulnerability has been resolved:
drm/amdgpu/vcn: set no_user_fence for VCN v3.0 enc/dec rings
VCN encoder and decoder rings do not support 64-bit user fence writes,
reject CS submissions with user fences.
(cherry picked from commit 663bed3c7b8b9a7624b0d95d300ddae034ad0614) |
| In the Linux kernel, the following vulnerability has been resolved:
drm/amdgpu/vcn: set no_user_fence for VCN v4.0 enc ring
VCN encoder and decoder rings do not support 64-bit user fence writes,
reject CS submissions with user fences.
(cherry picked from commit fd852c048b46f9825e904a4f3f4538fe9d8827d9) |
