| CVE |
Vendors |
Products |
Updated |
CVSS v3.1 |
| In Audio HAL, there is a possible out of bounds write due to a heap buffer overflow. This could lead to local denial of service with User execution privileges needed. User interaction is not needed for exploitation. Patch ID: ALPS10960023 (Note: For MT6880, MT6890, MT6980D, MT6988, MT6990) / AUTO00851189 (Note: For MT2735, MT3737); Issue ID: MSV-7586. |
| Improper input validation in MPEG4 codec in libsavsvc.so prior to SMR Aug-2026 Release 1 allows local attackers to write out-of-bounds memory. |
| An issue was identified in which CSRF tokens were generated using a predictable method, potentially reducing their effectiveness as a security control. This has been addressed by improving the randomness and entropy of token generation. |
| An improper access control vulnerability exists where an authenticated non-administrative application user could potentially view settings outside of their assigned scope. |
| Improper input validation in libsmsd.so prior to SMR Aug-2026 Release 1 allows local attackers to write out-of-bounds memory. |
| In display, there is a possible information disclosure due to a missing bounds check. This could lead to local information disclosure if a malicious actor has already obtained the System privilege. User interaction is not needed for exploitation. Patch ID: ALPS11004276; Issue ID: MSV-7757. |
| In display, there is a possible information disclosure due to an integer overflow. This could lead to local information disclosure if a malicious actor has already obtained the System privilege. User interaction is not needed for exploitation. Patch ID: ALPS11004274; Issue ID: MSV-7749. |
| IBM i 7.6, 7.5, 7.4, and 7.3 could allow a remote attacker to cause a denial of service due to an out-of-bounds read. |
| In the Linux kernel, the following vulnerability has been resolved:
netfilter: nft_payload: fix mask build for partial field offload
nft_payload_offload_mask() builds the offload match mask for a payload
expression that covers only part of a header field. For a partial IPv6
address match (field_len = 16, priv_len = 1) that shift is 1 << 120, which
is undefined on the 32-bit int operand. It also trims only one word, so
the remaining words stay 0xffffffff (and when priv_len is a multiple of 4
the trim is skipped entirely), leaving the mask covering more bytes than
the rule matches.
UBSAN: shift-out-of-bounds in net/netfilter/nft_payload.c:278:20
shift exponent 120 is too large for 32-bit type 'int'
...
The match is byte-granular and struct nft_data is zero-initialised, so the
correct mask is simply the first priv_len bytes set to 0xff. Set those
bytes directly and drop the word/shift trimming; this removes the undefined
shift and no longer over-masks the trailing bytes. |
| IBM i 7.6, 7.5, 7.4, and 7.3 could allow a remote attacker to cause a denial of service due to an integer error when processing DRDA large-object headers. |
| In the Linux kernel, the following vulnerability has been resolved:
keys: fix out-of-bounds read in keyring_get_key_chunk()
For description-level chunks keyring_get_key_chunk() advances the read
pointer by level * sizeof(long) past the inline prefix but only
bounds-checks the prefix, so a long enough key description is read past
its kmemdup(desc, desc_len + 1) allocation. Compute the full byte
offset and bounds-check the description against it before reading.
The walk only reaches a description-level chunk when two keys collide
through the hash, x, type and domain_tag chunks, so this is reached from
an unprivileged add_key(2) with a crafted pair of same-type keys whose
index hashes collide; KASAN reports a slab-out-of-bounds read. |
| IBM i 7.6, 7.5, 7.4, and 7.3 could allow a remote authenticated attacker to obtain sensitive information or cause a denial of service due to an out-of-bounds read. |
| In the Linux kernel, the following vulnerability has been resolved:
hwmon: (nct6775-core) Fix number of temperature registers for NCT6116
Unlike NCT6106, NCT6116 only has three temperature registers, and with
it only three temperature source and temperature source configuration
registers. The register addresses match those of NCT6106 and can be
re-used.
The code used a separate array to list the temperature source registers
for NCT6116, but used the size of the NCT6106 register array to set
the number of registers. The NCT6106 register array provides six addresses,
while the temperature source register array for NCT6116 only provides three
addresses. This causes a KASAN report.
BUG: KASAN: global-out-of-bounds in nct6775_probe+0x936/0x46f0 [nct6775]
Read of size 2 at addr ffffffffc19561a6 by task modprobe/954
...
Call Trace:
dump_stack+0x7d/0xa7
print_address_description.constprop.0+0x1c/0x220
? __kasan_kmalloc.constprop.0+0xc9/0xd0
? __kmalloc_node_track_caller+0x194/0x5b0
? nct6775_probe+0x936/0x46f0 [nct6775]
? nct6775_probe+0x936/0x46f0 [nct6775]
...
Fix the problem by hard-coding the number of temperature and temperature
configuration registers to three for NCT6116. Drop the unnecessary
NCT6116_REG_TEMP_SOURCE array and re-use NCT6106_REG_TEMP_SOURCE. |
| In the Linux kernel, the following vulnerability has been resolved:
hwmon: (nct6775-core) Prevent access to unsupported weight registers
Sashiko reports:
During initialization of the nct6116 chip, the driver sets data->pwm_num
to 5. However, it assigns several NCT6106 register arrays (such as
NCT6106_REG_WEIGHT_DUTY_STEP, NCT6106_REG_WEIGHT_TEMP_SEL, and
NCT6106_REG_WEIGHT_TEMP_*) to data->REG_PWM and data->REG_WEIGHT_TEMP.
These arrays only contain 3 elements.
In nct6775_update_pwm(), the driver iterates up to data->pwm_num. If
data->has_pwm has bits 3 or 4 set (which is structurally possible for
nct6116), the loop attempts to read elements at index 3 and 4 from these
3-element arrays. This results in a global out-of-bounds read, which can
be caught by KASAN.
Furthermore, the driver uses these garbage out-of-bounds values as
hardware register addresses for subsequent read and write operations. This
leads to invalid hardware register access, potentially causing hardware
misconfiguration or system crashes.
The underlying problem is that the chip does support up to five fan
control channels, but only the first three support weight control.
Fix the problem by extending the affected weight register arrays with
zeroed fields. The driver uses zeroed register addresses to determine
if a register is supported or not, and skips accesses for unsupported
registers. |
| In the Linux kernel, the following vulnerability has been resolved:
pinctrl: devicetree: don't free uninitialized dev_name on error path
dt_remember_or_free_map() duplicates dev_name for each map entry. If
kstrdup_const() fails, dt_free_map() frees dev_name in all num_maps
entries, including entries that have not been initialized.
Some pinctrl drivers, including pinctrl-imx, allocate the map with
kmalloc() and leave dev_name for the core to initialize. The untouched
entries therefore contain uninitialized data which is passed to
kfree_const().
Reproduced on qemu's mcimx6ul-evk (pinctrl-imx) with failslab injection
while binding the pinctrl-consuming device, under KASAN:
BUG: KASAN: double-free in dt_free_map+0x34/0xa4
Free of addr c425a900 by task init/1
kfree from dt_free_map+0x34/0xa4
dt_free_map from dt_remember_or_free_map+0x184/0x198
dt_remember_or_free_map from pinctrl_dt_to_map+0x33c/0x4c8
pinctrl_dt_to_map from create_pinctrl+0x9c/0x5c0
Initialize all dev_name fields to NULL before duplicating the device
name, making the full-map cleanup safe after a partial failure. |
| Integer overflow in the Graphics component. This vulnerability was fixed in Firefox 154, Firefox ESR 140.14, Firefox ESR 153.1, Thunderbird 154, Thunderbird 140.14, and Thunderbird 153.1. |
| In the Linux kernel, the following vulnerability has been resolved:
Bluetooth: HIDP: reject frames without a transaction header
hidp_recv_ctrl_frame() and hidp_recv_intr_frame() read skb->data[0]
before checking that the L2CAP SDU contains a transaction header. A
connected HIDP peer can send an empty basic-mode SDU and make both paths
use an uninitialized byte from skb tailroom.
KMSAN reports the use in hidp_session_run(), with the uninitialized value
originating in __alloc_skb() through vhci_write(). The control path
produces two reports and the interrupt path produces one.
The byte can also be controlled by a malformed lower-layer packet. If an
HCI ACL packet contains an L2CAP PDU with a declared zero-length payload
followed by an extra 0x15 byte, l2cap_recv_acldata() reduces skb->len to
the declared PDU length before dispatch. The current HIDP path nevertheless
consumes the extra byte as HIDP_TRANS_HID_CONTROL |
HIDP_CTRL_VIRTUAL_CABLE_UNPLUG and terminates the HIDP session. With this
change, the same packet is discarded and a subsequent feature report
request succeeds.
Pull the transaction header with skb_pull_data() and discard frames that
do not contain it. |
| Site isolation issue in the Networking: Cookies component. This vulnerability was fixed in Firefox 154, Firefox ESR 140.14, Firefox ESR 153.1, Thunderbird 154, Thunderbird 140.14, and Thunderbird 153.1. |
| In the Linux kernel, the following vulnerability has been resolved:
Bluetooth: HIDP: validate numbered report payloads
When hidp_get_raw_report() waits for a numbered report,
hidp_process_data() compares the expected report number with skb->data[0].
A connected HIDP peer can reply with only a DATA transaction header,
leaving the skb empty after the header is removed.
KMSAN reports an uninitialized-value use in hidp_session_run(), with the
value originating in __alloc_skb() through vhci_write(). The transaction
header checks remove the empty-frame reports, but this report remains until
the payload check is added.
The comparison can also consume a peer-controlled byte beyond the declared
L2CAP PDU. A DATA | FEATURE response followed by an extra 0x01 byte made
the current code accept that byte as report ID 1 and complete
HIDIOCGFEATURE with a zero-byte result. With this change the malformed
response is rejected with -EIO, while a subsequent valid response still
succeeds.
Require a payload byte before comparing a numbered report ID. Unnumbered
reports continue to accept an empty payload. |
| In the Linux kernel, the following vulnerability has been resolved:
can: peak_usb: add bounds check for USB channel index
The channel control index ctrl_idx is derived from rx->len which comes
directly from a device USB payload. The mask 0x0f allows values 0-15, but
the array size of usb_if->dev[] is only 2. Values 2-15 cause heap
out-of-bounds read, eventually causing kernel panic in the IRQ context.
Add bounds checking for ctrl_idx before the array access in both
pcan_usb_pro_handle_canmsg() and pcan_usb_pro_handle_error(). |
