| CVE |
Vendors |
Products |
Updated |
CVSS v3.1 |
| In the Linux kernel, the following vulnerability has been resolved:
erofs: reliably distinguish block based and fscache mode
When erofs_kill_sb() is called in block dev based mode, s_bdev may not
have been initialised yet, and if CONFIG_EROFS_FS_ONDEMAND is enabled,
it will be mistaken for fscache mode, and then attempt to free an anon_dev
that has never been allocated, triggering the following warning:
============================================
ida_free called for id=0 which is not allocated.
WARNING: CPU: 14 PID: 926 at lib/idr.c:525 ida_free+0x134/0x140
Modules linked in:
CPU: 14 PID: 926 Comm: mount Not tainted 6.9.0-rc3-dirty #630
RIP: 0010:ida_free+0x134/0x140
Call Trace:
<TASK>
erofs_kill_sb+0x81/0x90
deactivate_locked_super+0x35/0x80
get_tree_bdev+0x136/0x1e0
vfs_get_tree+0x2c/0xf0
do_new_mount+0x190/0x2f0
[...]
============================================
Now when erofs_kill_sb() is called, erofs_sb_info must have been
initialised, so use sbi->fsid to distinguish between the two modes. |
| Flock Safety LPR (License Plate Reader) devices with firmware through 2.2 have a hardcoded password for a system. |
| In the Linux kernel, the following vulnerability has been resolved:
net: ks8851: Queue RX packets in IRQ handler instead of disabling BHs
Currently the driver uses local_bh_disable()/local_bh_enable() in its
IRQ handler to avoid triggering net_rx_action() softirq on exit from
netif_rx(). The net_rx_action() could trigger this driver .start_xmit
callback, which is protected by the same lock as the IRQ handler, so
calling the .start_xmit from netif_rx() from the IRQ handler critical
section protected by the lock could lead to an attempt to claim the
already claimed lock, and a hang.
The local_bh_disable()/local_bh_enable() approach works only in case
the IRQ handler is protected by a spinlock, but does not work if the
IRQ handler is protected by mutex, i.e. this works for KS8851 with
Parallel bus interface, but not for KS8851 with SPI bus interface.
Remove the BH manipulation and instead of calling netif_rx() inside
the IRQ handler code protected by the lock, queue all the received
SKBs in the IRQ handler into a queue first, and once the IRQ handler
exits the critical section protected by the lock, dequeue all the
queued SKBs and push them all into netif_rx(). At this point, it is
safe to trigger the net_rx_action() softirq, since the netif_rx()
call is outside of the lock that protects the IRQ handler. |
| In the Linux kernel, the following vulnerability has been resolved:
drm/xe/xe_migrate: Cast to output precision before multiplying operands
Addressing potential overflow in result of multiplication of two lower
precision (u32) operands before widening it to higher precision
(u64).
-v2
Fix commit message and description. (Rodrigo)
(cherry picked from commit 34820967ae7b45411f8f4f737c2d63b0c608e0d7) |
| Flock Safety LPR (License Plate Reader) devices with firmware through 2.2 have cleartext storage of code. |
| In the Linux kernel, the following vulnerability has been resolved:
amd/amdkfd: sync all devices to wait all processes being evicted
If there are more than one device doing reset in parallel, the first
device will call kfd_suspend_all_processes() to evict all processes
on all devices, this call takes time to finish. other device will
start reset and recover without waiting. if the process has not been
evicted before doing recover, it will be restored, then caused page
fault. |
| Improper Access Control vulnerability in Wikimedia Foundation Mediawiki - Scribunto Extension allows : Accessing Functionality Not Properly Constrained by Authorization.This issue affects Mediawiki - Scribunto Extension: from 1.39.X before 1.39.12, from 1.42.X before 1.42.7, from 1.43.X before 1.43.2. |
| Deserialization of untrusted data in python in pyfory versions 0.12.0 through 0.12.2, or the legacy pyfury versions from 0.1.0 through 0.10.3: allows arbitrary code execution. An application is vulnerable if it reads pyfory serialized data from untrusted sources. An attacker can craft a data stream that selects pickle-fallback serializer during deserialization, leading to the execution of `pickle.loads`, which is vulnerable to remote code execution.
Users are recommended to upgrade to pyfory version 0.12.3 or later, which has removed pickle fallback serializer and thus fixes this issue. |
| Default credentials in Each Italy Wireless Mini Router WIRELESS-N 300M v28K.MiniRouter.20190211 allows attackers to gain access to the debug shell exposed via Telnet on Port 23 and execute hardware-level flash and register manipulation commands. |
| Notepad++ v8.8.3 has a DLL hijacking vulnerability, which can replace the original DLL file to execute malicious code. NOTE: this is disputed by multiple parties because the behavior only occurs when a user installs the product into a directory tree that allows write access by arbitrary unprivileged users. |
| Improper handling of symbolic links in the TeamViewer Full Client and Host for Windows — in versions prior to 15.70 of TeamViewer Remote and Tensor — allows an attacker with local, unprivileged access to a device lacking adequate malware protection to escalate privileges by spoofing the update file path. This may result in unauthorized access to sensitive information. |
| This vulnerability affects Firefox < 143.0.3. |
| DX Unified Infrastructure Management (Nimsoft/UIM) and below contains an improper ACL handling vulnerability in the robot (controller) component. A remote attacker can execute commands, read from, or write to the target system. |
| This CVE ID has been rejected or withdrawn by its CVE Numbering Authority. |
| In the Linux kernel, the following vulnerability has been resolved:
drm/amdkfd: range check cp bad op exception interrupts
Due to a CP interrupt bug, bad packet garbage exception codes are raised.
Do a range check so that the debugger and runtime do not receive garbage
codes.
Update the user api to guard exception code type checking as well. |
| In the Linux kernel, the following vulnerability has been resolved:
scsi: lpfc: Move NPIV's transport unregistration to after resource clean up
There are cases after NPIV deletion where the fabric switch still believes
the NPIV is logged into the fabric. This occurs when a vport is
unregistered before the Remove All DA_ID CT and LOGO ELS are sent to the
fabric.
Currently fc_remove_host(), which calls dev_loss_tmo for all D_IDs including
the fabric D_ID, removes the last ndlp reference and frees the ndlp rport
object. This sometimes causes the race condition where the final DA_ID and
LOGO are skipped from being sent to the fabric switch.
Fix by moving the fc_remove_host() and scsi_remove_host() calls after DA_ID
and LOGO are sent. |
| In the Linux kernel, the following vulnerability has been resolved:
thermal/debugfs: Free all thermal zone debug memory on zone removal
Because thermal_debug_tz_remove() does not free all memory allocated for
thermal zone diagnostics, some of that memory becomes unreachable after
freeing the thermal zone's struct thermal_debugfs object.
Address this by making thermal_debug_tz_remove() free all of the memory
in question.
Cc :6.8+ <stable@vger.kernel.org> # 6.8+ |
| An authenticated command injection vulnerability exists in Pi-hole versions up to 3.3. When adding a domain to the allowlist via the web interface, the domain parameter is not properly sanitized, allowing an attacker to append OS commands to the domain string. These commands are executed on the underlying operating system with the privileges of the Pi-hole service user.
This behavior was present in the legacy AdminLTE interface and has since been patched in later versions. |
| In the Linux kernel, the following vulnerability has been resolved:
NFSD: Fix nfsd4_encode_fattr4() crasher
Ensure that args.acl is initialized early. It is used in an
unconditional call to kfree() on the way out of
nfsd4_encode_fattr4(). |
| In the Linux kernel, the following vulnerability has been resolved:
ipvlan: Dont Use skb->sk in ipvlan_process_v{4,6}_outbound
Raw packet from PF_PACKET socket ontop of an IPv6-backed ipvlan device will
hit WARN_ON_ONCE() in sk_mc_loop() through sch_direct_xmit() path.
WARNING: CPU: 2 PID: 0 at net/core/sock.c:775 sk_mc_loop+0x2d/0x70
Modules linked in: sch_netem ipvlan rfkill cirrus drm_shmem_helper sg drm_kms_helper
CPU: 2 PID: 0 Comm: swapper/2 Kdump: loaded Not tainted 6.9.0+ #279
Hardware name: QEMU Standard PC (i440FX + PIIX, 1996), BIOS 1.15.0-1 04/01/2014
RIP: 0010:sk_mc_loop+0x2d/0x70
Code: fa 0f 1f 44 00 00 65 0f b7 15 f7 96 a3 4f 31 c0 66 85 d2 75 26 48 85 ff 74 1c
RSP: 0018:ffffa9584015cd78 EFLAGS: 00010212
RAX: 0000000000000011 RBX: ffff91e585793e00 RCX: 0000000002c6a001
RDX: 0000000000000000 RSI: 0000000000000040 RDI: ffff91e589c0f000
RBP: ffff91e5855bd100 R08: 0000000000000000 R09: 3d00545216f43d00
R10: ffff91e584fdcc50 R11: 00000060dd8616f4 R12: ffff91e58132d000
R13: ffff91e584fdcc68 R14: ffff91e5869ce800 R15: ffff91e589c0f000
FS: 0000000000000000(0000) GS:ffff91e898100000(0000) knlGS:0000000000000000
CS: 0010 DS: 0000 ES: 0000 CR0: 0000000080050033
CR2: 00007f788f7c44c0 CR3: 0000000008e1a000 CR4: 00000000000006f0
DR0: 0000000000000000 DR1: 0000000000000000 DR2: 0000000000000000
DR3: 0000000000000000 DR6: 00000000fffe0ff0 DR7: 0000000000000400
Call Trace:
<IRQ>
? __warn (kernel/panic.c:693)
? sk_mc_loop (net/core/sock.c:760)
? report_bug (lib/bug.c:201 lib/bug.c:219)
? handle_bug (arch/x86/kernel/traps.c:239)
? exc_invalid_op (arch/x86/kernel/traps.c:260 (discriminator 1))
? asm_exc_invalid_op (./arch/x86/include/asm/idtentry.h:621)
? sk_mc_loop (net/core/sock.c:760)
ip6_finish_output2 (net/ipv6/ip6_output.c:83 (discriminator 1))
? nf_hook_slow (net/netfilter/core.c:626)
ip6_finish_output (net/ipv6/ip6_output.c:222)
? __pfx_ip6_finish_output (net/ipv6/ip6_output.c:215)
ipvlan_xmit_mode_l3 (drivers/net/ipvlan/ipvlan_core.c:602) ipvlan
ipvlan_start_xmit (drivers/net/ipvlan/ipvlan_main.c:226) ipvlan
dev_hard_start_xmit (net/core/dev.c:3594)
sch_direct_xmit (net/sched/sch_generic.c:343)
__qdisc_run (net/sched/sch_generic.c:416)
net_tx_action (net/core/dev.c:5286)
handle_softirqs (kernel/softirq.c:555)
__irq_exit_rcu (kernel/softirq.c:589)
sysvec_apic_timer_interrupt (arch/x86/kernel/apic/apic.c:1043)
The warning triggers as this:
packet_sendmsg
packet_snd //skb->sk is packet sk
__dev_queue_xmit
__dev_xmit_skb //q->enqueue is not NULL
__qdisc_run
sch_direct_xmit
dev_hard_start_xmit
ipvlan_start_xmit
ipvlan_xmit_mode_l3 //l3 mode
ipvlan_process_outbound //vepa flag
ipvlan_process_v6_outbound
ip6_local_out
__ip6_finish_output
ip6_finish_output2 //multicast packet
sk_mc_loop //sk->sk_family is AF_PACKET
Call ip{6}_local_out() with NULL sk in ipvlan as other tunnels to fix this. |
