| CVE |
Vendors |
Products |
Updated |
CVSS v3.1 |
| In the Linux kernel, the following vulnerability has been resolved:
block: don't call rq_qos_ops->done_bio if the bio isn't tracked
rq_qos framework is only applied on request based driver, so:
1) rq_qos_done_bio() needn't to be called for bio based driver
2) rq_qos_done_bio() needn't to be called for bio which isn't tracked,
such as bios ended from error handling code.
Especially in bio_endio():
1) request queue is referred via bio->bi_bdev->bd_disk->queue, which
may be gone since request queue refcount may not be held in above two
cases
2) q->rq_qos may be freed in blk_cleanup_queue() when calling into
__rq_qos_done_bio()
Fix the potential kernel panic by not calling rq_qos_ops->done_bio if
the bio isn't tracked. This way is safe because both ioc_rqos_done_bio()
and blkcg_iolatency_done_bio() are nop if the bio isn't tracked. |
| A vulnerability in the Bidirectional Forwarding Detection (BFD) offload implementation of Cisco Catalyst 4500 Series Switches and Cisco Catalyst 4500-X Series Switches could allow an unauthenticated, remote attacker to cause a crash of the iosd process, causing a denial of service (DoS) condition. The vulnerability is due to insufficient error handling when the BFD header in a BFD packet is incomplete. An attacker could exploit this vulnerability by sending a crafted BFD message to or across an affected switch. A successful exploit could allow the attacker to trigger a reload of the system. This vulnerability affects Catalyst 4500 Supervisor Engine 6-E (K5), Catalyst 4500 Supervisor Engine 6L-E (K10), Catalyst 4500 Supervisor Engine 7-E (K10), Catalyst 4500 Supervisor Engine 7L-E (K10), Catalyst 4500E Supervisor Engine 8-E (K10), Catalyst 4500E Supervisor Engine 8L-E (K10), Catalyst 4500E Supervisor Engine 9-E (K10), Catalyst 4500-X Series Switches (K10), Catalyst 4900M Switch (K5), Catalyst 4948E Ethernet Switch (K5). Cisco Bug IDs: CSCvc40729. |
| In the Linux kernel, the following vulnerability has been resolved:
spi: microchip-core: ensure TX and RX FIFOs are empty at start of a transfer
While transmitting with rx_len == 0, the RX FIFO is not going to be
emptied in the interrupt handler. A subsequent transfer could then
read crap from the previous transfer out of the RX FIFO into the
start RX buffer. The core provides a register that will empty the RX and
TX FIFOs, so do that before each transfer. |
| In the Linux kernel, the following vulnerability has been resolved:
drm/amdgpu: Fix signedness bug in sdma_v4_0_process_trap_irq()
The "instance" variable needs to be signed for the error handling to work. |
| A potential denial-of-service issue in the Proxygen handling of invalid HTTP2 priority settings (specifically a circular dependency). This affects Proxygen prior to v2018.12.31.00. |
| In the Linux kernel, the following vulnerability has been resolved:
nilfs2: handle inconsistent state in nilfs_btnode_create_block()
Syzbot reported that a buffer state inconsistency was detected in
nilfs_btnode_create_block(), triggering a kernel bug.
It is not appropriate to treat this inconsistency as a bug; it can occur
if the argument block address (the buffer index of the newly created
block) is a virtual block number and has been reallocated due to
corruption of the bitmap used to manage its allocation state.
So, modify nilfs_btnode_create_block() and its callers to treat it as a
possible filesystem error, rather than triggering a kernel bug. |
| In the Linux kernel, the following vulnerability has been resolved:
s390/mm: Fix VM_FAULT_HWPOISON handling in do_exception()
There is no support for HWPOISON, MEMORY_FAILURE, or ARCH_HAS_COPY_MC on
s390. Therefore we do not expect to see VM_FAULT_HWPOISON in
do_exception().
However, since commit af19487f00f3 ("mm: make PTE_MARKER_SWAPIN_ERROR more
general"), it is possible to see VM_FAULT_HWPOISON in combination with
PTE_MARKER_POISONED, even on architectures that do not support HWPOISON
otherwise. In this case, we will end up on the BUG() in do_exception().
Fix this by treating VM_FAULT_HWPOISON the same as VM_FAULT_SIGBUS, similar
to x86 when MEMORY_FAILURE is not configured. Also print unexpected fault
flags, for easier debugging.
Note that VM_FAULT_HWPOISON_LARGE is not expected, because s390 cannot
support swap entries on other levels than PTE level. |
| The cp2112_gpio_direction_input function in drivers/hid/hid-cp2112.c in the Linux kernel 4.9.x before 4.9.9 does not have the expected EIO error status for a zero-length report, which allows local users to have an unspecified impact via unknown vectors. |
| An issue was discovered in Xen through 4.9.x allowing guest OS users to cause a denial of service (host OS crash) or gain host OS privileges by leveraging incorrect error handling for reference counting in shadow mode. |
| A bug in the error handling of the send file code for the NIO HTTP connector in Apache Tomcat 9.0.0.M1 to 9.0.0.M13, 8.5.0 to 8.5.8, 8.0.0.RC1 to 8.0.39, 7.0.0 to 7.0.73 and 6.0.16 to 6.0.48 resulted in the current Processor object being added to the Processor cache multiple times. This in turn meant that the same Processor could be used for concurrent requests. Sharing a Processor can result in information leakage between requests including, not not limited to, session ID and the response body. The bug was first noticed in 8.5.x onwards where it appears the refactoring of the Connector code for 8.5.x onwards made it more likely that the bug was observed. Initially it was thought that the 8.5.x refactoring introduced the bug but further investigation has shown that the bug is present in all currently supported Tomcat versions. |
| ImageMagick allows remote attackers to have unspecified impact via vectors related to error handling in sun files. |
| The ReadGROUP4Image function in coders/tiff.c in ImageMagick does not check the return value of the fwrite function, which allows remote attackers to cause a denial of service (application crash) via a crafted file. |
| The ReadPSDLayers function in coders/psd.c in ImageMagick 6.8.9.9 allows remote attackers to have unspecified impact via unknown vectors, related to "throwing of exceptions." |
| The vc4_get_bcl function in drivers/gpu/drm/vc4/vc4_gem.c in the VideoCore DRM driver in the Linux kernel before 4.9.7 does not set an errno value upon certain overflow detections, which allows local users to cause a denial of service (incorrect pointer dereference and OOPS) via inconsistent size values in a VC4_SUBMIT_CL ioctl call. |
| The hdpvr_probe function in drivers/media/usb/hdpvr/hdpvr-core.c in the Linux kernel through 4.13.11 allows local users to cause a denial of service (improper error handling and system crash) or possibly have unspecified other impact via a crafted USB device. |
| Incorrect error handling in the set_mempolicy and mbind compat syscalls in mm/mempolicy.c in the Linux kernel through 4.10.9 allows local users to obtain sensitive information from uninitialized stack data by triggering failure of a certain bitmap operation. |
| On Samsung Galaxy S4 through S7 devices, absence of permissions on the BroadcastReceiver responsible for handling the com.[Samsung].android.intent.action.SET_WIFI intent leads to unsolicited configuration messages being handled by wifi-service.jar within the Android Framework, a subset of SVE-2016-6542. |
| On Samsung Galaxy S4 through S7 devices, an integer overflow condition exists within libomacp.so when parsing OMACP messages (within WAP Push SMS messages) leading to a heap corruption that can result in Denial of Service and potentially remote code execution, a subset of SVE-2016-6542. |
| On Samsung Galaxy S4 through S7 devices, the "omacp" app ignores security information embedded in the OMACP messages resulting in remote unsolicited WAP Push SMS messages being accepted, parsed, and handled by the device, leading to unauthorized configuration changes, a subset of SVE-2016-6542. |
| A vulnerability in the Multipurpose Internet Mail Extensions (MIME) scanner of Cisco AsyncOS Software for Cisco Email Security Appliances (ESA) and Web Security Appliances (WSA) could allow an unauthenticated, remote attacker to bypass configured user filters on the device. Affected Products: all releases prior to the first fixed release of Cisco AsyncOS Software for Cisco ESA and Cisco WSA, both virtual and hardware appliances, if the software is configured with message or content filters to scan incoming email attachments. More Information: CSCuw03606, CSCux59734. Known Affected Releases: 8.0.0-000 8.5.6-106 9.0.0-000 9.1.0-032 9.6.0-042 9.5.0-444 WSA10.0.0-000. Known Fixed Releases: 9.1.1-038 9.7.1-066. |
